VGN-NSxx Series Optical Disk Drive
These easy instructions are intended to guide you through the replacement process. If you need
The appearance of the electronic components shown in the illustrations may be different from
Replacement Instructions
additional help, please call 1-866-651-7669 for technical support from 9:00 am to 11:00 pm EST.
ü Before you begin, place your notebook computer on a clean or covered surface to avoid
* Sony is not responsible for any loss of data associated with your computer or any damage caused by
incorrect handling of the computer under these procedures. The terms of your Sony limited warranty
continue to apply.
damage to the computer's case.*
ü Follow the ESD (Electrostatic Discharge) damage prevention instructions:
o Hold parts by the edges, away from exposed circuitry when possible.
o Do not walk around excessively as this promotes static build-up.
ü Remove jewelry before you begin work to avoid scratching the surface of your notebook
computer.*
ü
the components shipped. This slight difference does not affect the accuracy of these
instructions.
1.
Push left tab in the unlock position
Step 1. Prepare the Computer.
CAUTION: Make sure the computer
is turned off, the lid is closed, and the AC
Adapter is disconnected. Failure to do so
can result in damage to the computer.
Place the computer upside down on a
protected surface with the front edge
facing you.
FOR TECHNICAL SUPPORT IN THE US CALL TOLL FREE 1-866-651-7669 FROM 9:00 AM TO 11:00 PM EST
P/N 994660100 Rev. A 1/2
Step 2. Remove the Battery Pack.
1. Slide the left battery tab to the
2. With your right thumb, slide the
3. Remove the battery by lifting the
Lift to remove
unlock position.
right battery tab in the release
direction and hold.
side where the arrow is pointing.
(ODD Removal) Steps 3-6
Step 3. Locate the ODD Bay.
Rotate the computer with the Optical
Disk Drive (ODD) facing you as shown
in the picture.
VGN-NSxx Series Optical Disk Drive
Replacement Instructions
Step 4. Using the magnetic screwdriver,
remove the three (3) screws securing the
ODD.
(ODD Reinstallation) Steps 7-9
Step 7. Hold the new ODD assembly by the
edges and align it with the opening.
IMPORTANT! Install the new ODD in the
correct position as shown in picture.
Step 5. To initiate the removal of the ODD,
pull slightly the ODD door as shown in the
picture.
Step 8. Make sure the new ODD is seated
flush on the edge of the computer.
Step 6. With even force, slide out the
ODD as shown. Some force may be
required to unlock the ODD from the
connector.
Step 9. Secure the new ODD by re-
installing the three (3) screws previously
removed.
Step 10. Reinstall the battery pack. Return
the old ODD to Sony following the included
shipping instructions.
FOR TECHNICAL SUPPORT IN THE US CALL TOLL FREE 1-866-651-7669 FROM 9:00 AM TO 11:00 PM EST
P/N 994660100 Rev. A 2/2