Sony DTPT1001 Users Manual

Testing Tool

Instruction manual

SCE CONFIDENTIAL

This manual contains safety precautions for the prevention of accidents,
and instructions for the use and handling of this product.
Read this manual carefully and use the product in a safe manner. After
reading the manual, store it in an accessible location for future reference.

DTP-H1500 A
DTP-L1500 A

2-591-231-12(2)

WARNING

WARNING

To avoid electrical shock, do not
open the cabinet. Refer servicing to
qualified personnel only.

Use the supplied AC adaptor only. If
you use other types, it may cause fire,
electrical shocks or a malfunction.

Laser specifications

TM

UMD

Wave length: 655-665 nm
Power: max 0.28 mW
Type: Semiconductor, continuous

DVD-ROM

Wave length: 640-660 nm (DVD)

Power: max 0.3 mW (DVD)

Type: Semiconductor, continuous

For customers in the U.S.A. and Canada

CAUTION

The use of optical instruments with this product will
increase eye hazard. As the laser beams used in the DVD­ROM and UMD™ drives are harmful to eyes, do not
attempt to disassemble the cabinet.
Refer servicing to qualified personnel only.

775-805 nm (CD)

0.23 mW (CD)

Operation of this equipment in a residential area is likely to
cause harmful interference in which case the user will be
required to correct the interference at his own expense.

You are cautioned that any changes or modifications not
expressly approved in this manual could void your
authority to operate this equipment.

FCC Radio-Frequency Exposure Statement

This equipment complies with FCC radiation exposure
limits set forth for an uncontrolled environment. This
equipment should be installed and operated with minimum
distance 20 cm between the radiator and body. This
transmitter must not be co-located or operating in
conjunction with any antenna or transmitter.

Owner’s Record

The model and serial numbers are located on the side of the
unit. Record the serial number in the space provided below.
Refer to these numbers whenever you call for technical
assistance at the number shown in "Contact information" on
the back cover of this instruction manual.
Model No.

DTP-H1500 A
DTP-L1500 A

Serial No.______________

For customers in Canada

This Class A digital apparatus complies with Canadian
ICES-003.
The term “IC” before the equipment certification number
only signifies that the Industry Canada technical
specifications were met.

Operation is subject to the following two conditions; (1) this
device may not cause interference, and (2) this device must
accept any interference, including interference that may
cause undesired operation of the device.

This label is located on the DVD-ROM laser protective
housing inside the enclosure.

For customers in the U.S.A.

CAUTION

Use of controls, adjustments or performance of procedures
other than those specified herein may result in hazardous
radiation exposure.

NOTE:

This equipment has been tested and found to comply with
the limits for a Class A digital device, pursuant to Part 15 of
the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference when the
equipment is operated in a commercial enviroment.
This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications.

2

WARNING

Pour les utilisateurs au Canada

Cet appareil numérique de la classe A est conforme à la
norme NMB-003 du Canada.
Le terme “IC” avant le numéro d’homologation ne signifie
seulement que les normes d’Industrie Canada ont été
respectées.

L'utilisation de ce dispositif est autorisée seulement aux
conditions suivantes : (1) il ne doit pas produire de
brouillage et (2) l'utilisateur du dispositif doit être prêt à
accepter tout brouillage radioélectrique reçu, même si ce
brouillage est susceptible de compromettre le
fonctionnement du dispositif.

WARNING

For customers in Europe

CAUTION

The use of optical instruments with this product will
increase eye hazard. As the laser beams used in the DVD­ROM and UMD™ drives are harmful to eyes, do not
attempt to disassemble the cabinet.
Refer servicing to qualified personnel only.

This label is located on the DVD-ROM laser protective
housing inside the enclosure.

This appliance is classified as a CLASS 1 LASER product.
The CLASS 1 LASER product marking is located on the side
of the product.

This equipment complies with EN55022 CLASS B and
EN55024 for use in the following areas: residential,
business, and light-industrial.

This equipment has been tested and found to comply with
the limits set out in the R&TTE Directive using a connection
cable shorter than 3 metres.

Audio and picture distortion may occur if this equipment is
positioned in close proximity to any equipment emitting
electromagnetic radiation.

If this unit is affected by static electricity or burst-noise, it
may not work correctly.

For customers in Korea

0 4 1 2

WARNING

3

Important safeguards

For your protection, please read these
safety instructions completely before
operating the appliance, and keep this
manual for future reference.

Carefully observe all warnings,
precautions and instructions on the
appliance, or those described in the
instruction manual and adhere to them.

USE

Power sources

This unit should be operated only from the type of
power source indicated on the marking label. If you
are not sure of the type of electrical power supplied
to your home, consult your dealer or local power
company. For those units designed to operate from
battery power, or other sources, refer to the
operating instructions.

Overloading

Do not overload wall outlets, extension cords or
convenience receptacles beyond their capacity,
since this can result in fire or electric shock.

Liquid and foreign objects

Never push objects of any kind into the unit through
openings as they may touch dangerous voltage
points or short out parts that could result in a fire or
electric shock. Never spill liquid of any kind on the
unit.

Attachments

Do not use attachments not recommended by the
manufacturer, as they may cause hazards.

Cleaning

Unplug the unit from the wall outlet before cleaning
or polishing it. Do not use liquid cleaners or aerosol
cleaners. Use a cloth lightly dampened with water
for cleaning the unit exterior.

INSTALLATION

Water and moisture

Do not use the powerline operated unit near water –
for example, near a bathtub, washbowl, kitchen
sink, or laundry tub, in a wet basement or near a
swimming pool, etc.

Power cord protection

Route the power cord so that it is not likely to be
walked on or pinched by items placed upon or
against it, paying particular attention to the plugs,
receptacles, and the point where the cord exits from
the unit.

Ventilation

The slots and openings in the cabinet are provided
for necessary ventilation. To ensure reliable
operation of the unit, and to protect it from
overheating, these slots and openings must never be
blocked or covered.

– Never cover the slots and openings with a

cloth or other materials.

–Never block the slots and openings by placing

the unit on a bed, sofa, rug or other similar
surface.

Accessories

Do not place the unit on an unstable cart, stand,
bracket or table. The unit may fall, causing serious
injury to a child or an adult, and serious damage to
the unit.
Use only a cart, stand, tripod, bracket, or table
recommended by the manufacturer.

An appliance and cart combination should be
moved with care. Quick stops, excessive force, and
uneven surfaces may cause the appliance and cart
combination to overturn.

– Never place the unit in a confined space, such

as a bookcase, or built-in cabinet, unless
proper ventilation is provided.

– Do not place the unit near or over a radiator or

heat register, or where it is exposed to direct
sunlight.

4

Important safeguards

Important safeguards

SERVICE

Damage requiring service

Unplug the unit from the wall outlet and refer
servicing to qualified service personnel under the
following conditions:

–When the power cord or plug is damaged or

frayed.

– If liquid has been spilled or objects have fallen

onto the unit.
– If the unit has been exposed to rain or water.
– If the unit has been subject to strong physical

shock by being dropped, or the cabinet has

been damaged.
– If the unit does not operate normally when

following the instruction manual. Adjust only

those controls that are specified in the

instruction manual. Improper adjustment of

other controls may result in damage and will

often require extensive work by a qualified

technician to restore the unit to normal

operation.
– When the unit exhibits a distinct change in

performance – this indicates a need for service.

Servicing

Do not attempt to service the unit yourself as
opening or removing the exterior casing may expose
you to dangerous voltage or other hazards.
Refer all servicing to an authorized service center.
Refer to the contact information on the back cover
to receive instructions on obtaining repair/
replacement services.

Replacement parts

When replacement parts are required, be sure the
service technician has used replacement parts
specified by the manufacturer that have the same
characteristics as the original parts.
Unauthorized substitutions may result in fire,
electric shock, or other hazards.

Safety check

Upon completion of any service or repairs to the
unit, ask the service technician to perform routine
safety checks (as specified by the manufacturer) to
determine that the unit is in safe operating
condition.

Important safeguards

5

Precautions

Safety

This product has been designed with the highest concern for safety. However, any electrical device, if
used improperly, has the potential for causing fire, electrical shock or personal injury. To help ensure
accident-free operation, follow these guidelines.

• Observe all warnings, precautions and instructions.

• Stop use and unplug the AC power cord from the electrical outlet if the unit functions in an abnormal
manner, or produces unusual sounds or smells.

• Call the number listed on the back cover for technical assistance if the device does not operate
properly.

• Do not remove the unit’s exterior or disassemble the unit. The laser beam emitted from the lens of this
unit may be harmful to the eyes.

• Do not use the unit near water.

• Stop using the unit immediately if you experience any of the following symptoms. If the condition
persists, consult a doctor.
– Lightheadedness, nausea or a sensation similar to motion sickness
– Tired, uncomfortable or aching hands or arms
– Tired, dry or aching eyes

• Avoid looking at the screen for prolonged periods of time.

• Listening to sound continuously for a long time with a high volume may adversely affect the ears. Be
careful, especially when using headphones. Adjust the volume so that surrounding sounds can be
heard.

• Do not close the disc tray or disc cover in a way that could pinch your hand or fingers, as personal
injury or damage to the unit could result.

• The socket outlet shall be installed near the equipment and shall be easily accessible.

Use and handling

• Do not use the unit or accessories outdoors.

• Do not throw or drop the unit or accessories, or expose the devices to strong physical shock. Handle
the analog stick with care.

• Do not forcibly twist the controller or expose it to strong physical shock, as doing so can cause
damage.

• Do not place the unit or accessories on surfaces that are unstable, tilted or subject to vibration.

• Do not expose the unit or accessories to high temperatures, high humidity or direct sunlight.

• Do not block the vents.

• Do not wrap the unit or accessories in cloth or similar materials.

• Do not allow dust to build up on the unit.

• Do not place the unit in locations of poor ventilation, such as small, enclosed areas, directly against a
wall or on a thick carpet or bedding.

• Do not expose the unit to dust, smoke or steam.

• Do not allow liquid or small particles to get into the unit.

• Do not put heavy objects on the unit.

• Do not place anything in front of the disc tray.

• Do not use damaged, reshaped or repaired discs.

• Do not touch or insert foreign objects into the connectors of the unit or accessories.

• Do not insert cords and cables at an angle. Doing so may damage the connector pins or create the risk
of fire.

• Do not set the unit other than in the vertical position.

• If a spring or screw is provided to secure a cable connector, use the provided spring or screw to secure
it. Take care to prevent making faulty connections.

6

Precautions