Smeg SSA92MAX9 User Manual
Contents
EN
1 Instructions 8
1.1 General safety instructions 8
1.2 Identification plate 9
1.3 Manufacturer liability 9
1.4 Appliance purpose 10
1.5 This user manual 10
1.6 How to read the user manual 10
2 Description 11
2.1 General Description 11
2.2 Cooking hob 12
2.3 Control panel 12
2.4 Other parts 13
2.5 Available accessories 14
3 Use 15
3.1 Instructions 15
3.2 First use 16
3.3 Using the accessories 17
3.4 Using the hob 18
3.5 Using the electric hotplates 19
3.6 Using the storage compartment 19
3.7 Using the oven 20
3.8 Cooking advice 21
4 Cleaning and maintenance 24
4.1 Instructions 24
4.2 Cleaning the appliance 24
4.3 Removing the door 25
4.4 Cleaning the door glazing 26
4.5 Removing the internal glass panes 26
4.6 Vapor Clean 28
4.7 Extraordinary maintenance 29
5 Installation 31
5.1 Gas connection 31
5.2 Adaptation to different types of gas 34
5.3 Positioning 36
5.4 Electrical connection 39
5.5 For the installer 40
We advise you to read this manual carefully, which contains all the instructions for
maintaining the appliance’s aesthetic and functional qualities.
For further information on the product: www.smeg.com
3
Instructions
READ BEFORE USE
IMPORTANT INSTRUCTIONS
GAS/ELECTRIC COOKERS
Gas/Gas Cookers:
• To avoid overheating when the oven or
grill is being used, the glass cover must
always be up.
• The glass cover may not be cooked on,
or closed when the burners are in use
and while they are still warm.
• The gas oven and gas grill cannot be
used simultaneously.
All Cookers:
• Never place aluminium or foil at the
bottom of the oven and do not place
oven trays as this may damage the
enamel coating by overheating.
• The manufacturer declines all
responsibility for improper use.
• Never attempt to repair or install the
appliance yourself as the warranty will
become void.
• Installation must be done by a qualified
gas installer and qualified electrician.
• Retain your proof of purchase for
guarantee.
4
Instructions
EN
Additional installation information for
SMEG gas hobs and stoves supplied to
South Africa
All Smeg appliances comply with SANS
1539 and have been issued with Permit
numbers by the Liquefied Petroleum Gas
Safety Association of Southern Africa.
Gas Type: LPG (Note: This appliance may
have been supplied ex factory with setting
and jets for Natural Gas. Your installer must
make the necessary changes and
adjustments before handing over the
installed appliances for use).
Operating Pressure: 2.8 kPa. Note that this
appliance may only be used with a LPG
regulator of 2.8 kPa outlet pressure and that
complies with requirements of SABS 1237.
• This appliance may only be installed by
a qualified Gas Fitter that is registered
with the LPGSASA. All registered Gas
fitters are provided with an identity card,
which also carries their registration
number. Make a note of this. The Gas
Fitter should also provide you with a
written certificate after completing the
work. Before the installer hands over the
installed appliance ensure that you are
informed of the location of the isolation
or shut off valve in the gas supply line to
the appliance and how to operate it.
• Do not modify the appliance in any way
as this may make it unsafe.
• Note carefully that ventilation
requirements indicated in the specific
model instruction booklet. This
information is vital for the safety of the
occupants of the area in which the
appliance is installed and used.
• Never check for gas leaks with a naked
flame. Always use a soapy water
solution applied with a brush to the areas
where you suspect there may be a gas
leak. Do not use the appliance if you
suspect a gas leak.
• There are no preset service intervals for
this appliance. Refer to the section on
maintenance and cleaning in the
instruction booklet for details on how to
care for your SMEG appliance.
• After removing burner caps or burner
heads to clean them or the hob surface
around the burners, always take care
that the burner heads are properly
located in position and that the igniter
post and flame failure thermocouple are
not damaged in any way. It is important
that these devices fit correctly into the
location holes provided in the burner
heads. They will not function correctly if
not properly located. The burner caps
locate by means of the ridge on the
underside. Note that burners will not
work efficiently if the burner caps are not
properly located. There are drawings of
a typical burner assembly in your
instruction booklet.
Supplied in South Africa by:
S.B.S. Household Appliances,
2985 William Nicol Drive cnr Bryanston
Drive, Bryanston, JHB
tel: (011) 463 1016
e-mail: info@smegsa.co.za
5
Instructions
FOR YOUR SAFETY
IF YOU SMELL GAS:
• Turn off gas supply at bottle
• Extinguish all naked flames
• Do not operate any electrical
appliances
• Ventilate the area
• Check for leaks as detailed in this
manual
If odour persists, contact your dealer or gas
supplier immediately.
Do not tamper with the appliance.
BURN-BACK (FIRE IN BURNER TUBE OR
CHAMBER)
In the event of a burn-back, where the flame
burns back to the jet, immediately turn off
the gas supply at the control valve on the
panel. After ensuring the flame is
extinguished, wait for 1 minute and re-light
the appliance in the normal manner. Should
the appliance burn back again, close the
control valve and call a service technician.
Do not use the appliance again until the
service technician has declared that it is
safe to do so.
GAS-PRESSURE REGULATOR
This appliance requires an operating
pressure of 2,8 kPa at the appliance. A
suitable LPG regulator that complies with
the requirements of SANS 1237 must be
installed.
6
Instructions
EN
IMPORTANT INFORMATION FOR THE
USER
This appliance may only be installed by a
registered LP Gas installer. All registered
installers are provided with a card carrying
their registration number. Ask to be shown
the card before allowing the installation
work to commence and make a note of the
Installer QCC number. Upon completion of
the installation, the installer is required to
explain the operational details of the
appliance together with the safety
instructions. You will be asked to sign
acceptance of the installation and be
provided with a completion certificate. You
should only sign for acceptance of the
installation when the installation is
completed to your satisfaction.
Note that your invoice is required in the
event that you wish make a guarantee
claim.
IMPORTANT INFORMATION FOR THE
INSTALLER.
This appliance may only be installed by a
LP gas installer registered with the Liquefied
Petroleum Gas
Association of Southern Africa. The
appliance must be installed in accordance
with the requirements of
SANS 10087-1 and any fire department
regulations and/or local bylaws
applicable to the area. If in doubt check
with the relevant authority before
undertaking the installation. Upon
completion of the installation you are
required to fully explain and demonstrate to
the user the operational details and safety
practices applicable to the appliance and
the installation.
7
Instructions
1 Instructions
1.1 General safety instructions
Risk of personal injury
• During use the appliance and its
accessible parts become very hot.
• Never touch the heating elements
during use.
• Keep children under eight years
of age at a safe distance if they
are not constantly supervised.
• Children must never play with the
appliance.
• This appliance may be used by
children aged at least 8 and by
people of reduced physical,
sensory or mental capacity, or
lacking in experience in the use of
electrical appliances, as long they
are supervised or instructed by
adults who are responsible for
their safety.
• Never rest metallic objects such
as knives, forks, spoons and lids
on the appliance during use.
• Switch the appliance off
immediately after use.
• Never try to put out a fire or
flames with water: turn off the
appliance and smother the flames
with a fire blanket or other
appropriate cover.
• The appliance must never be
cleaned by unsupervised children.
• Have authorised persons carry
out installation and assistance
interventions according to the
standards in force.
• Do not modify this appliance.
• Do not insert pointed metal
objects (cutlery or utensils) into the
slots in the appliance.
• Do not try to repair the appliance
yourself or without the intervention
of authorised persons.
• If the power supply cable is
damaged, contact technical
support immediately and they will
replace it.
• Do not open the storage
compartment when the oven is on
and still hot.
• The items inside the storage
compartment could be very hot
after using the oven.
• Do not spray aerosols in the
vicinity of this appliance while it is
in operation.
• This appliance is not to be
installed in marine craft or in
caravans.
• Do not use or store flammable
materials in the appliance storage
drawer or near the appliance.
8
Instructions
EN
Risk of damaging the appliance
• Do not use abrasive or corrosive
detergents on glass parts (e.g.
powder products, stain removers
and metallic sponges).
• Racks and trays have to be
inserted into the side guides until
they come to a complete stop.
The mechanical safety locks that
prevent the rack from being taken
out accidentally have to face
downwards and towards the
oven back.
• Use wooden or plastic utensils.
• Do not seat on the appliance.
• Do not use steam jets for cleaning
the appliance.
• Do not obstruct ventilation
openings and heat dispersal slots.
• Never leave the appliance
unattended during cooking
operations where fats or oils
could be released.
• Never leave objects on the
cooking surface.
• Do not use the appliance to heat
rooms for any reason.
• Remove any food residues or
large spills from previous cooking
operations from the inside of the
oven.
For this appliance
• Before replacing the bulb, switch off
the power supply to the appliance.
• Do not rest any weight or sit on the
open door of the appliance.
• Take care that no objects are stuck in
the doors.
1.2 Identification plate
• The identification plate bears the
technical data, serial number and brand
name of the appliance. Do not remove
the identification plate for any reason.
1.3 Manufacturer liability
The manufacturer declines all liability for
damage to persons or property caused by:
• use of the appliance other than the one
envisaged;
• non-observance of the user manual
provisions;
• tampering with any part of the
appliance;
• use of non-original spare parts.
9
Instructions
1.4 Appliance purpose
• This appliance is intended for cooking
food in the home environment. Every
other use is considered improper.
• The appliance is not designed to
operate with external timers or with
remote-control systems.
1.5 This user manual
This user manual is an integral part of the
appliance and must therefore be kept in its
entirety and in an accessible place for the
whole working life of the appliance.
Read this user manual carefully before using
the appliance.
1.6 How to read the user manual
This user manual uses the following reading
conventions:
Instructions
General information on this user
manual, on safety and final
disposal.
Description
Description of the appliance and its
accessories.
Use
Information on the use of the
appliance and its accessories,
cooking advice.
Cleaning and maintenance
Information for proper cleaning and
maintenance of the appliance.
Installation
Information for the qualified
technician: installation, operation
and inspection.
10
Safety instructions
Information
Advice
1. Use instruction sequence.
• Standalone use instruction.
EN
2 Description
2.1 General Description
Description
1 Upstand
2 Cooking hob
3 Control panel
4 Oven light
5 Seal
6 Door
7 Fan
8 Storage compartment
Rack/tray support frame shelf
11
2.2 Cooking hob
Description
AUX = Auxiliary
SR = Semi-rapid
UR = Ultra rapid
2.3 Control panel
1 Timer knob
This knob enables manual cooking or the
timer to be selected. the timer switches off
the oven automatically at the end of
cooking. To set the cooking time, turn the
knob clockwise until it reaches the required
position and then set the required cooking
function. The numbers indicated are
minutes. Adjustment is progressive so that
the time can also be set to any intermediate
value between these numbers. At the end of
the timed cooking operation, a buzzer will
sound and switch off automatically after 3-4
seconds.
1 = Small electric hotplate (1000W)
2 = Large electric hotplate (1500W)
2 Temperature knob
This knob allows you to select the cooking
temperature. Turn the knob clockwise to the
required value, between the minimum and
maximum settings.
3 Indicator light
The indicator light comes on to indicate that
the oven is heating up. It turns off as soon as
it reaches the set temperature. It flashes
regularly to indicate that the temperature set
inside the oven is kept constant.
12
Description
EN
4 Function knob
The oven's various functions are suitable for
different cooking modes. After selecting the
required function, set the cooking
temperature using the temperature knob.
5 Hob burner knobs
Useful for lighting and adjust the hob
burners. Press and turn the knobs anti-
clockwise to the value to light the
relative burners. Turn the knobs to the zone
between the maximum and minimum
setting to adjust the flame.
Return the knobs to the position to turn
off the burners.
6 Electric hotplate knobs
Useful for lighting and adjust the electric
hotplates. Turn the knobs clockwise to
adjust the operating power of the hot plate
from minimum 1 to maximum 6.
7 Electric hotplate indicator light
2.4 Other parts
Shelves
The appliance features shelves to position
trays and racks at different heights. The
insertion heights are indicated from the
bottom upwards (see 2.1 General
Description).
Cooling fan
The fan cools the oven and comes into
operation during cooking.
The fan causes a steady outflow of air that
exits from the rear of the appliance and
which may continue for a brief period of
time even after the appliance has been
turned off.
The electric hotplate indicator light comes
on to indicate that the electric hotplate is
heating up.
Do not obstruct ventilation
openings and heat dispersal slots.
Interior lighting
The appliance interior lighting comes on:
• When the door is opened
• When any function is selected, apart
from the
function.
13
Description
2.5 Available accessories
Some models are not provided
with all accessories.
WOK ring
Useful when using a wok.
Rack
Tray
Useful for collecting fat from foods placed
on the rack above.
Deep tray
Useful for collecting fat from foods placed
on the rack above and for cooking pies,
pizzas and baked desserts.
Useful for supporting containers with food
during cooking.
Tray rack
To be placed over the top of the oven tray;
for cooking foods which may drip.
14
The accessories intended to come
into contact with food are made of
materials that comply with the
provisions of current legislation.
Supplied and optional accessories
can be requested to Authorised
Assistance Centres. Use only
original accessories supplied by
the manufacturer.
Loading...