Sonance Ellipse 1.0 LCR, Ellipse 2.0 LCR, Ellipse Surround, Ellipse Series User Manual

Sonance • 212 Avenida Fabricante • San Clemente, CA 92672-7531, USA • [phone] or [phone] • FAX: [phone] • Technical Support: [phone]

INTRODUCTION

This enclosure is specifically designed for use with the
Ellipse Series of speakers

INSTALLATION INSTRUCTIONS

1. Determine the proper location for the
speaker opening.

2. Attach the box to the joist bay using four wood
screws.(Not Included)

3. Drill a quarter inch hole for the speaker wire.

4. Route the speaker wire into the enclosure
through the hole you just drilled and tie a knot
on the inside to secure it.

5. Seal the hole with the supplied mortite adhesive
to make the box air tight.

RECOMMENDED PLACEMENT

Proper placement of the Ellipse is critical for maximum
performance. Try to apply as many of the following
recommendations in your installation.

The speakers should be located from eight to eighteen
feet from the listener. The minimum recommended
spacing from speaker to listening position would be
approximately 6 feet in a room with eight foot ceilings.
The height and size of the television will largely
determine this distance. Keep in mind that if the
television is placed at eye level and the speakers are
installed less than six feet in front of the listening
position the picture and sound could seem very
disconnected.

If possible the speakers should be located a minimum
of three to four feet from the front wall this is the wall
the television is on.

The left and right speakers should be separated
approximately eight to twelve feet apart with the
center speaker placed as close to the middle as possible.

ACOUSTIC ENCLOSURE
INSTALLATION INSTRUCTIONS

SONANCE ELLIPSE SPEAKER SYSTEM

PN.33-2650 03.03

Left Center Right Speaker Placement

TV

8 to 12 feet

8 to 18 feet

3 to 4 feet

DIMENSIONS: 14” x 15-1/4” x 6” (W X H X D)

8 to 18 feet

TV