Multiscan® Color Computer Display
CPD-1304S
Operating Instructions page 2
Mode d’emploi page 16
Owner’s Record
The model and serial numbers are located at the rear of the unit. Record
the serial number in the space provided below. Refer to these numbers
whenever you call upon your dealer regarding this product.
Model No. CPD-1304S Serial No.-
Multiscan
WARNING
To prevent fire or shock hazard, do not expose the unit
to rain or moisture.
Dangerousiy high voitage is present inside the unit. Do
not open the cabinet. Refer servicing to quaiified
personnel only.
NOTE; This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful
interference in a residential installation, This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
— Reorient or relocate the receiving antenna.
— Increase the separation between the equipment and receiver.
— Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
— Consult the dealer or an experienced radio/TV technician for help.
You are cautioned that any changes or modifications not expressly
approved in this manual could void your authority to operate this
equipment.
For the customers in Canada
This apparatus complies with the Class B limits for radio noise
emissions set out in Radio Interference Regulations.
Trademark, registered or otherwise, used in this manual are:
IBM, IBM PS/2, VGA — International Business Machines Corporation,
The CPD-1304S is a high resolution computer display designed for use
with microcomputers, or computers having analog RGB output.
Features
Super Fine Pitch Trinitron computer display with an anti-glare dark
screen.
RGB terminal which allows equipment with analog RGB output to be
connected.
Compatible with the PS/2 microcomputers using VGA,
Muttiscan capacity which makes it compatible with a variety of
computer graphics standards.
Table of Contents
Precautions
Precautions......................................................................................................5
Location and Function ot Controls
Connections.....................................................................................................8
Use of the Tilt-Swivel.......................................................................................9
Specifications...................................................................................................10
Timing Chart....................................................................................................11
Appendix..........................................................................................................14
..................................................................
6
On safety
• Operate the unit only at 100 to 120V AC, 50-60 Hz.
• Should any liquid or solid object tall into the cabinet, unplug the unit and
have it checked by qualified personnel before operating it any further.
• Unplug the unit from the wall outlet if it is not to be used for several
days.
• To disconnect the AC power cord, pull it out by the plug. Never pull the
cord itself.
On instattation
• Allow adequate air circulation to prevent internal heat build-up.
Do not place the unit on surfaces (rugs, blankets, etc.) or near materials
(curtains, draperies) that may block the ventilation holes.
• Do not install the unit in a location near heat sources such as radiators
or air ducts, or in places subject to direct sunlight, excessive dust,
mechanical vibration or shock.
On cleaning
To keep the unit looking brand-new, periodically clean it with a soft cloth.
Stubborn stains may be removed with a cloth lightly dampened with a mild
detergent solution. Never use strong solvents such as thinner or benzine,
or abrasive cleansers since these will damage the cabinet. As a safety
precaution, unplug the unit before cleaning it.
On repacking
Do not throw away the carton and packing materials. They make an ideal
container in which to transport the unit. When shipping the unit to another
location, repack it as illustrated on the carton.
If you'have any questions about this unit, contact your authorized Sony
dealer.
Location and Function of Controls
[T] POWER switch and indicator
To turn on the power of the unit, press this switch. The indicator will
light up. To turn off the unit, press it again.
[I] CONTRAST control (O)
Turn clockwise to increase contrast, or counterclockwise to decrease
contrast,
[3] BRIGHTNESS control (o)
Turn clockwise for a brighter display, or turn counterclockwise for a
darker display.
AC IN connector
Connect to an AC outlet with the supplied AC power cord.
To obtain the same horizontal and vertical sizes of 48 kHz or 57 kHz frequency
with those of VGA mode
Adjust the H SIZE and V SIZE while receiving 48 kHz or 57 kHz to the same sizes with
that ot VGA mode, and set the AUTO SIZE switch to LOCK i1 it is set to ADJ,
When the display receives the 48 kHz or 57 kHz frequency the next time, the horizontal
and vertical sizes become the same as those of VGA mode,
6
[g AUTO SIZE switch
Depending on the microcomputer connected to the display, set this
switch to the appropriate position.
LOCK: For the IBM PS/2 microcomputer using the VGA mode.
When this switch is set to LOCK, the timing is automatically
adjusted to the VGA mode, and the H SIZE, H SHIFT, V SIZE
and V CENT controls will have no effect.
ADJ: For other microcomputers having analog RGB output.
When this switch is set to ADJ. adjust the display with the H
■ SIZE. H SHIFT, V SIZE and V CENT controls.
• To adjust the horizontal frequencies of less than 40 kHz, set the
AUTO SIZE switch to ADJ.
• To adjust the horizontal frequencies of 40 kHz or more, set the
AUTO SIZE switch to either LOCK or ADJ.
11] H SIZE (horizontal size) control
Turn this control to adjust the horizontal size of the display.
Ul H SHIFT (horizontal shift) control
Turn this control to adjust the center of the display horizontally.
[il V CENT (vertical center) control
Turn this control to adjust the center of the display vertically.
H V SIZE (vertical size) control
Turn this control to adjust the vertical size of the display.
Connections
Use of the Tilt-Swivel
Connect the power cord and the color monitor cable.
Be sure to turn the power of the unit off before making the connection.
Rear ol the CPD-1304S
RGB Input Pin Assignment
66660
p O O O O
00000
1 2
R
10
GND GND
3 4 5 6 7
G B GND FLG GND GND
11
12
-
14 15
13
H SYNC VSYNC
-
8 9
GND
With the tilt-swivel, this unit can be adjusted to be viewed at your destred
angle within 90" horizontally and 13° vertically.
To turn the unit horizontally, hold it at its bottom with both hands as
illustrated below.
-
Specifications
Timing Chart
Super Fine Pitch Trinitron color tube
14-inch picture tube measured diagonally
90 degrees deflection
Anti-glare dark screen
Faceplate; non glare
Conductive Silica Coating
Phosphor P22
Viewable pixels
Scanning frequency
Video input signal
Sync input
Power requirements
Dimensions
Weight
Supplied accessory
Design and specifications subject to change without notice.
0.25 mm Aperture Grille Pitch
1024 X 768
Vertical sync signal frequency:
55-110 Hz
Horizontal sync signal frequency;
28 - 57 kHz
Analog RGB positive
0.714 Vp-p/75i2 terminated
Video band width: 60 MHz ±3 dB
TTL level. Polarity free.
Composite sync is acceptable at Pin # 13.
Sync on green is acceptable.
100-120 V AC. Max. 1.8 A, 50-60 Hz
355(H) X 348(W) X 411 (D) mm
(14 X 13^/4 X 16’/4 inches)
Approx. 13.1 kg (30 lb 14 oz)
Including the tilt-swivel
AC power cord (1)
The following timing chart shows approximate values.
MONITOR ACCEPTABLE TIMING EXAMPLE
U
BACKPORCH(B.P)"
H] VGA
FREQ.
H
V
SYNC
POLARIPr
CLOCK FREQ.
H (kHz)
PERIOD (mS)
SYNC
B.P
ACTIVE 25.42
PERIOD (H)
SYNC
B.P 34
ACTIVE 400
H NEGA
V
V (Hz)
POSI NEGA
(MHz)
1
31.47 31.47 31.47
70.1 70.1 59.9
31.78
3.81
1.91
449
2
POSI NEGA
25.175
r
2 3
449
350 480
25.175 25.175
2 •2
59
NEGA
525
32
10
11
Timing Chart
[2] 1024 X 768 interace (fh = 35.52 kHz/fv = 87 Hz)
FREQ.
H
V PERIOD (H)
SYNC POLARITY
CLOCK FREQ.
[D. (U: When the AUTO SIZE switch is in the LOCK position, picture size
is automatically adjusted for the above listed video modes ([]],
{2}).
All sizing controls on the left side of the monitor are therefore
ineffective.
To adjust sizing for other video modes, change the switch to ADJ
and adjust the controls.
Polarity free with the timing [i], [J] If the AUTO SIZE switch is not
used.
ID 35 kHz
non-interace (example)
800 X 600
FREQ. H (kHz)
H PERIOD (mS) 28.44
V
CLOCK FREQ.
H (kHz)
V (Hz) 87.0
PERIOD (mS)
SYNC 3.92
B.P 1.25
ACTIVE 22.81
SYNC
B.P
ACTIVE
H
V
(MHz) 44.900
V (Hz)
SYNC
B.P
DISPLAY
PERIOD (H)
SYNC
B.P
ACTIVE
35.52
28.15
408.5
20/20.5
384
POSI
POSI
35.16
56.0
3.11
2.67
22.22
628
(MHz) 36.000
600
4
14
7
И 48 kHz non-interace (example)
FREQ, H (kHz)
H
V
CLOCK FREQ.
PERIOD (mS) 20.500
SYNC
B.P
DISPLAY
PERIOD (H)
SYNC
B.P
ACTIVE
[g, S: SYNC POLARITY FREE
О 57 kHz
non-interace
FREQ.
H
V
SYNC
POLARITY
CLOCK FREQ. (MHz)
PERIOD (nS) 17.707
SYNC 1.813
B.P 1,920
ACTIVE
PERIOD (H)
SYNC
BP
ACTIVE
H
V
48-780
V (Hz)
16,000
(MHz) 64.000
H (kHz)
56.476
V (Hz) 70.069
13,653
NEGA
NEGA
75 000
60.00
1.500
2.000
813
768
806
768
3
39
6
29
12
13
Appendix
Sony TriniUon System
Sony used its skilled research and development teams to create the first
Trinitron TV, introduced 20 years ago. Some 40 million Trinitrons have
been sold worldwide so tar, and Sony won the Emmy Award tor technical
quality in 1977, Its Super Fine Pitch (the narrowest dot pitch in the industry
for each CRT size class) provides images that are just as sharp and clear
as prints, making it most suitable for computer graphics, not to mention TV
broadcasts.
Features
Clear, crisp, and easy-to-read screen
Trinitron's black screen increases the contrast by 50 percent, and its 1-
gun, 3-beam system with one large lens allows more precise color beam
focusing. Thus colors are reproduced more distinctly. Higher contrast aiso
recreates computer graphics and characters that are crisp, clear, and easy
to read.
Display with less glare and distortion
Only Trinitron incorporates a cylindrical screen with a completely straight,
vertically flat surface.
The cylindrical screen delivers a clear undistorfed picture, and also
eliminates ambient light reflection, for long viewing without fatigue.
Brighter picture and more accurate colors
Sony's exclusive Aperture Grille with long and unbroken slits delivers more
color and brightness to the screen.
The result is a brighter and more beautiful picture.
This Grille is stabilized with a damper wire. When viewing images with
light backgrounds, this wire is sometimes visible as a fine iine.
14
15
Loading...