SOMFY RS485 Setting Tool Installation Manual

1Copyright © 2013 Somfy SAS. All rights reserved - V0 - 02/2013

RS485 SETTING TOOL

Ref. 5101887A

EN

Installation guide

2 Copyright © 2013 Somfy SAS. All rights reserved - V0 - 02/2013

CONTENTS

1. Introduction 2

2. Safety 2

3. Description & Installation 3

3.1. Description

3.2. Battery installation

4. Wiring 5

4.1. Connect the RS485 setting tool to
the RS485 product

5. Commissioning 5

5.1.Switch on the RS485 SETTING
TOOL

5.2. Somfy RS485 Node discovery
section

5.3. Setting tool parameters section

6. Tips & recommendations 9

7. Technical data 9

2. SAFETY

• This Somfy product must be installed by a professional motorisation and home
automation installer, for whom these instructions are intended.

• Before installation, check that this product is compatible with the associated equip­ment and accessories.

• These instructions describe how to install, commission and use this product.

• Moreover, the installer must comply with current standards and legislation in the

country in which the product is being installed, and inform his customers of the
operating and maintenance conditions for the product.

• AnyuseoutsidethesphereofapplicationspeciedbySomfyisnotapproved.Such

use, or any failure to comply with the instructions given herein will invalidate the
warranty, and Somfy refuses to accept liability.

Subjecttotechnicalmodications.

1. INTRODUCTION

The RS485 SETTING TOOL is a smart digital system which enables the setting of
SOMFY RS485 products (Somfy RS485 motors and interfaces).

This was designed to ease the integration and settings for OEMs & façade makers,
but also to ease the installation and/or maintenance for installers thanks to fast
connection and intuitive tool thanks to its display.

Moreover,itsrmwarecanbeeasilyupdatedtoallowtohavethelatestcompatibility

version in hands.

3Copyright © 2013 Somfy SAS. All rights reserved - V0 - 02/2013

3. DESCRIPTION & BATTERY INSTALLATION

1

2

3

4

5

BACK

OPEN

STOP

CLOSE

OK

LIGHT

a: Ground e: Not used

b: Ground f: Not used

c: Not used g: RS485 -

d: Not used h: RS485 +

1: Navigation buttons 4: Battery compartment

2: Control buttons 5: On/Off

3: Backlight button 6: RJ45 socket

3.1. description

a b c d e f g h

6