Sony AD-7590A, AD-7591S, AD-5590S, AD-7590S, AD-7593A User Manual

...

Instructions

1 Front Panel

This panel prevents dust from entering the DVD Writer and opens automatically only a little when the Eject button is pushed.

2 Busy Indicator

This indicator lights during data read and write operation.

3 Eject Button

This button is pressed to open the disc tray/eject the disc when the power is on.

4 Emergency Eject Hole*

Use to remove the disc from the DVD Writer if the electrical eject is disabled by software or if power failure occurs. (see „Emergency Eject“

for details)

Front View AD-5590, AD-759x

Internal ATAPI Drive Slimline DVD Writer

Names and Functions

3 4

English

CLASS 1 LASER PRODUCT

LASER KLASSE 1

LUOKAN 1 LASERLAITE

KLASS 1 LASERAPPARAT

Laser Safety Information

This drive employs a laser. Do not remove the cover or attempt to service this device when connected due to the possibility of eye damage.

CAUTION

The use of controls or adjustments or performance of procedures other than those specified herein may result in hazardous radiation exposure.

Laser Specification:

Semiconductor Laser: 330mW, 785nm; 280mW, 661nm

Disposal of Old Electrical & Electronic Equipment

(Applicable in the EU and other European countries with separate collection systems)

This symbol on the product or on its packaging indicates that this product shall not be treated as household waste. Instead it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment. By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product. The recycling of materials will help to conserve natural resources. For more detailed information about recycling of this product, please contact your local

Civic Office, your household waste disposal service or the shop where you purchased the product.

Front View AD-763xA, AD-767xS (slot-in)

Instructions

3. Connect the intended plug

with the socket on the back of the Slimline DVD Writer.

4. Slide the Slimline DVD Writer

into the computer and fix it in the computer cabinet with 4 screws.

To avoid damage to the DVD Writer take care that the screws do not reach more than 1.5 mm into the Optiarc Writers cabinet.

5. Reassemble the computer and

close the housing cover. Refer to the operation gudie that came with the computer for help with this step.

Drive usage

Inserting a Disc

1. Press the Eject button. The disc

tray will be ejected by about 10mm.

2. Pull the disc tray all the way

open by hand.

3. Set the disc into the shaft in

the centre of the tray with the label side facing up.

4. Press the disc tray into the

DVD Writer calmly by hand.

Removing a Disc

1. Press the Eject button. The disc

tray will be ejected by about 10mm.

2. Pull the disc tray all the way

open by hand.

3. Lift the edge of the disc

strongly, pressing the shaft in the centre of the tray.

4. Press the disc tray into the

DVD Writer drive calmly by hand.

Note: If an eject prohibit

command has been received from the computer, the disc tray will not be ejected even if the Eject button is pressed.

5 Connector

This Connector includes Power and I/O BUS.

Installation

Configuration

The drive configures itself independently through the connector.

Note: Not all computer hardware

supports the intended automatic configuration. Usually this causes that after the drive assembled the computer does not boot any longer. In such case the drives firmware must by changed by qualified personnel.

Installing in a host computer

While installing a slimline drive, you have to consider that it’s dimension and connector are designed for usage in portable computer and are standardized. If the Slimline drive is not target for a standard slimline system, additional adapters must be procured from an appropriate expert trader.

1. Turn off the computer, other

peripherals and unplug all the cords and cables. Then remove the computer cover, face plate, mounting clips, and keeper bracket. Refer to the operation gudie that came with your computer for help with this step.

2. Slide the Slimline DVD Writer

into the computer in such a way that you are able to connect the intended plug.

Rear View

+ 2 hidden pages