Sony PM-0751 Startup Guide
Important Information
Before you use your device, please read the
Important
Information
provided in your device regarding warranty,
safety and handling information.
Protecting your device from water
and dust
Your device has IP (Ingress Protection) ratings of IP55 and
IP58. These ratings mean that your device is dust resistant
and is protected against low pressure water stream as well
as against the effects of submersion for 30 minutes in fresh
(non-saline) water up to 1.5 metres deep.
Always firmly attach all covers to ensure the water and dust
resistance of the device. If liquid is detected inside the
device, for example, underneath one of the covers, your
warranty will be void.
Before using your device in water and in dusty conditions,
refer to the relevant section of the User guide for your
device for more detailed information. An online User guide
as well as a downloadable version is available at
www.sonymobile.com/support
.
Overview
6
1 2 3 5
7
8
4
9
10
11 12
13
14
15
16
1. Front camera lens
2. Speaker/Charging
light/Notification light
3. Second microphone
4. Proximity/Light sensor
5. Headset jack
6. Power key
7. Volume/Zoom key
8. Camera key
9. Speaker
10. Microphone
11. Main camera lens
12. Camera light
13. Charger/USB port cover
14. NFC™ detection area
15. Charging dock connector
16. Cover for micro SIM/
memory card slot
Assembly
Make sure you insert the micro SIM card into the SIM card
holder before inserting the card into the device. Also, don’t
confuse the SIM card slot with the memory card slot.
To insert the micro SIM card
If you insert the SIM card while the device is powered on,
the device restarts automatically.
1
Detach the cover for the micro SIM card holder.
2
Using a fingernail or other similar object, drag out the SIM
card holder.
3
Place the micro SIM card in the SIM card holder, then
reinsert the holder.
4
Re-attach the cover.
Make sure you reinsert the SIM card holder in the correct
orientation. When you drag the holder out to insert the
micro SIM card, do not turn it around.
To insert the memory card
1
Remove the memory card slot cover.
2
Insert the memory card into the memory card slot with the
gold coloured contacts facing down, then reattach the
memory card slot cover.
Basics
Turning on the device
Make sure that the battery is charged for at least 30 minutes
before you turn on the device for the first time.
To turn on the device
Make sure that the battery is charged for at least 30
minutes before you turn on the device for the first time.
1
Press and hold down the power key until the device
vibrates.
2
Wait a while for the device to start.
Waking up the screen
To activate the screen
•
Briefly press the power key
.
•
If Tap to wake up mode is enabled, double-tap the screen.
To enable Tap to wake up mode, go to the Home screen,
then tap > Settings > Display > Tap to wake up.
Setting up your device
Basic settings
The first time you start your device, a setup guide explains
basic device functions and helps you enter essential settings.
You can also access the setup guide later.
To access the setup guide manually
1
From the Home screen, tap .
2
Tap Settings > Setup guide.
Loading...