Spalding 21112201 User Manual

Page 1
1
11/05 ID# 21112201
Toll-Free Customer Service Number for U.S: 1-800-558-5234,
For Canada: 1-800-284-8339,
For Europe: 00 800 555 85234 (Sweden: 009 555 85234),
For Australia: 1-800-632 7921
Internet Address: http://www.huffysports.com
REQUIRED TOOLS
OPTIONAL TOOLS
Ground Sleeve Owners Manual
for a 4” (10.2 cm) square pole
Customer Service Center
• N53 W24700 South Corporate Circle • Sussex, WI 53089 • U.S.A.
A DIVISION OF RUSSELL CORPORATION
READ AND UNDERSTAND OPERATOR'S MANUAL BEFORE USING THIS UNIT.
FAILURE TO FOLLOW OPERATING INSTRUCTIONS COULD RESULT IN INJURY OR DAMAGE TO PROPERTY.
WARNING!
• 2 People
• Carpenter’s Level
• 15’ Tape Measure
• Shovel & Post Hole Digger
• Spade
• Wood Board (scrap)
• Tape
• Sawhorse or Support Table
• Wedge
• Safety Glasses
• Heavy-Duty Tape
• Container to Mix
Write Model Number
From Box Here:
• Large and Small Adjustable Wrenches
• (2 each) Wrenches and/or Socket Wrenches and Sockets (Deep-Well Sockets are Recommended).
• Extension is Recommended
AND/OR
9/16"
9/16"
Page 2
2
ID# 21112201 11/05
PARTS LIST (SEE PARTS IDENTIFIER)
Owner must ensure that all players know and follow these rules
for safe operation of the system.
WARNING
DO NOT HANG on the rim or any part of the system including backboard, support braces or net.
During play, especially when performing dunk type activities, keep player's face away from the backboard, rim and net. Serious injury could occur if teeth/face come in contact with backboard, rim or net.
Do not slide, climb, shake or play on base and/or pole.
When adjusting height or moving system, keep hands and fingers away from moving parts.
Do not allow children to move or adjust system.
During play, do not wear jewelry (rings, watches, necklaces, etc.). Objects may entangle in net.
Keep organic material away from pole base. Grass, litter, etc. could cause corrosion and/or deterioration.
Check pole system for signs of corrosion (rust, pitting, chipping) and repaint with exterior enamel paint. If rust has penetrated through the steel anywhere, replace pole immediately.
Check system before each use for proper ballast, loose hardware, excessive wear and signs corrosion and repair before use.
Check system before each use for instability.
Never play on damaged equipment.
Keep pole top covered with cap at all times.
See instruction manual for proper installation and maintenance.
R
ea
d a
nd understand war
ning
s listed
below befor
e using this product
.
F
a
ilure t
o f
ollow these war
ning
s m
ay
resul
t in seriou
s injury a
nd/o
r
property damag
e
.
ID#: 588000 05/05
In the U.S.: 1-888-713-5488
In the U.S.: 1-800-558-5234 In Canada: 1-800-284-8339
In the U.S.: 1-800-334-9111
In the U.S.: 1-800-558-5234
In Canada: 1-800-284-8339
Item Qty.Part No. Description
1 1 206500 Ground Sleeve, Square
2 2 201124 Locknut, Hex Head, 3/8 - 16 3 4 203232 Washer, Flat, 3/8 x 3/4 O.D. 4 2 206512 Clamp, V-shaped 5 2 206252 Bolt, Hex Head, 3/8-16 x 1 Long 6 1 206502 Clamp Cover
7 1 206119 Warning Label
PARTS LIST (SEE PARTS IDENTIFIER)
#2 (2)
#5 (2)
#3 (4)
#1 (1)
#7 (1)
#4 (2)
#6 (1)
Page 3
11/05 ID# 21112201
3
SAFETY INSTRUCTIONS
Most injuries are caused by misuse and/or not following instructions.
Use caution when using this system.
• If using a ladder during assembly, use extreme caution.
• Two (2) people are recommended for this operation.
• Seat the pole sections properly. Failure to do so could allow the pole sections to separate during play.
• Before digging, contact utility company to locate underground power cables, gas, and water lines. Ensure there are no overhead power lines within 20 ft. (7 m) radius of pole location.
• Climate, corrosion, excessive use, or misuse could result in system failure.
• If technical assistance is required, contact Huffy Sports.
• Minimum operational height is 6' 6" (1.98 m) to the bottom of backboard.
• This equipment is intended for home recreational use only and NOT excessive competitive play.
• Read and understand the warning labels.
• The life of your basketball pole depends on many conditions. The climate, placement of the pole, the location of the pole, exposure to corrosives such as pesticides, herbicides, or salts are all important.
• Adult supervision is recommended when adjusting height.
• Serious injury could occur if teeth/face come in contact with backboard, net, or rim.
FAILURE TO FOLLOW THESE SAFETY INSTRUCTIONS MAY RESULT IN
SERIOUS INJURY, PROPERTY DAMAGE AND WILL VOID WARRANTY.
Owner must ensure that all players know and follow these rules for safe
operation of the system.
To ensure safety, do not attempt to assemble this system without following the instructions carefully. Proper and complete assembly, use and supervision is essential for proper operation and to reduce the risk of accident or injury. A high probability of serious injury exists if this system is not installed, maintained, and operated properly. Check entire box and inside all packing material for parts and/or additional instructional material. Before beginning assembly
, read the instructions and identify parts using the
hardware identifier and parts list in this document.
Page 4
4
ID# 21112201 11/05
1.
2.
Ensure ground is level with playing surface, then dig pole hole.
CONTACT UTILITIES BEFORE DIGGING.
WARNING!
BOTTOM
TOP
POLE(S) NOT INCLUDED.
FOLLOW
MANUFACTURERS
INSTRUCTIONS ACCORDINGLY.
POLE STYLE WILL VARY
NOTE:
GROUND
SURFACE
PLAYING
SURFACE
IMPORTANT!
Maximum distance from edge
of hole to edge of playing
surface: 6” (15.2 cm).
24" (61 cm)
24" (61 cm)
6" (15.2 cm)
Page 5
11/05 ID# 21112201
5
4.
Fill hole approximately 1/3 full with mixed concrete.
3.
Insert bottom pole section into ground sleeve (1).
Assemble clamps (4) around bottom pole and ground sleeve (1) as shown.
1
2
5
4
1
4
3
IMPORTANT!
Clamp assembly MUST
be positioned
as shown below.
4
5.
Page 6
6
ID# 21112201 11/05
Insert ground sleeve assembly and center in hole (FIG. A).
Note
: Leave 1" below flange exposed for drainage hill.
SIDE VIEW
6.
IMPORTANT!: CONTINUE ON TO NEXT STEP.
DO NOT
WAIT FOR CONCRETE TO CURE.
PLAYING SURFACE
G
FIG. A
IMPORTANT!
NOTE POSITION OF
GROUND SLEEVE
IMPORTANT!
FRONT OF POLE MUST
BE PARALLEL WITH PLAYING SURFACE.
PLAYING SURFACE
PLAYIN
SURFACE
1" (2.54 cm)
Page 7
11/05 ID# 21112201
7
Fill hole completely with concrete.
7.
8.
Tamp down concrete to release air pockets and build drainage hill. Level pole section in all directions several times while concrete is curing.
SIDE VIEW
DRAINAGE HILL
IMPORTANT!: CONTINUE ON TO NEXT STEP.
DO NOT
WAIT FOR CONCRETE TO CURE.
IMPORTANT!:
WAIT A MINIMUM OF 24 HOURS BEFORE GOING ON TO
NEXT STEP. CONCRETE MUST
CURE.
PLAYING SURFACE
1" (2.54 cm)
1" (2.54 cm)
1" (2.54 cm)
FILL TO
HERE
Page 8
8
ID# 21112201 11/05
After concrete has cured, remove clamp assembly and lift bottom pole section from ground sleeve as shown.
9.
Page 9
11/05 ID# 21112201
9
;
Bounce pole sections together until they no longer move toward taped reference mark.
Insert pole cap onto bottom pole end. Mix concrete and fill pole.
NOTE: Concrete must cure before going on to the next step.
POLE(S) NOT INCLUDED.
FOLLOW MANUFACTURERS
INSTRUCTIONS
ACCORDINGLY.
NOTE:
IMPORTANT!
POLES SHOULD
HAVE A
4-1/2” (11.4 CM)
MINIMUM OVERLAP.
IMPORTANT!
FAILURE TO FILL YOUR POLE
COMPLETELY WITH CONCRETE
AS DESCRIBED IN THESE
INSTRUCTIONS WILL VOID
ALL WARRANTIES
WRITTEN OR IMPLIED.
10.
11.
FOLLOW MANUFACTURERS
INSTRUCTIONS ON FILLING
POLE ACCORDINGLY.
NOTE:
C
O
N
C
R
E
T
E
Page 10
10
ID# 21112201 11/05
Lower clamp cover (6) over clamps and snap into proper position.
Secure clamps (4) around pole section as shown. Refer to Step 4. Tighten completely.
6
6
Remove pole cap from bottom pole section and insert clamp cover (6) onto bottom section. Bend back exposed top flange sections of secured ground sleeve (1) as shown. Then insert pole into ground sleeve (1).
WARNING!
TWO PEOPLE REQUIRED FOR THIS PROCEDURE. FAILURE TO FOLLOW THIS WARNING COULD RESULT IN SERIOUS INJURY AND/OR PROPERTY DAMAGE.
WARNING!
REMOVE BACKBOARD AND RIM
BEFORE REMOVING POLE FROM
GROUND SLEEVE. REQUIRES TWO
PEOPLE TO REMOVE POLE.
12.
13.
14.
6
1
Loading...