Sony SU-W210 User Manual
4-095-518-E1 (2)
Wall-Mount Bracket
Operating Instructions
• This Wall-Mount Bracket is designed for use with the Sony KLV-SG21M1
LCD Color TV.
SU-W210
© 2004 Sony Corporation
Thank you for purchasing this product.
For Customers
Sufficient expertise is required for installing this product, especially to
assure the strength of the wall. Be sure to entrust the attachment of this
product on the wall (Step 1 to Step 3 in “Installation”) to qualified service
personnel and pay adequate attention to safety during the installation. We
are not liable for any damage or injury caused by mishandling or improper
installation.
WARNING
To avoid risk of serious injury or damage to the TV caused by dropping it,
observe the following precautions.
• Do not hang from the TV or the Wall-Mount Bracket installed on the wall.
• Be careful not to trap the AC power adaptor cord of the TV when you secure
the TV to the Wall-Mount Bracket.
• Follow the installation procedures and installation direction described in this
manual.
For a safety installation, consult qualified service personnel.
• Before installing, confirm that the wall has sufficient strength to support the
TV and the Wall-Mount Bracket. The installation location should be a flat,
perpendicular wall with a reinforcing material inside.
• Do not apply a weight other than the TV to the Wall-Mount Bracket installed
on the wall.
• Do not disassemble, modify or change the parts of the Wall-Mount Bracket.
For qualified service personnel
Sufficient expertise is required for installing this product. Be sure to read this
instruction manual thoroughly to do the installation work safely. We are not
liable for any damage or injury caused by mishandling or improper
installation. After installation, please hand this instruction manual to the
customers.
2
Caution
• This Wall-Mount Bracket is only for the specified Sony LCD Color TVs.
Do not use the bracket with a TV whose operating instructions do not specify
the use of this bracket.
• Be especially careful not to drop the TV when you install it high on a wall.
Installation
For the installation, have ready eight commercially available mounting screws,
anchor bolts, etc. that are appropriate for the wall.
The type and length of the screws required depend on the material and
strength of the wall. If you do not know which material your wall is made of,
consult qualified service personnel.
For qualified service personnel
Step 1: Check the parts
Check all the parts are included in the package.
Bracket A (1) Bracket C (3)
(0°, 5°, 10°)
Bracket B (1) Bracket D (1) Locking rod (1)
Bracket E (1) Screw (6)
(with washer)
continued
3
Step 2: Decide the installation location
Decide the location on the wall to install the TV.
Then, place bracket A on the installation location and mark the four screw
holes on the wall using a pencil.
Before marking the location of the holes, make sure that the distance between the
upper edge of bracket A and the ceiling is 15 cm or more, and that between the
side edge of bracket A and the side wall is 25 cm or more.
Ceiling
25 cm or more
Bracket A
Note
Attach bracket A level with the floor.
15 cm
Wall
or more
Mark this
portion using
a pencil.
4
Step 3: Secure bracket A to the wall
Insert four of the screws you prepared at the positions
marked in Step 2 (page 4).
1
Do not tighten the screws completely for the moment. Keep a space of
2 to 3 mm from the wall.
Wall
Screws you
prepared
Press bracket A to the wall and slide it down. Then fully
tighten the four screws on the wall.
2
Bracket A
Wall
2 - 3 mm
Bracket A
Insert four of the screws you prepared in the screw holes,
and tighten them securely in the order of 1 to 4 as
3
shown below.
1
Screws you
prepared
4
3
Bracket A
2
Wall
continued
5
Loading...