Sony Trinitron Wega KV-SZ292, Trinitron Wega KV-SZ252 Operating Instructions Manual

3-208-942-13 (1)

Tr initron Color TV

Operating Instructions

• Before operating the unit, please read this manual thoroughly and retain
it for future reference.

KV-SZ292

GB

KV-SZ252

© 2007 Sony Corporation

N60
N50

A Specifications

KV-SZ292N60
KV-SZ292N50

Power requirements

Power consumption (W)

Television system

Color system

Stereo/Bilingual system

Channel coverage

8 (Antenna)

Audio output (Speaker)

Number of terminal

(Video)

(Audio)

(Component

Video)

i (Headphone)

FM Radio

Tuning Range

Intermediate
Frequency

Picture tube

Tube size

Viewing screen size

Dimensions (w/h/d)

Mass

Design and specifications are subject to change without notice.

110-240 V AC, 50/60 Hz

Indicated on the rear of the TV

M

NTSC3.58, PAL*, PAL 60*, SECAM*, NTSC4.43* * AV IN only

MTS KV-SZ292N60/

VHF : 2 to 13 /UHF : 14 to 69 /CATV : 1 to 125

75-ohm external terminal

6 W + 6 W

Input: 2 Output: 1 Phono jacks; 1 Vp-p, 75 ohms

Input: 3 Output: 1 Phono jacks; 500 m Vrms

Input: 1 Phono jacks;

Output: 1 Stereo minijack

87.5 - 108.0 MHz

7.9 MHz

29 in. 25 in.

724 mm 639 mm

679 mm 598 mm

774 × 590 × 506 mm 704 × 530 × 506 mm

46 kg 35 kg

Y: 1 Vp-p, 75 ohms,
sync negative
C

B: 0.7 Vp-p, 75 ohms

C

R: 0.7 Vp-p, 75 ohms

KV-SZ252N60
KV-SZ252N50

Note

SZ252N60 only

KV-SZ292N60/
SZ252N60 only

Measured diagonally

Measured diagonally

B WARNING

• Dangerously high voltages are present inside the TV.

• TV operating voltage: 110 – 240 V AC.

• Do not plug in the power cord until you have completed making all other
connections; otherwise a minimum leakage current might flow through the antenna
and other terminals to ground.

•To avoid battery leakage and damage to the remote, remove the batteries from the
remote if you are not going to use it for several days. If any liquid leaks from the
batteries and touches your skin, immediately wash it away with water.

For your own safety, do not touch
any part of the TV, the power cord
and the antenna cable during
lightning storms.

Do not place any objects on the TV.
The apparatus shall not be
exposed to dripping or splashing
and that no objects filled with
liquids, such as vases, shall be
placed on the apparatus.

Do not block the ventilation
openings of the TV. Do not install
the TV in a confined space, such
as a bookcase or built-in cabinet.

Do not open the cabinet and the
rear cover of the TV as high
voltages and other hazards are
present inside the TV. Refer
servicing and disposal of the TV
to qualified personnel.

For children’s safety, do not leave
children alone with the TV. Do not
allow children to climb onto it.

Do not operate the TV if any liquid
or solid object falls into it. Have it
checked immediately by qualified
personnel only.

Your TV is recommended for
home use only. Do not use the TV
in any vehicle or where it may be
subject to excessive dust, heat,
moisture or vibrations.

Clean the TV with a dry and soft
cloth. Do not use benzine, thinner,
or any other chemicals to clean the
TV. Do not attach anything (e.g.,
adhesive tape, cellophane tape,
glue) on the painted cabinet of the
TV. Do not scratch the picture
tube.

To prevent fire or shock hazard, do
not expose the TV to rain or
moisture.

Install the TV on a stable TV stand
and floor which can support the
TV set weight. Ensure that the TV
stand surface is flat and its area is
larger than the bottom area of the
TV.

Do not plug in too many
appliances to the same power
socket. Do not damage the power
cord.

Pull the power cord out by the
plug. Do not pull the power cord
itself. Even if your TV is turned
off, it is still connected to the AC
power source (mains) as long as
the power cord is plugged in.
Unplug the TV before moving it
or if you are not going to use it for
several days.

C Securing the TV

To prevent the TV from falling, use the supplied screws, clamps and band to
secure the TV.

20 mm

3.8 mm

screws

Screw the band to the TV stand and to the
provided hole at the rear of your TV.

or

(1) Put a cord or chain through the clamps.
(2) Screw one clamp to a wall or pillar and

clamps band

the other clamp to the provided hole at
the rear of your TV.

or

(1) Attach each end of a cord or chain to

the provided holders at the rear of your
TV.

(2) Securely fix the attached cord or chain

to a wall or pillar using an attachment
which can support the TV set weight.

• Use only the supplied screws. Use of other screws may damage the TV.

D Getting Started

Step 1

b

b

Insert the batteries (supplied) into the remote.

• Do not use old or different types of batteries together.

Step 2

Connect the antenna cable (not supplied) to 8
(antenna input) at the rear of the TV.

•Your TV can receive both TV and FM radio signals from

the appropriate connections through the 8 (antenna
input) terminal (KV-SZ292N60/SZ252N60 only) (see F).

•You can also connect your TV to other optional

components (see F).

Step 3

Plug in the power cord, then press 1 on the TV to turn
it on.

• The 1 (standby) indicator flashes green for a few seconds

when turning on the TV. This does not indicate a
malfunction.

Step 4

Select

Confirm

Set up the TV by following the instructions of the
“Initial Setup” menu (see E).

End

E

Setting up your TV (“Initial Setup”)

When you turn on your TV for the first time, the “Initial Setup” menu will
appear. You can adjust settings below using the buttons on the remote control
or TV front panel. Press V, v, B or b to select or adjust items, then press

.

Select the desired menu language.

1

Select “Yes” to preset the channels automatically.

2

To skip automatic channel presetting, select “No”.

The “Program Edit” menu enables you to edit the

3

channels (see L).

Adjust the bars on the top and bottom of the menu

4

if they are slanted.

Adjust the upper and lower bars if they are not

5

equally positioned to the top and bottom of the
screen.

Initial Setup
Language:

Select

Select

Confirm

Initial Setup
First please connect
cable/ antenna

Start Auto Program now?

Program Edit

PROG

Edit:

Select

Select

Select

Yes

No

Confirm

SkipLabel

1

Off

2

Off

3

Off

4

Off

Confirm

End

Confirm

End

Confirm

English

End

End

Exit

To prevent this “Initial Setup” menu from appearing

6

again when you turn on the TV by pressing 1,
select “No”.

Initial Setup

Display this menu next time?

To allow this menu to appear again, select “Yes”.

Select

•You can immediately go to the end of the “Initial Setup” menu by pressing WEGA
GATE.

Yes

No

Confirm