Sony PCG-GRT250P User Manual
PCG-GRT Series Hard Disk Drive
Replacement Instructions
These easy instructions are intended to guide you through the replacement process.
9 To avoid electric shock please make sure product is turned off and AC Adapt or is disconnected
* Sony is not responsible for any loss of data associated with your computer or an y damage caused by
incorrect handling of the computer under these procedures. The terms of your Sony Limited Warranty
continue to apply.
from the power source. Remove jewelry before you begin work to av oid scratching the surface o f
your notebook computer.*
9 Place your notebook computer on a clean, stable and covered surface to avoid damage to the
computer's case.*
9 Follow the ESD (Electrostatic Discharge) damage prevention instructions:
o Hold parts by the edges, away from exposed circuitry when possible.
o Do not walk around excessively as this promotes static build-up.
9 The appearance of the electronic components shown in the illustrations may be different from the
components shipped. This slight difference does not affect the accuracy of these instructions.
PLEASE READ BEFORE YOU START
IMPORTANT!
Step 1. Prepare the Computer.
CAUTION: Make sure the
computer is turned off, the lid is
closed, and the AC Adapter is
disconnected. Failure to do so can
result in damage to the computer.
Place the computer upside down on
a protected surface with the HDD
bay facing you.
P/N T99860135 Rev. B 1/2
Step 2. Remove the Battery Pack.
Locate the battery door and unlock it.
With your thumbs, pull the battery in
the release direction as shown in the
picture.
Step 3. Remove completely the
battery pack from the computer and
set aside.
PCG-GRT Series Hard Disk Drive
Replacement Instructions
Step 4. Remove the HDD Bay.
Using the enclosed magnetic
screwdriver, remove the two (2)
screws securing the hard disk drive
bay.
Step 7. Install New HDD Bay.
Hold the new HDD Bay by the edges
and align it with the opening. With an
even force slide in the new HDD
Bay.
Step 5. Release the HDD Bay.
Slide out the HDD Bay as shown.
Some force may be required to
unlock the HDD Bay.
Step 8. Reinstall the two (2) screws
previously removed.
Reinstall the Battery Pack and
reconnect the AC Adapter.
Step 6. Gently pull the original HDD
Bay away from the computer as
shown.
Step 9. Power on your computer
and continue with the recovery
process by following the
instructions described on the back
of the recovery disk’s case.
Return the old HDD Bay to Sony
following the included shipping
instructions.
P/N T99860135 Rev. B 2/2
Loading...