Socket Mobile BM56S Manual revised

Socket Bluetooth 56K Modem

User’s Guide

BM56S

M73-APO02-550

Declaration of conformity

This equipment conforms to the Directive 1995/5/EC (R&TTE Directive)
and is qualified for bearing the CE Marking.

Standard:
EN301 489-17 ,
EN301-489-1,
EN300382-1,
EN300382-2,
EN60950

Important Safety Instructions

Before using your telephone equipment, basic safety precautions should
always be followed to reduce the risk of fire, electric shock and injury to
persons, including the following:

1. Read and understand all instructions.

2. Follow all warnings and instructions marked on the product.

3. Unplug this product from the telephone jack and the power outlet before
cleaning. Do not use liquid or aerosol cleaners. Use a damp cloth for
cleaning.

4. Do not use this product near water, such as near a bathtub, sink, laundry
tub, in a wet basement, or near a swimming pool.

5. Do not place this product on an unstable cart, stand, or table. Serious
damage may result if the product falls.

6. Slots or openings in the cabinet and the back and bottom are provided
for ventilation to protect the phone from overheating. These openings
must not be blocked or covered. The product should never be placed
near or over a radiator or heat register.

7. This product should be operated only from the type of power source
indicated on the marking label.

8. Do not allow anything to rest on the power cord. Do not locate this
product where the cord will be abused by persons walking on it. Do not
attach the power cord to building surfaces.

9. do not overload wall outlets and extension cords as this can result in the
risk of fire or electric shock.

10. never push any objects into this product through cabinet slots as they
may touch dangerous voltage points or short out parts that could result in
a fire or electric shock. Never spill liquid of any kind on the product.

11. if this product does not operate normally, see the “In Case of Difficulty”
section in this owner’s manual. If you cannot resolve the problem, or if
the product is damaged, refer to the “Umited Warranty” section of this
owner’s manual. Opening the product or reassembling it incorrectly may
expose you to dangerous voltages or other risks, and will void the
warranty.

12. Unplug this product from the wall outlet and refer servicing to qualified
service personnel under the following conditions: (a) When the power
supply cord or plug is damaged or frayed. (b) if liquid has been spilled
into the product. (c) If the product has been exposed to rain or water. (d)
If the product does not operate normally by following the operating
instructions. Adjust only thoser controls that are covered by the
operating instructions. (e) If the product has been dropped or the cabinet
has been damaged. (f) If the product exhibits a distinct change in
performance.

13. Avoid using a telephone during an electrical storm. There may be a
remote risk of electric shock and/or hearing damage from lightning.

14. Do not use the telephone near a gas leak even to report the leak.

FCC Warning

Warning: Changes or modifications to this unit not expressly approved by the
party responsible for compliance could void the user authority to operate the
equipment.

This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference,
and (2) this device must accept any interference received, including interference
that may cause undesired operation.

The users manual or instruction manual for an intentional or unintentional
radiator shall caution the user that changes or modifications not expressly
approved by the party responsible for compliance could void the user’s
authority to operate the equipment.

NOTE: This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more of the
following measures:

o Reorient or relocate the receiving antenna.
o Increase the separation between the equipment and receiver.
o Connect the equipment into an outlet on a circuit different from that to

which the receiver is needed.

o Consult the dealer or an experienced radio/TV technician for help.

CAUTION:

1. The equipment complies with FCC RF radiation exposure limits set forth

for an uncontrolled environment, under 47 CFR 2.1093 paragraph (d)(2).

2. This Transmitter must not be co-located or operating in conjunction with

any other antenna or transmitter

Basic Information

Features

§ Plug & Play

§ DTE rate up to 115,200bps

§ CE, R&TTE approval

§ V.92 Hardware Ready

§ Wireless connection via BluetoothTM radio

transmission between PC host and modem.

§ Complies with Bluetooth SIG specification Rev.

1.0

§ Uses 2.4 GHz ISM frequency band

§ High-speed wireless transmissions, up to 721

Kbps data throughput

§ Connections within ranges up to 32 feet (10

meters)

§ PSTN Telephone Line interface through RJ-11

Requirements

• An analog telephone line with RJ-11 jack

• System with Bluetooth utility and Bluetooth

module pre-installed.

LEDs on the Front Panel

LED Indicators Status
Charger LED Green (Full), Amber (Charge)
Power LED Power ON(Green Flash),

Battery low(Red Flash)

BT LED Blue(Flash),radio side being

present and operating

Off Hook LED Green (ON) off hook