Smeg SWT260D-1 Various instructions [GB]

SWT260-SWT262-SW262-SWT264

SHORT INSTRUCTION SHEET

SELECTING THE WASHING PROGRAMME

Switch on the device by pressing the On/Off key (hold down for 2 seconds). Close the door by shutting it against

the appliance until the lock clicks shut. The buttons are only enabled with the door closed.

Use the Selection buttons to select the program. Display show P- number programm

Press the Start/Stop button to start the cycle.
Once the selected program has been successfully completed, the display shows “End”.

The appliance can only work if there is salt in the water softener. The wash program cannot be started if the
indicator light is on.

SUSPEND THE CYCLE

A cycle in progress can be suspended by pressing the Start/Stop button. After the cycle has been interrupted, the
options available vary depending on conditions in the chamber:

1. If the tank temperature is less than 75°C: the door can be opened and the program can be restarted from where
it left off by pressing the Start/Stop button.

2. If the interior temperature is greater than 75°C, you must confirm again to open the door and the machine warns
you of the interior temperature on the display and by beeping.

DOOR OPENING

Press the Door opening button: the appliance gives a beep when it receives the signal. Release the button and the
door will open automatically after a few moments.

RESET PROCEDURE

+

Press the Drain and Start/Stop buttons and hold them down for about 2 seconds, until a beep is heard.
"P-" appears on the display and the RESET procedure starts.

ALARMS

LED

MEANING

When an alarm occurs: Led “Warning” on and display indication.

“AF” – fatal alarm.
“A-“– non fatal alarm. If a non-fatal alarm occurs you can press the Start/Stop button to continue using the device.

When an error occurs, generally the device manages the anomaly itself: in this case the alarm code flashes on the
display until the problem has been dealt with: no reset commands are accepted during this time.
Any RESET forced by the user will not be accepted until the problem has been dealt with and the alarm code on the

display is “steady”.

PROGRAMS – overview:

THIS DOCUMENT

Instruction sheet for basic operations.
For all the details concerning the correct and safe use of the devices in question, for the updated program table, for the
interpretation of alarm messages and for the requirements for installation: refer to the user manual - full version.