Sony XS-F6932SL User Manual
Specifications
Speaker Coaxial 3-way:
Woofer 16 × 24 cm cone type
Midrange 6.6 cm cone type
Tweeter 2.2 cm dome type
Maximum input power 220 watts
Rated input power 50 watts
Impedance 4 ohms
Sensitivity 93 dB/W/m
Frequency response 25 – 28,000 Hz
Mass Approx. 1,300 g per speaker
Design and specifications are subject to change without notice.
3-240-094-11 (1)
Precautions
•Do not continuously use the speaker system beyond the maximum power handling capacity.
•Keep recorded tapes, watches, and personal credit cards using magnetic coding away from the
speaker system to protect them from damage caused by the magnets in the speakers.
If you cannot find an appropriate mounting location, consult your car dealer or your nearest Sony
dealer before mounting.
3-way Speaker
Instructions
Dimensions
182
XS-F6932SL
Sony Corporation 2002
250
30
Printed in Thailand
146
118
166
5.5 × 9.5
166
Unit: mm
215
ø 105
19
80
239
Mounting
Parts list
Before mounting
A depth of at least 80 mm is required for flush mounting. Measure the depth of the area where you are
to mount the speaker, and ensure that the speaker is not obstructing any other components of the car.
Keep the following in mind when choosing a mounting location.
•Make sure that nothing is obstructing around the mounting location of the rear tray where you are to
mount the speaker.
•A hole for mounting may already be cut out of the inner panel of the rear tray. In this case, you need
to modify the board only.
•If you are to mount this speaker system in the rear tray, make sure that the speaker terminals, frame
or magnet do not touch any inner parts of the car, such as the torsion bar springs (when you open or
close the trunk lid), etc.
Also make sure that the speaker grille does not touch any inner fittings, such as seat belts, head rests,
center brake lights, inner covers of the rear wipers, curtains or air purifiers etc.
Mounting from the car interior (Top mounting)
Mark the four bolt holes and make them 3.3 mm* in diameter.
1
* When using 6: ø 5 mm
1
4
4 m
(× 2)
23
(× 2) (× 2)
56
ø 4 × 30
(× 8)
(× 8)
2
216 mm
Rear tray
1
147 mm
c
3
ø 3.3 mm
5
2
4
Black-striped cord
4*
Power amplifier etc.
Press and insert the edges of the grille net.
6
7.5 mm
c
* White cord — Left speaker
Grey cord — Right speaker
4
How to remove the grille net.
3
3
2
2
Loading...