Smeg S9GMXU Installation

Table of Contents - Important Safety Instructions

1. IMPORTANT SAFETY INSTRUCTIONS ................................................................................. 4

2. DIMENSION REQUIREMENTS ............................................................................................... 7

3. UNPACKING, MOVING AND POSITIONING THE RANGE .................................................... 9

4. WALL ATTACHMENT AND THE ANTI-TIP DEVICE ............................................................ 10

5. ELECTRICAL REQUIREMENTS ........................................................................................... 14

6. GAS SUPPLY REQUIREMENTS .......................................................................................... 17

WARNING: If the instructions contained in this manual are not followed

precisely, fire or explosion may result causing property damage, personal injury or loss of life.

- Do not store or use gasoline or other flammable vapors or liquids near this or any other appliance.

WHAT TO DO IF YOU SMELL GAS

• Do not try to light any appliance.

• Do not touch any electrical switches.

• Do not use any telephones in your building.

• Immediately call your gas supplier from a neighbor’s phone. Follow the gas supplier’s instructions.

• If you cannot reach your gas supplier, call the fire department.

- Installation and service must be performed by a qualified installer, service agency or gas supplier.

NOTE: THIS APPLIANCE MUST BE INSTALLED SOLELY AND EXCLUSIVELY BY A QUALIFIED TECHNICIAN. ANY TECHNICAL PROCEDURES MUST BE CARRIED OUT BY AN AUTHORIZED TECHNICIAN.

INSTRUCTIONS FOR THE INSTALLER: these are intended for the qualified technician who must install

the appliance, set it functioning and carry out an inspection test.

Important Safety Instructions

1. IMPORTANT SAFETY INSTRUCTIONS

READ AND SAVE THESE INSTRUCTIONS – Your safety and the safety of others are very important.

We have provided many important safety messages throughout this manual and on the appliance. Read all the instructions before using the appliance and always obey all safety messages.

RECOGNIZE SAFETY INFORMATION This is a safety alert symbol. This symbol alerts you to potential hazards that can result in severe personal injury or loss of life.

UNDERSTAND SIGNAL WORDS A signal word – DANGER, WARNING, or CAUTION – is used with the safety alert symbol. DANGER denotes the most serious hazards. It means you could lose your life or be seriously injured if you do not immediately the instructions are not followed. CAUTION indicates a potentially hazardous situation which, if not avoided, could result in minor to moderate injury.

The safety messages will inform you of potential hazards, on how to avoid the risk of injury and what can occur if the instructions are not followed.

IMPORTANT: Installation, gas connections and grounding must conform to applicable codes. Observe all governing codes and ordinances.

follow the instructions. WARNING means you could lose your life or be seriously injured if

WARNING: For your safety, the instructions in this manual must be followed to minimize the risk of fire or explosion and to prevent property damage, personal injury or loss of life.

- This appliance is intended for home use only.

- Use this appliance only for its intended purpose. The manufacturer cannot be

held liable for damage caused by improper use of this range.

WARNING

NOTE: This range is manufactured for use with natural gas. To convert the appliance to LP/Propane gas, see the instructions in the Gas Conversion Kit provided in the literature package.

The proper gas supply connection must be available. See "Gas supply requirements”.

In the State of Massachusetts, the following installation instructions apply:

- Installation and repairs must be performed by a Massachusetts qualified or licensed contractor, plumber, or gas fitter.

- If using a ball valve, it shall be the T-handle type.

- A flexible gas connector, when used, must not exceed 3 feet.

- This appliance complies with current safety regulations. Improper use of this

range can result in personal injury and material damage.

- Read all the instructions before installing or using the range for the first time.

- Keep these operating instructions in a safe place and pass them on to any future user.

Important Safety Instructions

TIP OVER HAZARD

- A child or adult can tip the range and be killed.

WARNING

- Make sure that the anti-tip device has been properly installed and engaged. The wall-mounted brackets should anchor the sides of the range (primary system) or, in case of floor-mounted brackets, they should anchor the rear of the range to the ground.

- Make sure that the anti-tip device is re-engaged when the range is moved. The wall-mounted brackets should anchor the sides of the range (primary system) or, in case of floor-mounted brackets, they should anchor the rear of the range to the ground.

- Do not operate the range without the anti-tip device in place and engaged.

- Failure to do so can result in death or serious burns to children or adults.

PRIMARY FASTENING SYSTEM:

Visually check that the wall-mounted brackets are inserted into the appropriate lateral hooks (on both sides).

SECONDARY FASTENING SYSTEM:

Visually check from the inside of the drawer that the floor-mounted bracket is inserted into the appropriate lateral hooks (left or right).

NOTE: This range is NOT designed for installation in manufactured (mobile) homes or in recreational vehicles (RVs).

DO NOT install this range outdoors.

To reduce the risk of fire, electrical shock, personal injury, or damage when

WARNING

- Read all instructions

- Proper installation is your responsibility. Have a qualified technician install and ground this appliance in accordance with these installation instructions.

It is the responsibility of the installer to comply with installation information specified on the model/serial ID plate. The ID Plates are visibly located on the back of the appliance and on the oven door frame.

These ID plates must never be removed.

CAUTION: To eliminate the risk of burns or fire caused by reaching over hot surface burners, do not

store items directly above the rangetop.

installing the range, some basic safety precautions must be followed, including:

Important Safety Instructions

- ELECTRICAL GROUNDING REQUIRED: See the “Electrical Requirements” section. It is the customer’s responsibility: 1 To contact a qualified electrician to install the appliance 2 To ensure that the electrical system is adequate and conforms with the national ANSI / NFPA 70

ELECTRICAL CODE – latest edition – Or the CANADIAN ELECTRICAL CODE, C22.11 – 1 and C22.2 No. 01982 – or latest edition – and all local codes and ordinances. IMPORTANT: Observe all governing codes and ordinances.

- Before you plug the electrical cord into an outlet, make sure that all the appliance controls are in the OFF position.

- Never modify or alter the construction of the appliance. For example, do not remove adjustable legs, panels, wiring or anti-tip brackets/screws.

CAUTION: This unit is designed as a cooking appliance. For safety purposes, never use it for warming the room or as a space heater.

- Do not obstruct oven vents or openings for heat exhaust.

- Test the appliance immediately after installation, following the instructions in this booklet. If the appliance does not work properly, disconnect it from the electrical power supply and call the service center. DO NOT attempt to repair the appliance.

- All adjustments and servicing must be performed by qualified installers or service technicians.

- Do not leave the packing material around the home. Sort the various items of waste and take them to the nearest specialized waste collection facility.

WARNING

SAVE THESE INSTRUCTIONS

- This appliance is intended for home use only.

- Use this appliance only for its intended purpose. The manufacturer cannot be held liable for damage caused by improper use of this range.

- This appliance complies with current safety regulations. Improper use of this range can result in personal injury and material damage.

- Read all the instructions before installing or using the range for the first time.

- Keep these operating instructions in a safe place and pass them on to any future user.

Instructions for the installer

2. DIMENSION REQUIREMENTS

CLEARANCE

MODEL

S9GMXU

A B

900 mm

”

636 mm

25 “

(5)

216 mm

/2 ”

1 min. when bottom of wood or metal cabinet is protected by not less than ¼” (0.64 cm) flame retardant

millboard covered with not less than No. 28 MSG sheet steel, 0.015” (0.4 mm) stainless steel, 0.024” (0.6 mm) aluminum or 0.020” (0.5 mm) copper. 35” (889 mm) min. clearance between the top of the

cooking surface and the bottom of an unprotected wood or metal cabinet. 2 max. upper cabinet depth; 3 min. cabinet opening width; 4 upper cabinet to countertop; 5 min. clearance from the sides of range to side wall or other combustible material;

NOTE: Install with zero clearance sides and back.

Grounded outlet

Position within 11

/8” (300 mm) from the

left rear corner of the range.

(3)

900 mm

”

(4)

457 mm

18 “

(1)

610 mm

24 “

(2)

330 mm

13 “

Gas supply line

Position within 11

/8” (300 mm) from the

right rear corner of the range.

150 mm

”

+ 11 hidden pages