Southbend SX-3 User Manual
A Middleby Company
ELECTRIC COUNTER
CONVECTION STEAMER
3, 4, AND 5 PAN
Compartment Pan Capacity
Pan Depth
Model
SX-3
SX-4
SX-5
1” 2 1/2” 4” 6”
6
8
10
3
4
5
2
2
3
1
1
2
Standard Features
- Stainless steel construction
- Coved interior corners
- Automatic generator blow down valve
- Delime mode power setting
- Deliming port for the generators which is located at the rear of the unit
for easy access to allow cleaning of the generator tank
- Split water connections for simple hook up for a treated water
system.
- Removable stainless steel pans supports and drip trough connected to
drain to collect condensate when door is opened
- Electric, stainless steel generator operating at 0 psi (0 kPa)
with field replaceable element rated at:
SX-3 - 7.5 kW
SX-4 - 10 kW
SX-5 - 15 kW
Job Item#
SX-3
SX-5
CONSTRUCTION SPECIFICATIONS
Southbend counter convection steamer with electric steam
generator. C-CSA-US Certified and NSF Approved. The
steamer shall be constructed of #4 finish stainless steel type
#304. The cooking chamber is a one piece all welded, #316
stainless steel with coved corners. The heavy duty door shall
have an inner liner of stainless steel with a full perimeter
gasket seal, an outer liner of one piece all welded stainless
steel, and a positive lock and seal mechanism with spring
release. Each compartment shall be provided with
removable stainless steel pan supports. A stainless steel
drip trough shall be integrally connected to drain to collect
condensate when the doors are opened.
The control housing shall be constructed of stainless steel
with a full access removable panel. The compartment shall
include an illuminated three way power switch (ON/OFF/
Delime), a pilot ready light, a pilot cooking light, and a 60minute electric timer which sounds an audible signal at the
end of the cooking cycle. Steam flow to the cooking chamber
shall be cut off when the door is opened and reactivated when
the door is closed.
WATER QUALITY STATEMENT
Water quality is the major factor affecting the performance of your appliance. If you are unsure of water quality, consult a local
water treatment specialist and have the water analyzed. Your water supply must be within these general guidelines:
Total dissolved solids - less than 60 PPM
Total alkalinity - less than 20 PPM
Silica - less than 13 PPM
Chlorine -less than 1.5 PPM
pH Factor -7.0-8.5
Water which fails to meet these standards should be treated by installation of water conditioner.
FAILURE OR MALFUNCTION OF THIS APPLIANCE DUE TO POOR WATER QUALITY IS NOT COVERED UNDER WARRANTY
Form SX345
A Middleby Company
05/04 Printed in USA
Models:
SX-3 SX-4 SX-5
UTILITY CONNECTIONS
Electrically heated, stainless steel steam generator operating at 0 psi
(0kPa) and rated at:
SX-3 - 7.5 kW
SX-4 - 10 kW
Controls:
- 208 VAC, 3 Phase, 50/60 Hz
- 240 VAC, 3 Phase, 50/60 Hz
* Unit shall be field convertible to single phase
Electrical: 1 1/8” hole for electrical connection. Rating to be as specified
on data plate.
Drain: 1 1/8” O.D. tubing to open floor drain. No Solid Connection. 24”
length before open air gap opening (no bends or elbows)
Generator Water: 3/8” O.D. tubing at 25-50 PSI (170-345 kPa)
Condensing Water: 3/8” O.D. tubing at 25-50 PSI (170-345 kPa)
SX-5 - 15 kW
OPTIONS/ACCESSORIES
- 220 VAC, 1 Phase, 50/60 Hz Controls
- 220 VAC, 3 Phase, 50/60 Hz Controls
- 240 VAC, 1 Phase, 50/60 Hz Controls
- 240 VAC, 3 Phase, 50/60 Hz Controls
- 220/380 VAC, 3 Phase, 50/60 Hz 4 wire Controls
- 240/415 VAC, 3 Phase, 50/60 Hz 4 wire Controls
- 480 VAC, 3 Phase, 50/60 Hz Controls
- 10.0kW element (SX-3 Only)
- 120 Minute Timer
- Continuous steam feature
- 4” adjustable legs
- Stacking kit
LEDOMWk
3-XS
4-XS
5-XS
esahPelgniSesahPeerhT
V802V042V802V042V084
5.7631312819
018424824221
018424824221
512736246381
- Stainless steel stand (RL-34)
- Stainless steel stand (RL-28)
- Stainless steel stand (RL-18)
- Correctional Package
Form SX345
INTENDED FOR COMMERCIAL USE ONLY.
NOT FOR HOUSEHOLD USE.
1100 Old Honeycutt Rd., Fuquay-Varina, NC 27526
www.southbendnc.com
Loading...