Soleus Air SG-DEH-PEX User Manual

THE DEHUMIDIFIER

PUMP IS LOCATED

INSIDE THE

DEHUMIDIFIER

BUCKET WHEN

UNPACKING

SG-DEH-PEX

Vertical Dehumidifier Pump

Operating Instructions

The actual pump design may differ from the image on manual.

Operating Instructions

Please read and save these instructions. Read carefully before attempting to assemble, install, operate or
maintain the product described in this manual. Protect yourself and others by observing all safety
information. Failure to comply with instructions may result in personal injury and/or property damage.
Retain instructions for future reference.

Dehumidifier Pump Kit Instructions

The included vertical pump is used to pump water from the dehumidifier to sump kit, utility sink, floor
drain or through a window.

This pump is to be used only to drain dehumidifiers. It is not submersible and is for indoor use only.

For use with all Soleus Air Powered by Gree Dehumidifiers.

3M (9.75’)

1M (3.25’)

Dehumidifier Pump

2

General Safety Information

Carefully read and follow all safety instructions in this manual and on the included pump. Keep

safety labels in good condition. Replace missing or damaged safety labels if possible.

This product contains chemicals known to the state of California to cause cancer
and birth defects or other reproductive harm.

Risk of electric shock. This pump has not been tested for use in swimming pool
areas.

Meets United States National Electrical Code and local codes for wiring.

Do not handle a pump or pump motor with wet hands or when standing on a wet or damp surface
or in water.

Do not use the pump near flammable or explosive fluids such as gasoline, fuel oil, kerosene,
etc. Do not use in flammable and /or explosive atmospheres.

All electrical wiring or service should be done by a qualified electrician.

Install all electrical equipment in protected area to prevent moisture damage to
components.

Protect power cable from crimps or cuts from sharp objects. Do not allow the
cord to come into contact with oil, grease, hot surfaces or chemicals.

3

SPECIFICATIONS

UL and cUL Listed
Motor Rating:115 V AC , 0.12amps, 10 watts
Thermally Protected

Tank Capacity:
Weight:

Dimensions:

TOOLS NEEDED

Phillips Head Screwdriver

PARTS SUPPLIED

(1) Drain Pump
(2) 3M (9.75') Pump Drain Hose
(3) 1M (3.25') Dehumidifier Drain Hose
(4) Dr
(5) Hose Cl
(6) Hose Clamp
(7) Screw

2.5lbs (1.15 kg)

ainage Joint

0.6 L

4.75" x 3.75" x 7.125" (125mm×96mm×181mm)

amp

Pump Drain Hose Pump Drain Hose Drainage Joint

Small Hose Clamp Large Hose Clamp Screws

Drain Pump



4

Unpacking

When unpacking the unit ,inspect carefully for any damage that may have occurred during transit.

IMPORTANT PRECAUTIONS
ELECTRICAL SUPPLY

The motor voltage and phase indicated on the motor product label should be checked against the actual
electrical supply. Check your power source. Check electrical supply for correct fusing ,wire size, and
adequate grounding and transformer size.

Location Requirements

Risk of electric shock – This pump is supplied with a grounding
conductor and grounding-type attachment plug. To reduce the risk
of electric shock, be certain that it is connected only to a properly grounded, grounding-type
receptacle.

1. Plug pump into a grounded electrical outlet.

2. Water drains from the dehumidifier tank to the pump.
The pump will automatically start and pump water to the drain or out of a window.

3. Make sure water is being pumped to the drain.

4. Check for leaks.

Prohibit operating the dehumidifier pump when there’s no body nearby for a long time.
Observe whether it operates normally for a period of time (for example: 24h or 36h). If it’s
abnormal, unplug the power immediately and contact customer service.

Risk of electric shock. Do not place in water. Disconnect power before cleanings. Failure to follow these
instructions can result in death or electrical shock.

Electrical Requirements

Volts:115 AC only ,60HZ

5

Installation Instructions

Using the diagrams below to connect the pump hose to the dehumidifier. After installation, please ensure
the bucket is correctly placed in the dehumidifier. The bucket must be in place for proper operation.

Step 1: Remove the dehumidifier Bucket Step 2: Open the Drainage door on the side

of the dehumidifier

Step 3: Secure the drainage joint onto the
continuous drainage connector

Step 5: Make sure the drain hose is securely
connected to the drainage joint by pushing
the large hose clamp towards the drainage
joint.

Step 4: Place the large 1M hose clamp
onto the drain hose and attach to the
drainage joint on the dehumidifier.

Step 6: Re-insert the bucket into the
dehumidifier for operation.

6