Safety Regulations
WARNING
You are cautioned that any changes or modifications not expressly approved in this manual
could void your authority to operate this equipment.
To reduce the risk of fire or electric shock, do not expose this apparatus to rain or moisture.
To avoid electrical shock, do not open the cabinet. Refer servicing to qualified personnel only.
CAUTION:
As the laser beam used in the DRU-170C is harmful to the eyes, do not attempt to disassemble the
cabinet. Refer servicing to qualified personnel only.
The use of optical instruments with this product will increase eye hazard.
The use of controls or adjustments or performance of procedures other than those specified
herein may result in hazardous radiation exposure.
This label is located on the top of the drive unit enclosure.
Dieses Etikett befindet sich an der Oberseite des Laufwerksgehäuses.
DVD/CD
Rewritable Drive
Product Information
Included Documents
❑ Quick Start Guide
❑ Electronic manual on the software disc
❑ Warranty card (for US and Canada)
❑ Product Information (this document)
The DRU-170C is classified as a CLASS 1 LASER PRODUCT.
The CLASS 1 LASER PRODUCT label is located at the top of the enclosure.
Bei diesem DRU-170C handelt es sich um ein Laser-Produkt der Klasse 1.
Das Etikett mit der Aufschrift LASER KLASSE 1 PRODUKT befindet sich an der Oberseite
des Gehäses.
CLASS 1
LASER PRODUCT
LASER KLASSE 1
PRODUKT
• Power-Burn and
• Pentium is a registrated trademark of Intel Corporation.
• Microsoft, MS, MS-DOS, Windows, and Windows Vista are registered trademarks of Microsoft Corporation.
• Other system and product names used herein are registered trademarks or trademarks of their respective
manufacturers, although the
Before using this device, be sure to read the end-user license agreements for the software provided with your
computer.
❑ Our product warranty is valid only when the supplied accessories (including software) are used in the
specified or recommended system environment, in accordance with the documentation, and applies
only to this DVD/CD rewritable drive. Our customer service and user support apply only under these
product warranty conditions.
Please note that we cannot accept responsibility for failure of the computer or other devices,
❑
incompatibility with special hardware, operating problems caused by improper installation of software,
loss of data, discs or other accidental or incidental damage that might occur when using this product.
❑ The guarantee and user support for this product are valid only within the countries or sales regions
specified on the warranty card.
❑ Copyright laws prohibit the copying in part or in full of the supplied software and documentation, or
loaning the software, without obtaining permission of the copyright holder.
❑ We cannot accept responsibility for any direct or indirect financial damage or loss of profit that might
occur when using the supplied software.
❑ The supplied software can only be used with this product.
❑ Specifications of the supplied software may be changed without notice in the interest in product
improvement.
LUOKAN 1 LASERLAITE
KLASS 1 LASER APPARAT
are trademarks of Sony Corporation.
TM
and ® marks are not used in the text.
DRU-170C
2006 Sony Corporation Printed in China P/N: 78199E00003WA
English
Please refer to this manual together with the “ATAPI Interface Drive User’s Guide” in the attached
Software Disc, which carries more detailed information.
Français
Reportez-vous au présent manuel ainsi qu’au document intitulé “Lecteur d’interface ATAPI - Guide
de l’utilisateur” contenu sur le disque du logiciel accompagnant ce produit pour plus de détails.
Deutsch
Einzelheiten entnehmen Sie bitte diesem Handbuch sowie der “Laufwerk mit ATAPI-Schnittstelle Anwenderanleitung” auf der mitgelieferten Software-Disc.
Español
Consulte este manual junto con la “Unidad de interfaz ATAPI - Guía del usuario” del disco de
software suministrado, que contiene información más detallada.
Italiano
Fare riferimento al presente manuale insieme a “Guida dell’utilizzatore dell’unità disco con interfaccia ATAPI”
nel disco del software allegato, nel quale sono contenute informazioni più dettagliate.
Português
Consulte este manual juntamente com o “Guia do Utilizador do Drive de Interface ATAPI” incluído
no disco de software fornecido, para obter informações mais detalhadas.
Nederlands
Raadpleeg deze handleiding alsook de “ATAPI Station-interface -Gebruikershandleiding” op de
bijgevoegde Software Disc, die meer gedetaileerde informatie bevat.
Svenska
Förutom denna bruksanvisning finns mer information i “Brukanvisning för enhet med ATAPI
gränssnitt” på den medföljande programskivan.
Introduction
Specifications
This product offers the following features.
❑ You can write at a maximum of 18×
when using high speed DVD+R,
❑ An internal DVD/CD rewritable drive
with ATAPI (EIDE) interface for
computers.
❑ Can be used horizontally or vertically.
❑ The drive can write to DVD+R Double
Layer and DVD-R Dual Layer discs.
DVD-R discs.
❑ The drive can write to DVD-RAM discs.
❑ Features the
technology to prevent buffer underrun
errors.
System Requirements
The drive should be used with a system that
meets the following requirements1).
❑ PC/AT-compatible computer
❑ CPU: Pentium III, 800 MHz or higher
(Pentium 4, 2.0 GHz or higher
recommended)
❑ 256 MB RAM (512 MB RAM for
Windows Vista) or more
❑ 1 GB (10 GB for DVD creation) free
hard disk space
❑ One available EIDE (ATAPI) interface
connection with DMA capability
2)
❑ One empty 5-inch half-height drive bay
❑ One available internal +12 V/+5 V power
connector
3)
❑ Operating system:
Windows 2000 Professional SP4
(referred to as Windows 2000 SP4),
Windows XP Home Edition SP2/
Windows XP Professional SP2 (referred
to as Windows XP SP2), or Windows
Vista Home Basic/Windows Vista Home
Premium/Windows Vista Business/
Windows Vista Ultimate
1)
The above requirements the minimum necessary
requirements to write to disc normally. Under
actual operating conditions, the requirements
imposed by your software must also be met. For
details, refer to your software documentation.
2)
The drive does not support connection to an
ATAPI interface card. Connect the drive to the
IDE (ATAPI) interface connector of your
computer’s motherboard.
3)
The drive consumes a lot of power when
operating at high speeds. You should therefore
make sure that the rated power output of the
power outlet where you connect all your drives is
sufficient to power all the drives, including this
one. For details about each drive’s power
consumption rating, refer to their documentation.
Package Contents
Please verify that the package includes the following accessories with the drive when
unpacking.
If any of these items appears to be missing or damaged, please contact your supplier.
• Drive • Screws (×4)
• Product Information (this document)
• Quick Start Guide
• Software disc
• Warranty card (for US and Canada)
Note
Make sure that you back up the supplied software disc on another disc because the software disc is not distributed
independently.
Please Record Responsibly
Before copying anything onto a disc, please be sure that you are not violating copyright
laws. Most software companies allow you to make a backup or archive copy of software.
Check your software’s license agreement for details.
Compatible discs Read Write
(max.) (max.)
DVD+R
DVD+R Double Layer 12×-CAV
DVD+RW 13×-CAV
DVD-R 16×-CAV
DVD-R Dual Layer 12×-CAV
DVD-RW 13×-CAV 6
DVD-RAM(5×)
DVD-RAM(12×)
1)
1)
16×-CAV 18×-CAV
8×-ZCLV
8×-ZCLV
18×-CAV
8×-ZCLV
×
5× 5
×
12×-PCAV 12×-PCAV
DVD-ROM 16×-CAV −
Buffer under-run error protection
technology
Operating Environment
5 to 40 °C
Power and Miscellaneous
Power source
DC +5 V 1.6 A max.
DC +12 V 1.8 A max.
DVD-Video 16×-CAV −
×
-CAV
CD-R 48
CD-RW
CD-RW(High Speed)
CD-RW(Ultra Speed)
CD-RW(Ultra Speed Plus)
40×-PCAV4×
40×-PCAV
40×-PCAV 24×-ZCLV
40×-PCAV 32×-ZCLV
CD-ROM 48×-CAV −
CD-DA
2)
CD-DA (DAE) 40
10×-CAV −
×
48×-CAV
10
-PCAV −
Size
Approx. 146 × 41.3 × 170 mm (W×H×D)
×
(excluding front panel)
Weight
Approx. 0.7 kg (drive only)
Laser
CD
Disc diameters
DVD 12 cm
3)
8 cm
CD 12 cm
3)
8 cm
1)
Use a non-cartridge-type disc or a cartridge from which the
disc can be ejected.
2)
This product is designed to playback discs that conform to
the Compact Disc (CD) standard. Recently, various music
discs encoded with copyright protection technologies are
marketed by some record companies. Please be aware that
among those discs, there are some that do not conform to
the CD standard and may not be playable by this product.
When you use this unit as an audio CD player, please use
compact discs with the following mark.
−
Wavelength: 783 nm
Output power (max): 100 mW (CW)
DVD
Wavelength: 658 nm
Output power (max): 100 mW (CW)
Interface
Drive interface
ATAPI (EIDE)-compliant
Buffer capacity
2 MB
Drive product number (Inquiry)
3)
With 8 cm discs, you must place the drive horizontally.
SONY DVD RW AW-G170A
Design and specifications are subject to
Drive
change without notice.
Data transfer rate
DVD: 24.9 MB/s (18× speed4))
×
CD: 7.2 MB/s (48
speed4))
Access time
Average random stroke
Approx. 160 ms (DVD)
Approx. 140 ms (CD)
4)
Maximum data transfer rate depends on the
capabilities of the host computer.
Product and Support Information
DVD region codes
The playback of DVD-Video (DVD discs) is
protected and controlled by a region code
setting. For the drive to play back DVDVideo, the region code on the DVD disc, the
region code of the drive, and the region code
of the DVD-Video software must all match.
With this drive, the region code can be set up
to five times, including the initial assignment
(RPC phase 2 standard). After setting the
region code five times, the setting becomes
permanent and can no longer be changed.
From this point on, you are only able to play
back DVD-Video whose region code
matches the one set the fifth time.
Do not attempt to make unauthorized
changes to the region code. Any problems
resulting from doing so are not covered by
the warranty.
Hint
You can change the region code of the drive on it’s
properties dialog box accessible from the Device
Manager.
Precautions for Use
Avoiding condensation problems
As much as possible, avoid sudden temperature changes. Do not attempt to use the drive
immediately after moving it from a cold to a warm location, or raising the room temperature
suddenly, as condensation may form within the drive. If the temperature changes suddenly
while using the drive, stop using it but keep the power on for at least an hour.
Attention Regarding DualDisc Software
A DualDisc is a two sided disc product which mates DVD recorded material on one side with
digital audio material on the other side.
However, since the audio material side does not conform to the Compact Disc (CD) standard,
playback on this product is not guaranteed.
Sony Global Sites Information (As of February, 2007)
Product purchased in the USA:*
http://sony.storagesupport.com/
Product purchased in Canada:
http://www.sony.ca/
Product purchased in Singapore:
http://www.sony-asia.com/storage/
* Local Web sites for computer peripheral products
About the Bundled Writing Software
Detailed information about the supplied
writing software is available on the Web
sites of the software manufacturers and
software distributors. (Accessible from the
links in each software application)
Technical Support
Please consult the Sony global sites listed
before calling with questions about using
this product, or with technical questions
about the drive or the supplied software. If
using telephone or e-mail support, please
have the following information available:
• Model number: DRU-170C
• Serial number
• Date and place of purchase
• Computer maker and model number
• Computer specifications (CPU speed,
memory size, OS version, etc.)
• Writing software used (version, etc.)
Local technical support is only
available in the specified sales
regions. The customers in these
regions should be provided with a
warranty card for this product. For
contact information, refer to the
warranty card.
Note that technical support
conditions may vary according to
the locality, and that charges and/
or limited service may apply in
some regions.