Sony SSCN-230, SSV-230, SAVE-230, SAWMS-230 Service manual
SA-VE230/WMS230/
SS-CN230/V230
SERVICE MANUAL
Ver 1.1 2001. 04
• The SA-VE230 system consists of one unit
of SA-WMS230, one unit of SS-CN230 and
four units of SS-V230.
AUDIO POWER SPECIFICATIONS
POWER OUTPUT AND TOTAL
HARMONIC DISTORTION :
with 6 Ω loads both channels driven, from 20 - 150 Hz; rated
50 W per channel minimum RMS power, with no more than
0.8% total harmonic distortion from 250 mW to rated output.
SS-V230 Front and rear speakers
Speaker system Full range, magnetically shielded
Speaker units 5
Enclosure type Bass reflex
Rated impedance 8 Ω
Power handling capacity
Maximum input power: 100 W
Sensitivity level 86 dB (1W, 1m)
Frequency range 90 Hz - 20,000 Hz
Dimensions (w/h/d) Approx. 70 × 151 × 126 mm
Mass Approx. 550 g (1 lb 3 oz) each
SS-CN230 Center speaker
Speaker system Full range × 2, magnetically
Speaker units 5
Enclosure type Bass reflex
Rated impedance 8 Ω
Power handling capacity
Maximum input power: 120 W
Sensitivity level 88 dB (1W, 1m)
Frequency range 90 Hz - 20,000 Hz
Dimensions (w/h/d) Approx. 301 × 70 × 126 mm
Mass Approx. 1.1 kg
× 9 cm (2 × 3
7
/8 × 6 × 5 in.), including front
(2
grille
shielded
× 9 cm (2 × 3
7
/8 × 27/8 × 5 in.), including front
(11
grille
(2 lb 7 oz)
Photo: SA-WMS230 Photo: SS-V230 Photo: SS-CN230
SPECIFICATIONS
5
/8 in.), cone type
5
/8 in.), cone type
Canadian Model
SA-WMS230 Subwoofer
System
Speaker system Active subwoofer, magnetically
Speaker unit Woofer : 16 cm (63/8 in.),
Enclosure type Advanded SAW type
Continuous RMS power output
(8 Ω, 20 - 150 Hz, 0.8 % THD)
Reproduction frequency range
High frequency cut-off frequency
Input
LINE IN (input pin jack)
General
Power requirements 120 V AC, 60 Hz
Power consumptions 45 W
Dimensions (w/h/d) Approx. 205 × 385 × 385 mm
Mass Approx. 10.5 kg
Supplied accessories
Foot pads (20)
Audio connecting cords (2 phono to 2 phono) (3)
Monaural connecting cord (1 phono to 1 phono) (1)
Speaker connecting cords, 10 m (32 ft
Speaker connecting cords, 2.5 m (8 ft
Design and specifications are subject to change
without notice
shielded
cone type
50 W
28 Hz - 200 Hz
200 Hz
(81/8 × 151/4 × 151/4 in.), including
front grille
(23 lb 2 oz)
93/4 in.) (2)
21/2 in.) (3)
US Model
9-929-074-12
2001D1600-1
© 2001.4
MICRO SATELLITE SYSTEM
Sony Corporation
Home Audio Company
Shinagawa Tec Service Manual Production Group
SA-VE230/WMS230/SS-CN230/V230
SAFETY CHECK-OUT
After correcting the original service problem, perform the
following safety checks before releasing the set to the customer:
Check the antenna terminals, metal trim, “metallized” knobs, screws,
and all other exposed metal parts for A C leakage. Check leakage as
described below.
LEAKAGE
The AC leaka ge from any exposed metal part to earth g round and
from all exposed metal parts to any exposed metal part having a
return to chassis, must not exceed 0.5 mA (500 microamperes).
Leakage current can be measured by any one of three methods.
1. A commercial leakage tester, such as the Simpson 229 or RCA
WT -540A. Follo w the manufacturers’ instructions to use these
instruments.
2. A battery-operated AC milliammeter. The Data Precision 245
digital multimeter is suitable for this job.
3. Measuring the voltage drop across a resistor by means of a
VOM or battery-operated A C voltmeter . The “limit” indication
is 0.75 V, so analog meters must have an accurate lo w-v oltage
scale. The Simpson 250 and Sanwa SH-63Trd are e xamples of
a passive VOM that is suitable. Nearly all battery operated
digital multimeters that have a 2V AC range are suitable. (See
Fig. A)
SAFETY-RELATED COMPONENT WARNING!!
COMPONENTS IDENTIFIED BY MARK 0 OR DOTTED LINE WITH
MARK 0 ON THE SCHEMATIC DIAGRAMS AND IN THE PARTS
LIST ARE CRITICAL TO SAFE OPERATION. REPLACE THESE
COMPONENTS WITH SONY PARTS WHOSE PART NUMBERS
APPEAR AS SHOWN IN THIS MANUAL OR IN SUPPLEMENTS
PUBLISHED BY SONY.
ATTENTION AU COMPOSANT AYANT RAPPORT
À LA SÉCURITÉ!
LES COMPOSANTS IDENTIFÉS P AR UNE MARQUE 0 SUR LES
DIAGRAMMES SCHÉMA TIQUES ET LA LISTE DES PIÈCES SONT
CRITIQUES POUR LA SÉCURITÉ DE FONCTIONNEMENT. NE
REMPLACER CES COMPOSANTS QUE PAR DES PIÈSES SONY
DONT LES NUMÉROS SONT DONNÉS DANS CE MANUEL OU
DANS LES SUPPÉMENTS PUBLIÉS PAR SONY.
T o Exposed Metal
Parts on Set
AC
0.15 µF
Fig. A. Using an A C v oltmeter to check A C leakage.
1.5 kΩ
Earth Ground
Voltmeter
(0.75 V)
2
SA-VE230/WMS230/SS-CN230/V230
d
SECTION 1
DIAGRAMS
1-1. NOTE FOR PRINTED WIRING BOARDS AND SCHEMATIC DIAGRAMS
Note on Printed Wiring Board:
• X : parts extracted from the component side.
• b : Pattern from the side which enables seeing.
• Indication of transistor.
Q
B
CE
These are omitted.
Note on Schematic Diagram:
• All capacitors are in µF unless otherwise noted. pF: µµF
50 WV or less are not indicated except for electrolytics
and tantalums.
• All resistors are in Ω and 1/
specified.
• 2 : nonflammable resistor.
• 5 : fusible resistor.
• C : panel designation.
Note:
The components identified by mark 0 or dotted
line with mark 0 are critical for safety.
Replace only with part
number specified.
• A : B+ Line.
• B : B– Line.
• Voltages are dc with respect to ground under no-signal
conditions.
• Voltages are taken with a VOM (input impedance 10 MΩ).
Voltage variations may be noted due to normal production tolerances.
• Signal path.
F : AUDIO
4
W or less unless otherwise
Note:
Les composants identifiés par
une marque 0 sont critiques
pour la sécurité.
Ne les remplacer que par une
piéce portant le numéro
spécifié.
• Circuit Boards Location
SA-WMS230
POWER SWITCH board
LED board
CONTROL board
POWER board
MAIN boar
3
SA-VE230/WMS230/SS-CN230/V230
• IC Block Diagrams
IC302 uPC1237H
OVER LOAD DET
CC
ON
OFFSET DET
LATCH/
AUTORESET
AC OFF
DET
1 2 3 4 5 6 7 8
F/F
V
MUTE
CC
V
4
1-2. PRINTED WIRING BOARD (SA-WMS230)
• See page 3 for Circuit Boards Location.
There are a few cases that the part printed on
SA-VE230/WMS230/SS-CN230/V230
this diagram isn’t mounted in this model.
A
B
C
12
CONTROL BOARD
IC201
MODE
ON : MUSIC
OFF: MOVIE
POWER SWITCH
BOARD
POWER
34567891011
POWER BOARD
IC401
11
(13)
LEVEL
11
(13)
LED BOARD
1-676-565-
(POWER)
11
(13)
• Semiconductor
Location
Ref. No. Location
D301 F-8
D302 F-8
D303 F-5
D304 D-9
D501 G-5
D502 G-7
D503 H-7
D801 B-7
IC101 G-11
IC102 G-9
IC103 E-11
IC201 B-3
IC302 E-9
IC401 B-10
Q101 G-9
Q102 G-8
Q103 E-10
Q303 D-9
D
E
F
G
AC
IN
MAIN BOARD
11
(13)
T501
POWER
TRANSFORMER
SP1
(SPEAKER)
IC102
IC302
IC103
IC101
H
12
(13)
LINE
55
Loading...