Sonoro Cubo, AU-1300 Instruction Manual

Instruction Manual

sonoro audio GmbH & Co. KG

Unter Goldschmied 6
50667 Köln
Germany
fon +49 221 - 16 79 29 - 0
fax +49 221 - 16 79 29 - 290
[e-mail]
www.sonoro-audio.com

05/09

The manufacturer continuously works on the further development of all types and models.
We ask for your understanding that changes of the scope of delivery in regard to form, components and technology are
therefore possible at any time. The information, illustrations and descriptions in this manual therefore shall not
constitute an entitlement to any claims.
Replication, copying or translation, even in parts, is not permitted without the written consent of the manufacturers.
The manufacturer explicitly reserves all rights pursuant to the law governing the copyright.
Subject to changes.

4

Safety Instructions

Place the cubo design cd-radio on a rm, level surface.

Make sure that

the cd-radio is not covered, so as to ensure there is always an adequate circulation of air;•
there are no direct sources of heat (e.g. radiators) radiating onto the product;•
the cd-radio is not subjected to direct sunlight;•
contact with moisture, water or spray is avoided (e.g., never place a ower vase on •
the cd-radio);
the cd-radio does not stand in the vicinity of magnetic elds – e.g., close to televisions •
or loudspeakers;
no naked ames (e.g., burning candles) are permitted to stand either on or near •
the product.

Never allow children to use electrical products unless under supervision. Also keep the
packaging away from children as the foil can cause suffocation.
Only connect the cd-radio to a 230 V ~ 50 Hz socket which is within easy reach of where the
product is placed, in case it is necessary to remove the cd-radio from the power supply in a hurry.

Never attempt to repair it yourself

On observing that the cd-radio or its power lead is damaged, you should
immediately pull the plug out of the power supply socket. In no circumstances
should you try to open the product, or repair it yourself. There is grave danger
of electric shock. In case of a technical issue, you should refer to our Service

Centre or to another suitably-qualied specialist workshop.

The CD player

The CD Player is a Class 1 laser product. The device is tted with a safety system,

which eliminates dangerous laser emissions during normal usage. To avoid any
eye injury, do not attempt to open or damage the laser safety device.

Cleaning and care of your cubo cd-radio

Before cleaning the cd-radio, please pull the plug out of the power supply socket. For cleaning,
use a soft, dry cloth. The use of chemical solvents and cleaners should be avoided, as these are
likely to damage the surface and / or the lettering. If you are not expecting to use the cd-radio for
The CD Player is a Class 1 laser product. The device is tted with a safety system, which elimi­nates dangerous laser emissions during normal usage. To avoid any eye injury, do not attempt to
open or damage the laser safety device. Sometimes it is advisable to unplug it from the socket.

LASER KLASSE 1
CLASS 1 LASER
PRODUCT
APPAREIL LASER
DE CATEGORIE 1

5

English

1 Tuning station search +/-

2 CD slot

3 Mode operating mode

4 Menu settings

5 Skip Reverse

6 Pause CD pause

7 Play CD playback

Controls

8 Stop CD playback stop

9 Skip Forward

10 Open eject CD

11 Power switch cd-radio into

standby mode

12 Volume volume control +/-

1 2 3 4 5

6

7

8

9

10 11 12

6

16 17 18

For radio mode

13, 14, 15 Preset radio station buttons

For CD mode

14 -10 Skip 10 tracks forward

15 +10 Skip 10 tracks back

16 Alarm 1

17 Snooze

18 Alarm 2

19 Headphone connector

20 AUX-IN connector

21 Security-lock connector

22 FM antenna VHF antenna

23 EXT/INT antenna selector (external/internal)

24 Power supply connector

25 Battery compartment

13 14 15

19 20 232221 24 25

Controls