Southbend SX-34GC User Manual
Job Item#
www.yatesgd.com www.yatesgraphicdesign.com
Model Compartments Capacity
SX-34GC 2 1-7 Pans
SX-55GC 2 1-10 Pans
Standard Features
- Automatic generator blow down
- Delime mode power setting
- Deliming port for the generators which is located on
the right side panel.
- Split water connections for simple hook up for a
treated water system.
- Mounted on stainless steel cabinet base
SX-34GC cabinet is 23” high
SX-55GC cabinet is 18” high
- Two gas red, stainless steel generators operating at
0 psi (0 kPa) and rated at 45,000 BTU each.
Gas Two ComparTmenT
C
onveCTion sTeamer on
C
abineT base
Model SX-34GC
CONSTRUCTION SPECIFICATIONS
Southbend Convection Steamer with individual steam generator
for each cavity. AGA/CGA Certied and NSF Approved. Model
SX-34GC shall have 3 pan capacity on top and 4 pan capacity
on bottom. Model SX-55GC shall have 5 pan capacity on top
and bottom. The steamer shall be constructed of a satin nish
stainless steel #304. The cooking chamber is a one piece all
welded, #316 stainless steel with coved corners. The heavy
duty door shall have an inner liner of stainless steel with a full
perimeter gasket seal, an outer liner of one piece all welded
stainless steel, and a positive lock and seal mechanism with
spring release. Each compartment shall be provided with
removable stainless steel pan supports. A stainless steel drip
trough shall be integrally connected to drain to collect conden-
sate when the doors are opened.
The control housing shall be constructed of stainless steel with
a full access removable panel. Each compartment shall have
individual controls which include an illuminated three way power
switch (ON/OFF/Delime), a pilot ready light, a pilot cooking
light, an ignition light, a 60-minute electric timer which sounds
an audible signal at the end of the cooking cycle, solid state
generator controls and electronic ignition for each generator.
Steam ow to the cooking chamber shall be cut off when the
door is opened and reactivated when the door is closed.
WATER QUALITY STATEMENT
Water quality is the major factor affecting the performance of your appliance. If you are unsure of water quality, consult a local
water treatment specialist and have the water analyzed. Your water supply must be within these general guidelines:
Total dissolved solids - less than 60 PPM
Total alkalinity - less than 20 PPM
Silica - less than 13 PPM
Chlorine -less than 1.5 PPM
pH Factor -7.0-8.5
Water which fails to meet these standards should be treated by installation of water conditioner.
FAILURE OR MALFUNCTION OF THIS APPLIANCE DUE TO POOR WATER QUALITY IS NOT COVERED UNDER WARRANTY
Form SXGC Rev 1 (March/2015)
Models:
SX-34GC SX-55GC
UTILITY CONNECTIONS
Two gas red, stainless steel steam generators operating at 0psi (0kPa) and rated at 45,000 BTU each / 26.4kW.
Required minimum inlet pressure:
-Natural Gas 6” W.C.
-Propane Gas 11” W.C.
Controls: 120 VAC, 1 Phase, 50/60 Hz
Unless otherwise specied, Field Wire Electrical Connection to be 120 Volts, 60 Hertz single phase with grounding wire. Furnished with 6 foot
cord and 3 prong plug. Maximum amps. 4.0
Drain: 1” IPS piped to open oor drain. No Solid Connection. 24” length before open air gap opening (no bends or elbows)
Gas: 3/4” IPS supply line required
Generator Water: 3/8” O.D. tubing at 25-50 PSI (170-345 kPa)
Condensing Water: 3/8” O.D. tubing at 25-50 PSI (170-345 kPa)
OPTIONS/ACCESSORIES
220 VAC, 1 Phase, 50/60 Hz Controls
120 Minute Timer Correctional Package
Form SXGC Rev 1 (March/2015)
INTENDED FOR COMMERCIAL USE ONLY.
NOT FOR HOUSEHOLD USE
1100 Old Honeycutt Road, Fuquay-Varina, NC 27526
(919) 762-1000 www.southbendnc.com
.
Loading...