
USERS GUIDE – NEURO EDITOR – NEURO MOBILE - SUPPORT
www.sourceaudio.net
Quick Start Reference Card
POWER: Power your Collider with the included power supply. If using a pedalboard power supply, be
sure to use a regulated 9 Volt DC output that can source at least 300mA.
CONTROLS:
TIME - Adjusts delay time for the delays and pre-delay for the reverbs.
MIX - Adjusts the ratio between the wet and dry signals. 50/50 wet/dry is at 3 o’clock.
FEEDBACK - Adjusts regeneration amount for the delays and decay time for the reverbs.
TONE and CONTROL 1 & 2 - Varies depending on the selected engine (see table below).
TAP Toggle - Selects a Tap Tempo beat division for the delay engines.
KNOBS Toggle - Selects whether the knobs control delay or reverb parameters. LOCK position
prevents accidentally bumped knobs from changing the settings.
DELAY/TAP Switch - Engage/bypass delay engines & Tap Tempo. While engaged, quick presses on the
footswitch will be used for tap tempo, a slightly longer press will bypass the delay.
REVERB Switch - Engage/bypass reverb engines. Press + hold to freeze/hold reverb tail.
TRAILS MODE - Press + hold CONTROL INPUT then press DELAY/TAP to toggle on/off.
SELECT/SAVE Button - Press to scroll through presets. Press + hold to save a preset.
PRESET SCROLLING - When bypassed, press + hold DELAY or REVERB footswitches to scroll down or
up through presets, respectively.
DISCOVER THE KNOB POSITION OF AN ACTIVE PRESET- The activity LED will blink twice to indicate
when the knob position matches the saved preset position. This feature can be modified in the
Hardware Options to other styles of preset knob behavior.