Soundmax SM-CCR3073F User Manual

SM-CCR3073F

USB/SD media player USB/SD-медиаплеер Instruction manual Руководство по эксплуатации

Dear customer!

Thank you for purchasing our product. For safety, it is strongly recommended to read this manual carefully before connecting, opera ti ng and/or adjusting the produc t a nd keep the manual for referenc e in the future.

Table of contents

TABLE OF CONTENTS ...................................................................................................................................................... 2

IMPORTANT SAFEGUARDS ............................................................................................................................................ 3

ACCESSORIES .................................................................................................................................................................... 4

INSTALLATION/CONNECTION ...................................................................................................................................... 5

CONTROL ELEMENTS ....................................................................................................................................................... 8

GENERAL OPERATIONS .................................................................................................................................................. 9

RADIO OPERATIONS ........................................................................................................................................................ 11

USB/SD OPERATIONS ..................................................................................................................................................... 12

TROUBLESHOOTING GUIDE .......................................................................................................................................... 13

SPECIFICATION ................................................................................................................................................................. 14

Important safeguards

• Read carefully through this manual to familiarize you rself with this high-quality sound sy stem.

• The beginning of operation is the moment of the unit installation. Before use the device in winter it is

recommended to heat up the pas s enger compartment during 20 seconds or to the operation temperature.

• Use the unit with the temperature that goes beyond the operation temperature greatly decreases the operation resource of the sc r een and other components of device a nd can result an outage.

• Disconnect the vehicle's negative battery term inal while mountin g a nd connecting the unit.

• When replacing the fuse, be sure to use one with an identical amperage rating. Using a fuse with a higher

amperage rating may ca use serious damage to the unit.

• Make sure that pins or other foreign objects do not get inside the unit; they may cause malfunctions, or create safety hazards such as electrical shock.

• Do not use the un it in places where it can b e exposed to water, moistu r e a nd dust.

• Do not open covers and do not repair yourself. Consult th e d ea ler or an experienced tech nician for help.

• Make sure you dis c onnect the power supply and aerial if you will not be using the sys te m for a long period

or during a thund er storm.

• Make sure you disconnect the power supply if the system appears to be working incorrectly, is making an unusual sound, has a strange smell, has smoke emitting from it or liquids have got inside it. Have a qualified technician check the system.

• The unit is designed for negative terminal of the battery, which is connected to the vehicle metal. Please confirm it before in stallation.

• Do not allow the speaker wires to be shorted together when the unit is switched on. Otherwise it may overload or burn out the power amplifie r .

Accessories

1. Receiver 1 pc

2. Mounting parts:

Hexagon nut 1 pc Mounting sleeve 1 pc Release keys 2 pcs Metal bar 1 pc Plain washer 1 pc Spring washer 1 pc Self-tapping screw 1 pc Screw 4 pc

3. Connector 1 pc

Instruction manual 1 pc

Installation/Connection

General notes

• Choose the mounting location where the unit will not interfere with the normal driving function of the driver.

• Before finally installing the unit, connect the wirin g an d m a ke sure that the unit wor ks properly.

• Consult with your nearest dealer if installation requires the drilling of holes or other modifications of the

vehicle.

• Install the unit where it does not get in the driver's way and cannot injure the passenger if there is a sudden stop, like an emergenc y stop.

• Avoid installing the unit where it would be subject to high temperature, such as from direct sunlight, or from hot air, fr om the heater, or whe r e it would be subject to dus t, dirt or excessive vibration.

DIN FRONT-MOUNT

1. Car dashboard

2. Sleeve

3. Bolt

4. Nut

5. Spring washer

6. Screw

7. Metal strap

8. Flat washer

1. Install the sleeve into the dashboard; ensure it is installed with the correct side and there are no obstacles (wires , dashboard elements , etc) for the unit installation.

2. After installing the sleeve into the dashboard, bend tabs fitting to the size of the dashboard to fix the sleeve in place.

3. Use the metal strap to fix the rear side of the unit. Determine a place for fixing and install the strap as shown in the picture. You can bend the strap to the needed angle with your hands.

4. Make the necessary wire connections. Ensure the connections are correct.

5. Install the unit into the sleeve until the side locks are fixed.

Dismantling the unit

1. Make sure the ignition is turned off, then disconnect the cable from the

vehicle battery’s negative (-) terminal.

2. Remove the metal s trap attached the back of the unit (if a ttached).

3. Insert both of the supplied keys into the slots at the middle left and right

sides of the unit, then pull the unit out of the dashboard.

Connection diagra m

Note: Auto antenna wire is intended for power supply of the antenna and for remote control of an

additional amplifier.

Control elements

Front panel

button

2. MODE button

5. BND button

6. CLK button

7. VOLUME knob/

BASS/TREBLE/BALANCE /FADER/LOUD/EQ button

8. 1 PLAY/PAUSE button

9. 2/RPT button

10. 3/RDM button

11. LCD

12. 4 button

13. 5/-10 button

14. 6/+10 button

15. SD card slot

16. RESET button (h ole )

17. AUX input

18. USB port

button button

General operations

Turning the unit on/off

Press the button to turn th e unit on. Press the button again to turn the unit off.

Reset the unit

When first usin g the device or after repla cing the car batter y, you must rese t the unit. Press the R ESET

button (hole) with a pointed object (such as a ballpoint pen) to set the unit to its initial state.

When some errors occ ur, you can also press the RESET button to r eturn to factory settings, but note that

it will erase clock setting and some mem or ized functions.

Mode selection

Press the MODE button repeatedly to select between Radio, AUX, MP3 modes. Operation modes ar e

indicated on the d is p la y. MP3 mode is not av ailable unless a m em or y card or a USB devic e is connected.

Clock

Press the CLK button to display time. P ress and hold this button to set the clock , rotate the volume knob for

adjustment.

Volume control

Adjust the volum e by rotating the VOLUM E knob.

Audio parameter setting

Press the VOL knob repeatedly to select a parameter: BA S (ba s s ) => TRE (treble) => BAL (balance) => FAD (fader). Press and hold the button to select LOUD (loudness), press and hold again to select EQ (equalizer). Rotate the k nob to adjust each mode.

• Bass/Treble: from -7 to +7;

• Balance: -10 (left) to +10 (right);

• Fader: from -10 (rear) to +10 (front).

• Loudness: see “Loudness” paragraph below

• EQ: select POP/CLASS/ROCK or OFF equalizer mode. When equalizer is in any mode except OFF, bass and treble are n ot adjustable.

Loudness

Activating this feature will enhance bass and treble frequencies when listening to music at low v olum es.

AUX input

AUX-in jack is inten d ed for connecting an external audio equipment to am plify the sound. If connection is made correc tly , th e au d i o si gna l f rom the ext ernal source will be transm itt e d through the acoust ic s of the head unit. This enables to adjust the v olume and quality of the sounding. F or examp le, you can connect an MP3 player to listen to tracks using the car acous tic sys tem.

+ 23 hidden pages