Snapper IR4001B, IR4002B, IR5002B, IR4000B, IR4002T User Manual
Parts Manual fo
r
E
T
INTERMEDIAT
REAR TINE TILLERS
SERIES 0, 1 & 2
MODEL
IR4000B
IR4001B
IR4002
IR4002B
IR5002B
COPYRIGHT ©2006
SNAPPER PRODUCTS, INC.
ALL RIGHTS RESERVED.
Revision 4,
McDonough, GA, 30253 U.S.A.
3/1/2006
Manual No. 7006043
TP 400-5171-4-RT-N
s
PAGE GROUP
4
6
12
14
18
20
22
24
Handle, Controls, Weights
Main Case & Gears
Tiller Head Components
Shift & Drive Components
Wheels, Tires, Rims
Decals
Accessory - Cultivator Shield Kit
Accessory - Hiller-Furrower Kit
Table Of Content
SERIES 0, 1 & 2
Manual No. 7006043INTERMEDIATE
3
TP 400-5171-4-RT-N
Handle, Controls, Weights
Manual No. 7006043 INTERMEDIATE
TP 400-5171-4-RT-N
4
SERIES 0, 1 & 2
Handle, Controls, Weights
p
y
Part No Descri
1 7036169 BAR, Handle
2 7014682 COVER, Cable
3 7032593 CATCH, Bail
4 7018787 BAIL
5 7036170 PANEL, Dash
6 7018921 CONTROL, Throttle (Series 0 & 1)
7 7018808 CABLE, Clutch
8 7015252 SPRING, Tine
9 7038221 SUPPORT, Handle
10A 7036171 BAR, Stand-Up (Briggs & Stratton)
10B 7033131 BAR, Stand-Up (Tecumseh)
11 7032496 2 BRACKET, Weight
12 7038223 7 WEIGHT, Steel
13 7035107 BOX, Weight
14 7090861 4 BOLT, 5/16-18 x 1 3/4" Carriage
15 7090316 2 BOLT, 5/16-18 x 5/8" Carriage Was 90605
7090316 BOLT, 5/16-18 x 3/4" Carriage (IR 50028)
16 7091601 12 LOCKNUT, 5/16-18 Hex Flange Was 90585
17 7090595 BOLT, 5/16-18 x 3/4" Hex Flange Lock
18 7091612 4 BOLT, 5/16-18 x 1 1/2" Carriage Was 90582
19 7090661 BOLT, 5/16-18 x 1" Hex Flange Lock
20 7011791 4 RETAINER, 5/16 Bolt
21 7090831 SCREW, 5/16-18 x 2 3/4" Hex Head Cap
22 7091575 5 LOCKNUT, 5/16-18 Hex Was 90184
23 7091541 2 SCREW, 5/16-18 x 3/4" Self-Tapping Was 90368
24 7091732 SCREW, 1/4-20 x 2 3/4" Hex Head Cap Was 90971
25 7090372 LOCKNUT, 1/4-20 Hex
26 7091540 4 SCREW, 5/16-18 x 1 1/2" Hex Head Cap Was 90211
27 7014681 2 BUSHING
tionItem Qt
Note
Footnotes:
Manual No. 7006043INTERMEDIATE
SERIES 0, 1 & 2
5
TP 400-5171-4-RT-N
Main Case & Gears
Manual No. 7006043 INTERMEDIATE
TP 400-5171-4-RT-N
6
SERIES 0, 1 & 2
Main Case & Gears
p
y
Part No Descri
7059969 CASE ASSM'Y., Complete (Service Kit)
1 7035520 CASE, Left Hand Tiller Was 35094 (Series 0 & 1)
7035220 CASE, Left Hand Tiller (Series 2)
2 7035218 CASE, Right Hand Tiller Was 35095 (Series 0 & 1)
7035218 CASE, Right Hand Tiller (Series 2)
3 7038222 2 REINFORCEMENT, Case
4 7015597 2 * CLAMP, Speedy
5 7015040 * SEAL, Boot Oil
6 7015716 * SEAL, Oil
7 7015598 * SEAL, Cap
8 7028753 GASKET, Main Case Was 16021
9 7015348 SPACER, Main Shaft
7022514 SPACER, Main Shift (IR 5002B)
10 7021977 PIN, Guide
11 7022512 SHAFT, Main Detent
12 7018786 FORK, Primary Shaft
13 7023252 SPRING Was 14500
14 7014469 BALL
15 7015405 CRANK, Shift
16 7015679 GASKET, Shift Arm
17 7015313 PIVOT, Shift Arm
18 7015409 * PLUG, 1/2" Button
19 7015350 2 O-RING
20 7010756 2 BEARING
21 7023849 * SHAFT, Input Was 22054 (Series 0 & 1)
7023849 SHAFT, Input (Series 2)
22 7015982 PINION, Input
23 7015136 2 SEAL, Oil
24 7015319 2 BEARING, Axle
25 7040609 * WELDMENT, Axle Was 40530 (Series 0 & 1)
7040609 WELDMENT, Axle (Series 2)
26 7015347 CHAIN, Traction #40
27 7015318 SPACER, Wheel Shaft
28 7015348 2 SPACER
29 7018790 GEAR & SPROCKET
30 7045127 SHAFT, Gear Was 22367
31 7053662 ** ASSEMBLY, Tine Drive Gear Was 52634
tionItem Qt
Note
Footnotes:
NOTE: * Not Used On Model IR 5002B
NOTE: ** Part # 15339 DX Bearings are included, if purchased separately they must be pressed in.
Manual No. 7006043INTERMEDIATE
SERIES 0, 1 & 2
7
TP 400-5171-4-RT-N
Main Case & Gears
Manual No. 7006043 INTERMEDIATE
TP 400-5171-4-RT-N
8
SERIES 0, 1 & 2
Main Case & Gears
p
y
Part No Descri
32 7054412 ** ASSEMBLY, Wheel Drive Gear Was 51654
33 7015323 SPACER, Reverse
34 7051653 ** ASSEMBLY, Reverse Idler
35 7015342 2 SEAL, Oil
36 7015343 2 O-RING
37 7018869 2 BEARING, Tine Shaft
38 7015315 SPACER, Tine Shaft
39 7041657 * STRUCTURE, Tine Shaft Was 47881 (Series 0 & 1)
7041657 STRUCTURE, Tine Shaft Was 57650 (Series 2)
40 7015346 CHAIN, Tine #40
41 7090244 4 SCREW, 5/16-24 x 1 3/4" Hex Hd. Cap
42 7011791 4 RETAINER, 5/16 Bolt
43 7090188 5 WASHER, 5/16 Flat
44 7090187 4 LOCKWASHER, 5/16 Split
45 7091297 4 NUT, 5/16-24 Hex Was 90223
46 7090053 4 WASHER, 1/4 Int. Tooth Lock
47 7090095 4 NUT, 1/4-20 Hex
48 7073293 4 * FASTENER, Ratchet Was 15404 ('88 Models Only)
49 7090858 27 SCREW, 5/16-18 x 1/2" Self-Tapping
50 7011024 PLUG
51 7090873 6 WASHER, 7/16 Int. Tooth Lock
52 7090460 6 NUT, 7/16-20 Hex
53 7091601 8 LOCKNUT, 5/16-18 Hex Flange Was 90585
54 7090372 14 LOCKNUT, 1/4-20 Hex
55 7090721 33 BOLT, 5/16-18 x 1/2" Hex Flg. Lock
56 7090953 6 SHIM
57 7020938 SHIM
58 7090072 12 SCREW, 1/4-20 x 5/8" Hex Hd. Cap
59 7090952 * SCREW, 1/4-20 x 1/2" Self-Tapping
60 7090290 3 SCREW, 1/4-20 x 3/4" Self-Tapping
61 7090595 5 BOLT, 5/16-18 x 3/4" Hex. Flg. Lock
62 7038647 REINFORCEMENT, R.H. Frame (Series 0 & 1)
7038647 REINFORCEMENT, R.H. Frame (Series 2)
63 7038648 REINFORCEMENT, L.H. Frame 38358 (Series 0 & 1)
7038648 REINFORCEMENT, L.H.Frame (Series 2)
64 7090987 * WASHER, Shim
65 7032845 BRACE, Belt Cover Was 38356 (Series 0 & 1)
7032845 BRACE, Belt Cover (Series 2)
tionItem Qt
Note
Footnotes:
NOTE: * Not Used On Model IR 5002B
NOTE: ** Part # 15339 DX Bearings are included, if purchased separately they must be pressed in.
Manual No. 7006043INTERMEDIATE
SERIES 0, 1 & 2
9
TP 400-5171-4-RT-N
Loading...