Sony CPD-15SF1 User Manual [en, es, fr]
3-758-954-22 (1)
Trinitron® Color Computer Display
Multiscan 15sf
Multiscan 17sf
Operating Instructions.
Mode d’empioi
Manual de instrucciones
____ __ _
CPD-15SF1
MODEL:
® 1994 by Sony Corporation
CPD-17SF1
Owner’s Record
The model and serial numbers are located at the rear of the unit.
Record the sedal number in the space provided below. Refer to
these numbers whenever you call upon your dealer regarding this
product.
Model No. CPD- . Serial No..
WARNING
To prevent fire or shock hazard, do not
expose the unit to rain or moisture.
Dangerousiy high voitages are present
inside the set. Do not open the cabinet.
Refer servicing to quaiified personnei
oniy.
This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part IS of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instru(^ons, may cause
harmful interference to radio communications. However, there is no
guarantee that interference wilt not occur in a particular installation.
If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
You are cautioned that any changes or modifications not expressly
approved in this manual could void your authority to operate this
equipment.
Bescheinigung des Hersteüers
Hiermit wird bescheinigt, daß der Monitor CPO-1SSF1/17SF1 in
Übereinstimmung mit den Bestimmungen der BMPT* Amtsblatt
Vfg 243/1991, Vfg 46/1992 funkentstört ist.
Oer vorschriftsmäßige Betrieb mancher Geräte (z.B. Meßsender)
kann allerdings gewissen Einschränkungen unterliegen.
Beachten Sie deshalb die Hinweise in der Bedienungs
anleitung. Dem Bundesamt für Zulassungen in der
Telekommunikation wurde das Inverkehrbringen dieses Gerätes
angezeigt und die Berechtigung zur Überprüfung der Serie auf
Einhaltung der Bestimmungen eingeräumt.
Sony Deutschland GmbH
Hugo Eckener Str. 20 50829 Köln
Hinweis
Gemäß der Amtsblätter des BMPT Nm. 61/1991 und 6/1992
wird der Betreiber darauf aufmerksam gemacht, daß die von ihm
mit diesem Gerät zusammengestellte Anlage auch den
technischen Bestimmungen dieser Amtsblätter genügen muß.
Hinweise
• Aus ergonomischen Gründen wird empfohlen, die Gaindfarbe
Blau nicht auf dunklem Untergrund zu verwenden (schlechte
EikennbaikeiL Augenbelastung bei zu geringem
Zeichenkontrast).
• Aus ergonomischen Gründen (flimmern) sollten nur
Darstellungen bei Vertikalfrequenzen ab 70 Hz (ohne
Zeilen<^rung) verwendet werden.
NOTICE
This notice is applicable for USA/Canada only.
If shipped to USA/Canada, install only a UL LISTED/CSA
LABELLED power supply cord meeting the following
specifications:
SPECIFICATIONS
Plug Type Nema-Plug 5-15p
Cord Type SVT or SJT, minimum 3x18
AWG
Length Maximum 15 feet
Rating Minimum 7 A, 125 V
For the customers in Canada
This apparatus complies with the Class B limits for radio noise
emissions set out in Radio Interference Regulations.
Pour les utilisateurs au Canada
Cet appareil est conforme aux normes Classe B pour bruits
radioélectriques, spécifiés dans le Règlement sur le brouillage
radioélectrique.
INFORMATION
This product complies with Swedish National Council for Metrology
(MPR) standards issued in December 1990 (MPRII) for very low
frequency (VLF) and extremely low frequency (ELF).
INFORMATION
Ce produit est conforme aux normes du Swedish National Council
for Metrology de décembre 1990 (MPR II) en ce qui concerne les
fréquences très basses (VLF) et extrêmement basses (ELF).
Hinweis
Dieses Gerät erfüllt bezüglich tieffrequenter (very low frequency)
und tiefstfrequenter (extremely low frequency) Strahlung die
Vorschriften des .Swedish National Council for Metrology (MPR)*
vom Dezember 1990 (MPR II).
INFORMACIÓN
Este producto cumple las normas del Consejo Nacional Sueco para
Metrología (MPR) emitidas en diciembre de 1990 (MPR II) para
frecuencias muy bajas (VLF) y frecuencias extremadamente bajas
(ELF).
NOTICE
Cette notice s'applique aux Etats-Unis et au Canada
uniquement.
Si cet appareil est exporté aux Etats-Unis ou au Canada, utiliser
le cordon d'alimentation portant la mention UL LISTED/CSA
LABELLED et remplissant les conditions suivantes:
SPECIFICATIONS
Type de fiche Fiche Nema 5-15 broches
Cordon Type SVT ou SJT, minimum 3x18
AWG
Longueur Maximum 15 pieds
Tension Minimum 7 A, 125 V
This monitor is Enet^ Star
Compliant when used with a
computer equipped with VESA
Display Power Management
Signaling (DPMS). The Energy Star
fr« poiunioM raeviNTii
emblem does not represent EPA
endorsement of any product or
service.
—
Table of Contents
A
Introduction
Precautions...............................................................................3
Getting Started.......................................................................... 4
Using Your Monitor
Preset and User Modes........................................................... 4
Adjustments..............................................................................5
Normal Operation Mode..........................................................5
Adjustment Mode
..............................................................................
...................................................................
...................................................................
Introduction
Congratulations on your purchase of a Sony Multiscan ISsff
17sfl
This monitor incorporates over 25 years of Sony experience
with Trinitron display technology, ensuring excellent
performance and outstanding reliability. The Multiscan 15sV
17sfs wide scan range (31.5-64 kHz), together with Digital
Multiscan Technology, allow it to sync to any video mode
from standard VGA through 1024 x 768 at 76 Hz (1280 x
1024 at 60 Hz). In addition, its two factory preset color
3
4
5
Entering New Timings...............................................................6
Power Saving Function
Specifications
Use of the Tilt-Swivel.................................................................7
Troubleshooting........................................................................8
...........................................................................
.............................................................
7
7
J
modes and one user adjustable color mode gives you
unprecedented flexibility in matching on-screen colors to
hard copy printouts. Furthermore, the Multiscan 15sf/17sf
features digital controls, raster rotation, power saving, low
emissions, and much more. All together, it delivers
incredible nerformance with the quality and support you can
expect froin a Sony.
Precautions
Installation
Prevent internal heat build-up by allowing adequate air
circuiation. Do not place the unit on surfaces (rugs,
biankets, etc.) or near materials (curtains, draperies) that
may block the ventilation holes.
Do not instedi the unit near heat sources such as radiators
or air ducts, nor in a place subject to direct sunlight,
excessive dust, mechanical vibration or shock.
Do not place the unit near equipment which generates
magnetism, such as a converter or high voitage power
iines.
Maintenance
Ciean the cabinet, glass panel and controls with a soft cloth
lightly moistened with a miid detergent solution. Do not use
any type of abrasive pad, scouring powder or solvent, such
as alcohol or benzine.
Warning on Power Connection
• Use the supplied power cord.
For the customers in U.S.A.
If you do not do this, this monitor will not conform to
mandatory FCC standards.
for too to 120 VAC
Before disconnecting the power cord, wait for at ieast
30 seconds after turning off the power switch to allow for
the discharging of static electricity on the CRT display
surface.
After the power has been turned on, the CRT is
demagnetized for approximately 5 seconds. This
generates a strong magnetic field around the bezel which
may affect the data stored on magnetic tape or disks near
the bezel. Place such magnetic recording equipment and
tapes/disks at a distance from this unit.
for 220 to 240 VAC
The socket-outlet shall be installed near the equipment
and shall be easily accessible.
________________________
Getting Started
Before using this monitor, piease make sure that the
foilowing items are inciuded in your package: Multiscan
15sf/17sf monitor (1), power cord (1), warranty card (1) and
this operating instruction manual (1).
This monitor will sync with any IBM or compatible system
equipped with VGA or greater graphics capability. Although
this monitor will sync to other platforms running at horizontal
frequencies between 31.5 and 64 kHz, including Macintosh
and Power Macintosh system, a cable adapter is required.
Piease consult your dealer for advice on which adapter is
suitable for your needs.
Step 1: With the monitor switched off, attach the power
cord to the monitor and the other end to a power
outlet.
step 2: With the computer switched off, attach the video
signal cable to the video output.
IBM or compatible computer
to video output
Apple computer
1i
101
J
000(=>
Step 3: Turn on the monitor and computer.
Step 4: If necessary, adjust the user controls according
The installation of your Multiscan 1Ssf/17sf is complete.
Enjoy your monitor.
Jlil
to your personal preference.
{
to video
Using Your Monitor
Preset and User Modes
The Multiscan 15sf/17sf has factoiy preset modes for the 6
most popular industry standards for true ‘^lug and play”
capability.
NO. Resolution (dots x lines)
1
640x480 31.5 kHz 60 Hz VGA Graphic "
2
800x600 46.9 kHz
3 832x624 49.7 kHz 75 Hz Macintosh 16” Color»
4
1024x768
1024x768 60.0 kHz 75 Hz VESA»
5
6 1280x1024
Note: For Windows 3.x users, check your video board
manual or the utility program which comes with your
graphic board and select the highest available refresh
rate to maximize monitor performance.
Horizontal Frequency Vertical Frequency Graphics Mode
48.4 kHz 60 Hz VESA»
64.0 kHz 60 Hz STD CAD/CAM
For less common modes, the Multiscan 15sf/17sfs Digital
Multiset Technology will perform all of the complex
adjustments necessary to ensure a high quality picture for
any timing between 31.5 and 64 kHz.
75 Hz
1) VGA is a trademark of IBM Corporation.
2) VESA is a trademark of the non-profit organization. Video
Electronics Standard Association.
3) Macintosh is a trademark of Apple Computer Inc.
VESA»
Recommended horizontal timing conditiona
Horizontal sync width should be: >1.0 psec.
Horizontal blanking width should be: >3.0 psec.
Adjustments
A number of digital controls are provided to allow you to
optimize the display parameters to your preferences.
Control Panel
odD o(ZD
Normal Operation Mode
Brightness__________________________
GO
-ft CO o co-jCi-
CO)
Adjustment Mode
When the limit value is reached, the POWER SAVING
indicator will begin to flash.
Adjustments will be stored automatically.
<1- ( <■ 1 o t i o o
Contrast
Cd)
POWER
8AVM0
3
o
3
■ Select one of the 4 function buttons (CENTER, SIZE,
GEOM, COLOR) and adjust as described below.
■ The monitor will return to the normal operation mode
after 20 seconds.
Centering______________________________________
CENTER
CO
©COO CO®
CSD
You may return immediately to normal operation mode
by pressing the illuminated function button a second
time.
Size
Press
SIZE
_ CO
___ __ __ __ __
■O’CO o co$ZB
CO
Geometry
Color Temperature
Press \1/
«-CZD
'I
GEOM
Pincushion (Bowing of the sides)
o ; O C
Raster Rotation
Resetting
Press the RESET button to recall the
factory settings for brightness, contrast,
horizontal etnd vertical size, center and
pincushion for the mode currently in
use.
Press and hold the RESET button for 2
seconds to recall factory setting for all
adjustments in all modes.
o
CSD
CU
DO
Press
COLOR
Preset color temperature
cxj
O ( ^^ 9300K
(Reddish)'——“^ ^ (Bluish)
CID
Monitor is initially set to 9300K.
User adjustable color temperature
9300K
OD
o (
)
SOOOK
You can choose between the two factory preset color
temperatures or adjust the color temperature to your
preferences within a range of 5(X)0 K - 93(X) K.
Your most recent adjusted color temperature will be recalled
by pressing o or o button.
Entering New Timings
When using a video mode that is not one of the 6 factory
preset modes, some fine tuning may be required to optimize
the display to your preferences. Simply adjust the monitor
according to the preceding adjustment instructions. The
adjustments will be stored automatically and recalled
whenever that mode is used.
A total of 10 user-defined modes can be stored in memory.
If an 11th mode is entered, it will reolace the first.
Loading...