Smeg SS55PNL, SS55PTE, FA55XBIL, SBS800AO, SBS800PO User Manual

...

Table of contents

Introduction

Installation

Operation

Entry Important safety instruction Identication of parts

Where to install Door removal Door replacement Feed water pipe installation Height adjustment

Starting Adjusting the temperatures and functions Refreshment center (Applicable to some models only) Shelf (Applicable to some models only) Wine holder (Applicable to some models only) Egg box

3 3 4

6 7 8

8 9

10 10

18 19 19 19

Suggestion on

food storage

Care and

maintenance

Humidity control in the vegetable compartment Convert into a vegetable or meat compartment (Applicable to some models only) Deodorizer (Applicable to some models only) Extra Fresh Temperature Transition Corner (Applicable to some models only) Temperature Change at Extra Fresh (Applicable to some models only) Extra Fresh (Applicable to some models only)

Location of foods Storing foods

How to dismantle parts General information Cleaning Trouble shooting

20 20

20 21

21 21

22 23

24 26 26 27

Introduction

Don’t use an

extension cord

Accessibility of

Supply Plug

Supply Cord

Replacement

Warning

Entry

The model and serial numbers are found on the inner case or back of refrigerator compartment of this unit. These numbers are unique to this unit and not available to others. You should record requested information here and retain this guide as a permanent record of your purchase. Staple your receipt here.

Date of purchase : Dealer purchased from : Dealer address : Dealer phone no. : Model no. : Serial no. :

Important safety instruction

Before it is used, this refrigerator must be properly installed and located in accordance with the installation instructions in this document.

Never unplug your refrigerator by pulling on the power cord. Always grip plug firmly and pull it straight out from the outlet.

When moving your appliance away from the wall, be careful not to roll over the power cord or to damage it in any way.

After your refrigerator is in operation, do not touch the cold surfaces in the freezer compartment these extremely cold surfaces.

Unplug the power cord from the power outlet for cleaning or other requirements. Never touch it with wet hands because you can get an electric shock or be hurt.

Never damage, process, severely bend, pull out, or twist the power cord because damage the power cord may cause a fire or electric shock. You have doubts on whether the appliance is properly grounded.

Never place glass products in the freezer because they may be broken due to expansion when their contents are frozen.

Never allow your hands within the ice storage bin of the automatic ice maker. You could be hurt by the operation of the automatic ice maker.

The appliance is not intended for use by young children or infirm persons without supervision.

Young children should be supervised to ensure that they do not play with the appliance. Never allow anyone to climb, sit, stand or hang on the refreshment center door. These

actions may damage the refrigerator and even tip it over, causing severe personal injury. If possible, connect the refrigerator to its own individual electrical outlet to prevent it and

other appliances or household lights from causing an overload that could cause a power outage.

The refrigerator-freezer should be so positioned that the supply plug is accessible for quick disconnection when accident happens.

If the supply cord is damaged, it must be replaced by the manufacturer or its service agent or a similarly qualified person in order to avoid a hazard.

Do not modify or extend the Power Cord length.



It will cause electric shock or fire.

, particularly when your hands are damp or wet. Skin could adhere to

Introduction

Child entrapment

warning

Don’t store

warning

Grounding (Earthing)

warning

Door rack

Shelf or Drawer

Lamp

Shelf or Drawer

DANGER: Risk of child entrapment. Before you throw away your old refrigerator or freezer: Take off the doors but leave the shelves in place so that children may not easily climb inside. The appliance is not intended for use by young children or infirm persons without supervision. Young children should be supervised to ensure that they do not play with the appliance.

Don’t store or use gasoline or other flammable vapor and liquids in the vicinity of this or any other appliance.

In the event of an electric short circuit, grounding (earthing) reduces the risk of electric shock by providing an escape wire for the electric current. In order to prevent possible electric shock, this appliance must be grounded improper use of the grounding plug can result in an electric shock. Consult a qualified electrician or service person if the grounding instructions are not completely understood, or if you have doubts on whether the appliance is properly grounded.

Identification of parts

*Non dispenser model

Freezer Compartment

Refrigerator Compartment

Milk product corner Lamp

Shelf Wine holder (Plastic or wire)

(Optional)

Door rack (1piece or 2piece) Shelf Snack drawer (Optional) Shelf (Folding or Normal) Refreshment center (Optional)

Guide Pitcher (Optional)

Door rack

Drawer (2 or 3)

Door rack

Lower cover

Door rack (1piece or 2piece)

(Optional)

Egg Box Vegetable Drawer

(1 or 2)

Door Rack Humidity switch

Extra Fresh (Optional)

Miracle Zone (Optional) Fresh compartment (Optional)

Conversion switch (Meats/Vegetables)(Optional)

NOTE

•

Parts, features, and options vary by model. Your model may not include every option.

(Optional)

Introduction

*Dispenser model - Type 22

Automatic

Icemaker

Shelf or Drawer

Lamp

Shelf or Drawer

Drawer

Door rack

Drawer (2 or 3)

Door rack

Lower cover

Freezer Compartment

Refrigerator Compartment

Milk product corner Lamp

Shelf Wine holder (Plastic or wire) Door Rack

Shelf Can Server

(Optional) Snack drawer (Optional) Refreshment center (Optional)

Shelf (Folding or Normal) Egg Box

Vegetable Drawer (1 or 2)

Humidity switch

Miracle Zone (Optional)

Extra Fresh (Optional)

Fresh compartment (Optional) Door Rack

Conversion switch (Meats/Vegetables)(Optional)

Guide Pitcher (Optional)

(Optional)

NOTE

•

Parts, features, and options vary by model. Your model may not include every option.

(Optional)

Automatic

Icemaker

Shelf

Lamp

Shelf

Drawer

Door Rack

Drawer

Door Rack

Lower Cover

*Dispenser model - Type 22

Freezer Compartment

Refrigerator Compartment

Milk product corner

Lamp

Door Rack Shelf

Can Server Wine holder (Plastic or wire) Refreshment center (Optional)

Shelf (Folding or Normal) Egg Box

Vegetable Drawer

Humidity Switch Miracle Zone (Optional)

Extra Fresh (Optional)

Fresh compartment (Optional)

Door Rack

Conversion switch (Meats/Vegetables) (Optional)

NOTE

•

Parts, features, and options vary by model. Your model may not include every option.

(Optional)

Where to Install

Installation

Select a good

location

Disposal of the

old appliance

1. Place your appliance where it is easy to use.

2. Avoid placing the unit near heat sources, direct sunlight or moisture.

3. To ensure proper air circulation around the fridge -freezer, please maintain sufficient space on both the sides as well as top and maintain at least 2 inches (5 cm) from the rear wall.

4. To avoid vibrations, the appliance must be leveled.

5. Don't install the appliance below 5°C. It may cause affect the performance.

This appliance contains fluid (refrigerant, lubricant)and is made of parts and materials which are reusable and/or recyclable. All the important materials should be sent to the collection center of waste material and can be reused after rework (recycling). For take back, please contact with the local agency.

Installation

Warning

Remove lower

cover and

then feed water

tube

Remove the

freezer

compartment

door

Door removal

Electric Shock Hazard

Disconnect electrical supply to refrigerator before installing.

Failure to do so could result in death or serious injury.

If your access door is too narrow for the refrigerator to pass through, remove the refrigerator door and pass the refrigerator laterally.

Remove the lower cover by lifting upward, and remove clip, and then pull up the feed water tube while pressing area shown in the figure to the right.

NOTE

•

If a tube end is deformed or abraded, cut the part away.

Hinge

1) Removing the hinge cover by loosening the screws. Separate all connection wires except for the earth line after.

Upper hinge

2) Remove the keeper by rotating it counter

)

clockwise ( hinge up (

and then lifting the upper

).

cover

Keeper

Feed water tube

Upper hinge

Lower cover

Connection wires

Earth line

Remove the

refrigerator

door

NOTE

•

When removing the upper hinge, be careful that the door does not fall forwards .

3) Remove the freezer compartment door by lifting it upward. This time, the door should be lifted enough for the feed water pipe tube to be completely pulled out.

Lower hinge

NOTE

•

Move the refrigerator compartment door passing through the access door and lay it down, but be careful not to damage the feed water pipe tube.

1) Loosen the hinge cover screws and remove the cover. Remove connection wire, if any, except for the earth line.

Connection

wires

2) Remove keeper by rotating it clockwise ()

Upper hinge

Keeper

and then remove the upper hinge by lifting it up ().

3) Remove the refrigerator compartment door by lifting it up.

Lower hinge

Installation

345

M a x

FRZ TEMP

REF TEMP

Mi n

Ma x

Pass the

refrigerator

Before

installation

Pass the refrigerator laterally through the access door as shown in the right figure.

Door replacement

Mount them in the reverse sequence of removal after they pass through the access door.

Feed water pipe installation

(*Dispenser model only)



Automatic ice maker operation needs water pressure of 147~834 kPa (1.5~8.5 kgf/cm2) (That is, an instant paper cup (180 cc) will be fully filled within 3 sec.).



If water pressure does not reach the rating 147 kPa (1.5 kgf/cm2) or below, it is necessary to purchase a separate pressure pump for normal automatic icing and cool water feed.



Keep the total length of the feed water pipe tube within 8 m and be careful for the tube not be bent. If the tube is 8 m or longer it may cause trouble in water feed owing to the drain water pressure.



Install the feed water pipe tube at a place free from heat.



Warning

Connect to potable water supply only.



Refer to instructions with water filter kit for installation.

Installation

Height adjustment

If the freezer

compartment door

is lower than the

refrigerator

compartment door

If the freezer

compartment door

is higher than the

refrigerator

compartment door

Level the door by inserting flat (-type) driver into the groove of the left height adjusting screw and rotate it clockwise ().



Level the door by inserting flat (-type) driver into the groove of the right height adjusting screw and rotate it clockwise ().

After leveling the

door height



The refrigerator doors will close smoothly by heightening the front side by adjusting the height adjusting screw. If the doors do not close correctly, performance may be affected.

1. Wipe off all dust accumulated during shipping and clean your appliance thoroughly.

2. Install accessories such as the ice cube box, cover evaporating tray, etc., in their proper places. They are packed together to prevent possible damage during shipping.

3. Connect the power supply cord (or plug) to the outlet. Don't double up with other appliances on the same outlet.

Operation

Optional

Type-1

Type-2

Function display board

Display Power Saving Mode

Refreshment Center

Refreshment Center Button

Starting

When your refrigerator is first installed, allow it to stabilize at normal operating temperatures for 2-3 hours prior to filling it with fresh or frozen foods. If operation is interrupted, wait 5 minutes before restarting.

Adjusting the temperatures and functions

*Non dispenser model

+ 22 hidden pages