Southbend P36 Series General Manual
Standard Features
• 36"-wide sectional range with a standard-oven base,
convection-oven base, cabinet base, or as a modular unit
(for mounting on countertop, refrigerated or freezer base)
• 9-1/4" deep front rail
• Stainless steel front, sides, rear and exterior bottom
• Fully insulated lining and burner box
• 1-1/4" front gas manifold and 1" rear gas connection
• 5" high stainless steel ue riser
• Free battery-design assistance
• Warranty: two years on specied operational parts and one
year on labor from date of purchase
12 " Open Top Features
• Two 33,000 BTU NAT (30,000 BTU LP) patented clog-free
burners
• Removable cast iron grates
• Removable drip tray
12" Hot Top Features
• Two 16,000 BTU NAT (14,000 BTU LP) burners with one
high/low control knob
• Electronic pilot ignition - Piezo
• Removable steel plates with 700°F surface temperature on
high setting
12" Charbroiler Features
• Two 16,000 BTU NAT (14,000 BTU LP) burners with one
high/low control knob
• Removable cast iron grates with adjustable front-to-back
slope that ip over for either 1/8" or 1/4" grid width
• 600°F even surface temperature on high setting
• Cast iron radiants or “lava rocks” (eld convertible)
• Removable drip tray
12" Griddle Features
• Two 16,000 BTU NAT (14,000 BTU LP) burners with one
control knob
• Manual "G", or Thermostatic "T" controls available
(thermostatic control available on 24" only)
• “Insta-On” thermostatic control of griddle surface
temperature in the range 180°F to 400°F
• Electronic pilot ignition - Piezo
• 1" thick griddle plate with side and rear splashers
• Removable stainless steel grease drawer
36" Sectional Range
Combination Tops
Job Item#
Additional congurations available.
Contact factory for details.
*All congurations
available with the
following oven base
options:
N - none
C - cabinet
D -standard oven
A - convection oven
Model P36A-BBH
with optional 24"
ue riser
Standard Features of Oven-Base Models
Exterior Finish: Front, sides, rear and exterior bottom con-
structed of #3 polished 430 and 304 stainless steel.
Front Rail: 9-1/4" deep front rail.
Flue Riser: 5" high stainless steel ue riser
Battery: Unit can be in any position in a battery. If the unit is
at the end of the battery, the end side will be solid (rather than
have a coverplate over the end of the front manifold).
Legs: 6" stainless steel adjustable legs standard.
Form P36ComboTop Rev 3 (September/2009)
www.yatesgd.com www.yatesgraphicdesign.com
Model 36D: 45,000 BTU NAT (42,000 BTU LP) oven with
standing pilot and thermostat range of 175°F to 550°F (79°C
to 288°C). Porcelain enamel interior, measuring 14” high x 26”
wide x 26.5” deep. Two racks with ve-position side rails.
Model 36A: 45,000 BTU NAT (42,000 BTU LP) convection
oven with standing pilot and thermostat range of 175°F to
550°F (79°C to 288°C). Porcelain enamel interior, measuring
14” high x 26” wide x 24” deep. Three racks with ve-position
side rails. Two-speed, 1/2 hp blower motor.
Model 36C: Stainless steel cabinet base with two removable
doors that open from the center.
Printed in USA
Models:
Connection
P36-BHH P36-BBH P36-BGG/BTT P36-BBG P36-BCC P36-BBC P36-GGC/TTC
37-1/2"
(953)
(914)
36"
TOP VIEW
36" (914)
36" Flue Riser
24" Flue Riser
5" Flue Riser
24"
(610)
9-1/4"
(235)
41"
(1041)
60"
(1524)
43"
(1092)
72"
(1829)
33-3/4"
(859)
20-1/2"
(521)
8-1/2" (216)
SIDE VIEW of MODULAR MODEL
15-3/4"
(400)
Optional Shelf
43-1/2" (1105)
40" (1016)
37-1/2" (953)
34" (864)
5" (127)
Front Gas
Manifold
11-3/4"
(298)
Optional extra-deep
flue riser (cooking
area is same as for
models with standard
Motor for
Convection
Oven Models
flue riser)
Rear Gas
Connection
moDel WiDth height Depth Volume Weight
P36N
P36C
P36D
P36A
1-Add 90lbs(40.8kg) to P36N-BGG/BTT, P36N-GGC/TTC models
2-Add 50lbs(22.6kg) to P36C-BGG/BTT, P36C-GGC/TTC models
3-Add 90lbs(40.8kg) to P36D-BGG/BTT, P36D-GGC/TTC models
4-Add 90lbs(40.8kg) to P36D-BGG/BTT, P36D-GGC/TTC models
6" (152)
20"
(508)
Shipping Crate DimenSionS & Weight
45.5"
(1156)
45.5"
(1156)
45.5"
(1156)
45.5"
(1156)
2-1/2" (64)
23"
(584)
45"
(1143)
45"
(1143)
45"
(1143)
Electrical
for Oven
Models
18"
(457)
55"
33.3 cu ft
(1397)
(0.94 cu m)
55"
65.2 cu ft
(1397)
(1.85 cu m)
55"
65.2 cu ft
(1397)
(1.85 cu m)
55"
65.2 cu ft
(1397)
(1.85 cu m)
Dimensions shown in
inches and (millimeters)
300 lbs
(136.1 kg)
440 lbs
(199.6 kg)
570 lbs
(258.5 kg)
710 lbs
(322.1 kg)
1
2
3
4
UTILITY INFORMATION
moDel DeCription
P36-BHH (2) Open Top Burners/24" Hot Top 66K(60K) 64K(56K) - - 130K(120K) 45,000 (42,000)
P36-BBH (4) Open Top Burners/12" Hot Top 132K(120K) 32K(28K) - - 164K(148K)
P36-BGG/BTT (2) Open top Burners/24" Griddle 66K(60K) - 64K(56K) - 130K(120K)
P36-BBG/BBT (4) Open Top Burners/12" Griddle 132K(120K) - 32K(28K) - 164K(148K)
P36-BCC (2) Open Top Burners/24" Charbroiler 66K(60K) - - 64K(56K) 130K(120K)
P36-BBC (4) Open top Burners/12" Charbroiler 132K(120K) - - 32K(28K) 164K(148K)
P36-GGC/TTC 24" Griddle/12" Charbroiler - - 64K(56K) 32K(28K) 96K(84K)
open top Btu
nat (lp)
Note 1: Specify left or right conguration. For griddle top specify "G" for manual, or "T" for thermostatic controls
GAS: Each unit has a 1-1/4" front manifold that couples to the adjacent sectional unit(s), and a 1"
rear gas connection with a male NPT connector. Minimum gas supply pressure is 7" W.C. for natural
gas and 11" W.C. for propane. All sectional units require a regulated gas supply (a pressure regulator
must be ordered separately). If using a exible-hose gas connection, the inside diameter of the hose
must not be smaller than the connector on the unit and must comply with ANSI Z21.69, providing an
adequate means of restraint to prevent undue strain on the gas connection.
hot top Btu
nat (lp)
griDDle Btu
nat (lp)
CharBroiler Btu
nat (lp)
total Btu
nat (lp)
aDD to total if uSing oVen BaSe
StanDarD or ConVeCtion nat(lp)
BaSe moDel
N - None - -
C - Cabinet - -
D - Standard Oven 0* 0*
A - Convection Oven 3.8* 1.6*
*Standing Oven Pilot Models
ELECTRICITY: All oven models with optional electronic
ignition require 50Hz or 60Hz single-phase power. 120V
models have a 7-foot power cord with ground plug (3.8A
for "A" models). 208/240V models have a terminal block for
connection to a single-phase 208/240V source (1.6A for "A"
models).
eleCtriCity (ampS)
120V 208/240V
MISCELLANEOUS
• If casters are used with a exible-hose gas connection, a restraining device should be used to prevent undue strain on the hose.
• Minimum clearance from noncombustible construction is zero (except there must be 2" clearance behind the blower motor of convection-oven models). Minimum
clearance from combustible construction is 10" (254 mm) on sides and 6" (152 mm) on rear.
• Installation under a vented hood is recommended.
• Check local codes for re and sanitary regulations.
NOTICE: Southbend has a policy of continuous product research and improvement. We reserve the right to change specications and product design without
notice. Such revisions do not entitle the buyer to corresponding changes, improvements, additions or replacements for previously purchased equipment.
External pressure regulator
Front rail options:
Cutouts in front rail for sauce pans
7-1/4" deep front rail (to match old style
sectional)
Square belly bar mounted on 7-1/4"
deep front rail
Casters (front two casters lock)
Cable restraint kit (to restrict movement
when on casters)
Form P36-ComboTop Rev 3 (September/2009)
OPTIONS and ACCESSORIES
24" or 36" high ue riser
Shelves on ue riser (one on 24" ue riser,
one or two on 36" ue riser)
Tray or tubular shelves (shelves not
available on units with charbroiler)
Open-frame base with casters for battery
Extra-deep rear-extending ue riser
Stainless steel oven interior
Salamander or cheesemelter mounted on
36" high ue riser
INTENDED FOR COMMERCIAL USE ONLY.
1100 Old Honeycutt Road, Fuquay-Varina, NC 27526
Removable shelf inside cabinet
Grooved griddle surface (Griddle Only)
Chrome griddle surface (Griddle Only)
Plated sh grids (Charbroiler only)
Electronic oven pilot ignition
120V, NEMA 4 water resistant controls
Additional top congurations available.
Contact factory for details
NOT FOR HOUSEHOLD USE.
(919) 762-1000 www.southbendnc.com
Loading...