Sony RMT-V259P Service Manual
Getting Started
7
Setting up the remote commander
Notes
• With normal use, the batteries should last about three to six months.
• If you do not use the remote commander for an extended period of time, remove the batteries
to avoid possible damage from battery leakage.
• Do not use a new battery with an old one together.
• Do not use different types of batteries together.
• Some buttons may not work with certain Sony TVs.
Controlling other TVs with the remote commander
The remote commander is preprogrammed to control non-Sony TVs. If your TV is
listed in the table below, set the appropriate manufacturer’s code number.
* These buttons may not work with all TVs.
Tip
• When you set your TV’s code number correctly while the TV is turned on, the TV turns off
automatically.
Select the sound AUDIO MONITOR
Use FASTEXT FASTEXT buttons
Call up the on-screen display
DISPLAY
Change the Teletext page
c
/
C
Switch to/from wide mode of a Sony wide TV (For other
manufactures’ wide TVs, see “Controlling other TVs with
the remote commander”.)
WIDE
To Press
1
Set TV/VIDEO at the top of the remote commander to TV.
2
Hold down ?/1, and enter your TV’s code number(s) using the programme
number buttons.Then release ?/1.
Now you can use the following TV control buttons to control your TV:
?/1
, TV/VIDEO, programme number buttons, –/– – (ten’s digit), PROG +/–,
2
+/–, a (TV), / (Teletext), FASTEXT buttons, WIDE
*
, MENU*,
M
*
/
m
*
/
<
*
/
,
*
, and OK*.
continued
8
Setting up the remote commander
Code numbers of controllable TVs
If more than one code number is listed, try entering them one at a time until you find
the one that works with your TV.
To switch to wide mode, see the footnotes below this table for the applicable code
numbers.
*1
Press WIDE to switch to the wide picture mode you want.
*2
Press WIDE, then press 2 +/– to select the wide picture mode you want.
*3
Press WIDE. The menu appears on the TV screen.Then, press M/m/</, to select the wide picture you
want and press OK.
Notes
• If the TV uses a different remote control system from the one programmed to work with the VCR, you
cannot control your TV with the remote commander.
• If you enter a new code number, the code number previously entered will be erased.
• If you remove the batteries of the remote commander for more than a few minutes, the code number may
be reset to 01 (Sony). In this case, reset the appropriate code number.
Manufacturer Code number
Sony
01
*1
, 02
Akai 68
Blaupunkt 10
C.G.M 09
Ferguson 52
Goldstar 03, 04, 17
Grundig
10
*1
, 11
*1
Hitachi 24
ITT
15, 16, 69
*3
JVC 33
Loewe 45
Mivar 09
NEC 66
Nokia
15, 16, 69
*3
Panasonic
17
*1
, 49
Philips
06
*1
, 07*1, 08
*1
Saba 12, 13
Samsung 22, 23
Sanyo 25
Sharp 29
Telefunken 36
Thomson
43
*2
To sh ib a 3 8
Manufacturer Code number
Loading...