Sony VPCSC1AFM-S, VPCSC1AFM Replacement Instructions
VPCSC Series Optical Disk Drive
NOTE: If your unit is configured with an
Extended Battery Pack, it must be
removed before beginning this
procedure.
Extended Battery Pack Removal
1) Slide the “LOCK” battery tab up to
the unlock position.
2) Slide the “RELEASE” battery tab to
the right and hold.
3) Rotate the battery up to remove.
Prepare the Computer
CAUTION: Make sure the
Computer is turned off, the lid is
closed, and the AC Adapter is
disconnected. Failure to do so can
result in damage to the Computer.
Place the Computer upside down on a
protected surface with the front edge
facing you.
Battery Pack Removal
Step 1. Using the enclosed magnetic
screwdriver, remove the two (2)
screws securing the Battery Door.
Put the screws aside to re-secure
the Door later in the procedure.
These easy instructions will guide you through the Hard Drive replacement process.
Before you begin, place your notebook computer on a clean or covered surface to avoid
damage to the computer's case.*
Follow the ESD (Electrostatic Discharge) damage prevention instructions:
o Hold parts by the edges, away from exposed circuitry when possible.
o Do not walk around excessively as this promotes static build-up.
Before you begin, remove any jewelry you may be wearing to prevent scratches to the surface
of your notebook computer.*
The appearance of the electronic components shown in the illustrations may differ from the
components shipped. This slight difference does not affect the accuracy of these instructions.
* Sony is not responsible for damage caused by incorrect handling of the notebook computer.
IMPORTANT!
PLEASE READ BEFORE YOU START
Replacement Instructions
P/N 989202621 Rev. B 1/4
FOR TECHNICAL SUPPORT IN THE US CALL TOLL FREE 1-866-651-7669 FROM 9:00 AM TO 11:00 PM EST
VPCSC Series Optical Disk Drive
Step 3: The Battery Pack is located as
shown.
Step 2. Slide the Battery Door towards
the Bottom edge of the unit to remove.
Step 4. Locate the Battery Lock. Slide
down to the “UNLOCK” position and
hold. Grasp the Battery from the Left
side and lift up to remove.
ODD Removal
Step 1. Using the enclosed magnetic
screwdriver, remove the two (2) screws
securing the ODD Assembly.
Put the screws aside to re-secure the
ODD later in the procedure.
Step 2. Insert your fingers in the space
between the ODD and the unit. Gently
slide the ODD away from the unit.
Step 3. Carefully remove the ODD
Assembly from the unit.
ODD Disassembly
Step 1. Identify the four (4) screws which
secure the ODD Brackets to the ODD.
Step 2. Remove the screws & brackets.
Put the ODD Brackets and screws
aside for transfer to the new ODD.
Step 3. Arrange the Brackets &
screws as shown above and then set
the old ODD aside.
Replacement Instructions
FOR TECHNICAL SUPPORT IN THE US CALL TOLL FREE 1-866-651-7669 FROM 9:00 AM TO 11:00 PM EST
P/N 989202621 Rev. B 2/4
Loading...