Spalding M8809511 User Manual

1
07/06 ID# M8809511
In-Ground Basketball System
Owners Manual
Customer Service Center
• N53 W24700 South Corporate Circle • Sussex, WI 53089 • U.S.A.
READ AND UNDERSTAND OPERATOR'S MANUAL BEFORE USING THIS UNIT.
FAILURE TO FOLLOW OPERATING INSTRUCTIONS COULD RESULT IN INJURY OR DAMAGE TO PROPERTY.
WARNING!
Toll-Free Customer Service Number for U.S: 1-800-558-5234 Canada Only: 1-800-284-8339
Internet Address: http://www.hydra-rib.com
REQUIRED TOOLS AND MATERIALS:
• 3 Capable Adults
• Carpenter’s Level
• 15’ Tape Measure
•Sh
ovel & Post Hole
Digger
• Phillips Screwdriver
• (1) Utility Knife
• (2) Stepladders 8 ft. (2.4 m)
• Safety Goggles
• Container to Mix
• Optional: Large & Small Adjustable Wrenches
• (2 each) Wrenches and/or Socket Wrenches and Sockets (Deep-Well Sockets are Recommended).
1/2"3/8" 9/16" 3/4"
15/16"
1/2"3/8" 9/16" 3/4"
15/16"
Write Model Number
From Box Here:
© COPYRIGHT 2006 by SPALDING
2
ID# M8809511 07/06
IMPORTANT! WRITE MODEL NUMBER FROM BOX ONTO PAGE 1 OF THIS OWNERS MANUAL
Owner must ensure that all players know and follow these rules
for safe operation of the system.
WARNING
DO NOT HANG on the rim or any part of the system including backboard, support braces or net.
During play, especially when performing dunk type activities, keep player's face away from the backboard, rim and net. Serious injury could occur if teeth/face come in contact with backboard, rim or net.
Do not slide, climb, shake or play on base and/or pole.
When adjusting height or moving system, keep hands and fingers away from moving parts.
Do not allow children to move or adjust system.
During play, do not wear jewelry (rings, watches, necklaces, etc.). Objects may entangle in net.
Keep organic material away from pole base. Grass, litter, etc. could cause corrosion and/or deterioration.
Check pole system for signs of corrosion (rust, pitting, chipping) and repaint with exterior enamel paint. If rust has penetrated through the steel anywhere, replace pole immediately.
Check system before each use for proper ballast, loose hardware, excessive wear and signs corrosion and repair before use.
Check system before each use for instability.
Never play on damaged equipment.
Keep pole top covered with cap at all times.
See instruction manual for proper installation and maintenance.
R
ea
d a
nd understand war
ning
s listed
below befor
e using this product
.
F
a
ilure t
o f
ollow these war
ning
s m
ay
resul
t in seriou
s injury a
nd/o
r
property damag
e
.
ID#: 588000 05/05
In the U.S.: 1-888-713-5488
In the U.S.: 1-800-558-5234 In Canada: 1-800-284-8339
In the U.S.: 1-800-334-9111
In the U.S.: 1-800-558-5234 In Canada: 1-800-284-8339
31
SAFETY INSTRUCTIONS
Most injuries are caused by misuse and/or not following instructions.
Use caution when using this system.
• If using a ladder during assembly, use extreme caution.
• Three (3) people are recommended for this operation.
• Seat the pole sections properly. Failure to do so could allow the pole sections to separate during play.
• Before digging, contact utility company to locate underground power cables, gas, and water lines. Ensure there are no overhead power lines within 20 ft. (7 m) radius of pole location.
• Climate, corrosion, excessive use, or misuse could result in system failure.
• If technical assistance is required, contact Customer Service.
• Minimum operational height is 6' 6" (1.98 m) to the bottom of backboard.
• This equipment is intended for home recreational use only and NOT excessive competitive play.
• Read and understand the warning label affixed to pole.
• The life of your basketball pole depends on many conditions. The climate, placement of the pole, the location of the pole, exposure to corrosives such as pesticides, herbicides or salts are all important.
• Adult supervision is recommended when adjusting height.
• Serious injury could occur if teeth/face come in contact with backboard, net, or rim.
FAILURE TO FOLLOW THESE SAFETY INSTRUCTIONS MAY RESULT IN
SERIOUS INJURY, PROPERTY DAMAGE AND WILL VOID WARRANTY.
Owner must ensure that all players know and
follow these rules for safe operation of the system.
To ensure safety, do not attempt to assemble this system without following the instructions carefully. Proper and complete assembly, use and supervision is essential for proper operation and to reduce the risk of accident or injury. A high probability of serious injury exists if this system is not installed, maintained, and operated properly. Check entire box and inside all packing material for parts and/or additional instructional material. Before beginning assembly, read the instructions and identify parts using the hardware identifier and parts list in this document.
For more information on assembly, placement, proper use and maintenance, visit The American Basketball Council website at http://www.smarthoops.com.
WARRANTY CARD:
Please remember to complete your product registration form either on­line at: www.huffysports.com/customer_support/product_registration or mail-in the enclosed postcard.
3
07/06 ID# M8809511
24" (61 cm)
36" (91.4 cm)
Ensure ground is level with playing surface, then dig pole hole.
GROUND
SURFACE
PLAYING
SURFACE
1.
Install threaded ends of J-bolts (1) through holes in mounting plate (3) and secure as shown.
2.
3
2
2
2
1
3.
1
Install nut (2) to J-bolt (1) as shown. Repeat procedure for other three J-bolts (1).
2-1/2”
(6.35 cm)
CONTACT UTILITIES BEFORE DIGGING.
WARNING!
IMPORTANT!
Make sure nuts are 2-1/2” (6.35cm) from top of J-Bolts.
Make sure J-bolts (1) are in the illustrated position.
NOTE:
Nuts on the top of plate are used for leveling the pole after system is fully assembled.
NOTE:
4
ID# M8809511 07/06
Fill hole with concrete. Tamp down concrete to release air pockets and build drainage hill.
Insert J-bolts (1) from mounting plate (3) into cement as shown. Move assembly around to release any air pockets in cement, then rest mounting plate on cement drainage hill. Apply some pressure to level mounting plate on top of drainage hill. Level mounting plate and square with playing surface. Clean off any excess cement on mounting plate at this time.
4.
5.
PLAYING SURFACE
3
1
IMPORTANT!
Front of mounting plate (3) must be parallel with playing surface.
WARNING!
DO NOT PROCEED UNTIL CONCRETE HAS CURED! A MINIMUM OF 72 HOURS. ALLOW ADDITIONAL TIME FOR COLD, WET OR HUMID WEA THER.
IMPORTANT!
Check leveling of mounting plate several times with carpenter’s level while concrete is curing.
5
07/06 ID# M8809511
G
Upright pole (5). Assemble lower pole flange onto protruding J-bolts (1) as shown. The flange will then rest on the nuts (2).
Secure pole (5) flange to mounting plate (3) as shown. Tighten completely.
6.
7.
5
3
2
6
6
6
2
6
2
6
1
1
5
THREE PEOPLE REQUIRED FOR THIS PROCEDURE. FAILURE TO FOLLOW THIS WARNING COULD RESULT IN SERIOUS INJURY AND/OR PROPERTY DAMAGE.
WARNING!
Holes in pole must be parallel with playing surface.
IMPORTANT!
PLAYING SURFACE
Position crank jack mounting as shown.
NOTE:
6
2
6
6
PLAYIN
SURFACE
Loading...
+ 11 hidden pages