4-692-893-42(1)
Wireless Speaker
Reference Guide
SRS-XB10
©2017 Sony Corporation Printed in China
http://www.sony.net/
Before operating the system, please read this guide thoroughly and
retain it for future reference.
WARNING
To reduce the risk of fire, do not cover the ventilation opening of the
appliance with newspapers, tablecloths, curtains, etc.
Do not expose the appliance to naked flame sources (for example,
lighted candles).
Do not install the appliance in a confined space, such as a bookcase or
built-in cabinet.
Do not expose the batteries (battery pack or batteries installed) to
excessive heat such as sunshine, fire or the like for a long time.
The validity of the CE marking is restricted to only those countries where
it is legally enforced, mainly in the countries EEA (European Economic
Area).
Disposal of Old Electrical & Electronic
Equipment (Applicable in the European
Union and other European countries with
separate collection systems)
Do not dismantle, open or shred secondary cells or batteries.
Do not expose cells or batteries to heat or fire. Avoid storage in direct
sunlight.
In the event of a cell leaking, do not allow the liquid to come in contact
with the skin or eyes. If contact has been made, wash the affected area
with copious amounts of water and seek medical advice.
Do not use any cell or battery which is not designed for use with the
equipment.
Secondary cells and batteries need to be charged before use.
After extended periods of storage, it may be necessary to charge and
discharge the cells or batteries several times to obtain maximum
performance.
Dispose of properly.
Precautions
On safety
Before operating the system, be sure that the operating voltage of the
system is identical with that of your local power supply.
The nameplate and important information concerning safety are
located on the bottom exterior of the main unit.
About micro-USB cables
To charge, use a micro-USB cable and connect the system to:
an AC outlet by using a commercially-available USB AC adaptor (5 V,
at least 0.5 A).
a USB port of a computer.
Make sure to use the following supplied micro-USB cable.
USB Type A plug
(connects to a PC, USB AC adaptor)
On placement
Do not set the speaker in an inclined position.
Do not leave the system in a location near heat sources, in a place
subject to direct sunlight, excessive dust, moisture, rain, or mechanical
shock, or in a car with its windows closed.
Do not leave any objects susceptible to magnetism (cash cards, floppy
disks with magnetic coding, etc.) near the system.
On cleaning
Do not use alcohol, benzine, or thinner to clean the cabinet.
Others
Even if you do not intend to use the system for a long time, charge the
battery to its full capacity once every 6 months to maintain its
performance.
If the system is not used for a long time, it may take longer to charge
the battery.
USB Micro-B plug
(connects to the system)
On Copyrights
WALKMAN and WALKMAN logo are registered trademarks of Sony
Corporation.
Microsoft and Windows are registered trademarks or trademarks of
Microsoft Corporation in the United States and/or other countries.
Android is a trademark of Google Inc.
Mac and Mac OS are trademarks of Apple Inc., registered in the U.S.
and other countries.
iPhone, iPad and iPod are trademarks of Apple Inc., registered in the
U.S. and other countries.
The BLUETOOTH® word mark and logos are owned by the Bluetooth
SIG, Inc. and any use of such marks by Sony Corporation is under
license.
The N Mark is a trademark or registered trademark of NFC Forum, Inc.
in the United States and in other countries.
Other trademarks and trade names are those of their respective
owners.
Notes on water resistant feature
(Read before using the system)
Water resistant performance of the system
This system has a water resistant specification*1,*2 of IPX5*3 as specified
in “Degrees of protection against ingress of water” of the IEC60529
“Ingress Protection Rating (IP Code).” However, this system is not
completely water-tight.
Do not drop the system into hot water in a bathtub or purposely use it in
wate r.
Liquids that the water resistant performance specifications
apply to
Applicable : fresh water, tap water
Not applicable : liquids other than the above (soapy water,
1
Requires that the cap is fastened securely.
*
2
The supplied accessories are not water resistant.
*
3
IPX5 (Degree of protection against jets of water): For details, refer to
*
Help Guide.
The water resistant performance of the system is based on our
measurements under the conditions herein described. Note that
malfunctions as a result of water immersion caused by misuse by the
customer are not covered by the warranty.
water with detergent or bath agents,
shampoo, hot spring water, pool water,
seawater, etc.)
To avoid the deterioration of the water
resistant performance
Check the following and use the system correctly.
Do not use or leave the system in an extremely hot or cold
environment (temperature outside the range of 5 °C – 35 °C. If the
system is used or left in outside the above range, the system may
automatically stop to protect internal circuitry.
Be careful not to drop the system or subject it to mechanical shock.
Deformation or damage may cause deterioration of the water
resistant performance.
Do not use the system in a location where large amount of water or
hot water may splash on it. The system does not have a design that is
resistant to water pressure. Use of the system in the above location
may cause a malfunction.
Do not pour high-temperature water or blow hot air from a hair dryer
or any other appliance on the system directly. Also, never use the
system in high temperature locations such as in saunas or near a
stove.
Handle the cap with care. The cap plays a very important role in
maintenance of the water resistant performance. When using the
system, make sure that the cap is closed completely. When closing the
cap, be careful not to allow foreign objects inside. Mark is on the
upper side of the cap. If the cap is not closed completely the water
resistant performance may deteriorate and may cause a malfunction
of the system as a result of water entering the system.
Cap
How to care for the system when wet
If the system gets wet, first remove the water from the system, and then
wipe off the moisture on the system using a soft, dry cloth. Especially in
cold regions, leaving moisture on its surface may cause the system to
freeze and malfunction. Be sure to wipe off the moisture after using the
system.
Put the system on towel or dry cloth. Then leave it at room temperature
and dry the system until no moisture remains.
Specifications
Speaker section
Speaker system Approx. 46 mm dia.
Enclosure type Built-in passive radiator
BLUETOOTH
Communication System
Output BLUETOOTH Specification Power Class 2
Maximum communication range
Frequency band 2.4 GHz band (2.4000 GHz - 2.4835 GHz)
Modulation method FHSS
Compatible BLUETOOTH Profiles*
Supported Codec*
Transmission range (A2DP)
1
The actual range will vary depending on factors such as obstacles
*
between devices, magnetic fields around a microwave oven, static
electricity, reception sensitivity, antenna’s performance, operating
system, software application, etc.
2
BLUETOOTH standard profiles indicate the purpose of BLUETOOTH
*
communication between devices.
BLUETOOTH Specification version 4.2
Line of sight approx. 10 m*
2
A2DP (Advanced Audio Distribution Profile)
AVRCP (Audio Video Remote Control Profile)
HSP (Headset Profile)
HFP (Hands-free Profile)
3
AAC*4, SBC*
5
20 Hz - 20,000 Hz (Sampling frequency 44.1 kHz)
1
*3 Codec: Audio signal compression and conversion format
4
Advanced Audio Coding
*
5
Subband Codec
*
Microphone
Type Electret condenser
Directional characteristic
Effective frequency range
General
Input AUDIO IN jack (ø 3.5 mm stereo mini jack)
Power DC 3.7 V (using the built-in lithium-ion battery),
Usage life of lithium-ion battery (using the BLUETOOTH connection)
Operating temperature
Dimensions (including projecting parts and controls)
Mass Approx. 260 g including battery
Supplied accessories Micro-USB cable (1)
*6 When the specific music source is used and the volume level of the
unit is set to 10. If the volume level of the unit is set to maximum, the
usage life will be approx. 5 hours. Time may vary, depending on the
temperature or conditions of use.
7
The item is not included in some countries/regions.
*
Design and specifications are subject to change without notice.
Omni directional
200 Hz - 4,000 Hz
DC 5 V 0.5 A (using the USB power supply)
Approx. 16 hours*
5 °C to 35 °C
Approx. 75 mm dia. × 91 mm
Strap (1) (attached to the unit)
Startup Guide (1)
Reference Guide (this document) (1)
Warranty card (1)*
6
7
Loading...