Smeg FS66MFX User Manual

Index

1 INSTRUCTIONS FOR SAFE AND PROPER USE_______________________________4

2 INSTALLATION OF THE APPLIANCE ________________________________________ 6

3 DESCRIPTION OF CONTROLS _____________________________________________ 9

4 USE OF THE COOKING HOB______________________________________________ 11

5 USE OF THE OVEN _____________________________________________________ 12

6 ELECTRONIC PROGRAMMER (ONLY ON EQUIPPED MODELS) _________________ 14

7 CLEANING AND MAINTENANCE ___________________________________________ 16

8 EXTRAORDINARY MAINTENANCE _________________________________________ 18

HESE INSTRUCTIONS ARE VALID ONLY FOR THE END USER COUNTRIES WHOSE

IDENTIFICATION SYMBOLS APPEAR ON THE COVER OF THIS MANUAL.

INSTRUCTIONS FOR THE INSTALLER: these are for the qualified technician who must carry out

suitable check of the gas system, install the appliance, set it functioning and carry out an inspection test.

INSTRUCTIONS FOR THE USER: these contain user advice, description of the commands and th correct procedures for cleaning and maintenance of the appliance.

1 INSTRUCTIONS FOR SAFE AND PROPER USE

THIS MANUAL IS AN INTEGRAL PART OF THE APPLIANCE AND THEREFORE MUST BE KEPT

IN ITS ENTIRETY AND IN AN ACCESSIBLE PLACE FOR THE WHOLE WORKING LIFE OF THE COOKER. WE ADVISE READING THIS MANUAL AND ALL THE INSTRUCTIONS THEREIN BEFORE USING THE COOKER. INSTALLATION MUST BE CARRIED OUT BY QUALIFIED PERSON IN ACCORDANCE WITH THE REGULATIONS IN FORCE. THIS APPLIANCE IS INTENDED FOR DOMESTIC USES AND CONFORMS TO CURRENT REGULATIONS IN FORCE. THE APPLIANCE HAS BEEN BUILT TO CARRY OUT THE FOLLOWING FUNCTIONS: COOKING

AND HEATING-UP OF FOOD. ALL OTHER USES ARE CONSIDERED IMPROPER. THE MANUFACTURER DECLINES ALL RESPONSIBILITY FOR IMPROPER USE.

DO NOT LEAVE THE PACKING IN THE HOME ENVIRONMENT. SEPARATE THE VARIOUS

WASTE MATERIALS AND TAKE THEM TO THE NEAREST SPECIAL GARBAGE COLLECTION CENTRE.

IT IS COMPULSORY THAT THE APPLIANCE BE GROUNDED ACCORDING TO THE METHODS

REQUIRED BY SAFETY RULES.

Introduction

THE PLUG TO BE CONNECTED TO THE POWER CABLE AND THE SOCKET MUST BE THE

SAME TYPE AND MUST CONFORM TO CURRENT REGULATIONS. THE SOCKET MUST BE ACCESSIBLE AFTER THE APPLIANCE HAS BEEN BUILT IN.

NEVER UNPLUG BY PULLING ON THE CABLE.

IMMEDIATELY AFTER INSTALLATION CARRY OUT A BRIEF INSPECTION TEST OF THE

APPLIANCE, FOLLOWING THE INSTRUCTIONS BELOW. SHOULD THE APPLIANCE NOT FUNCTION, DISCONNECT IT FROM THE SUPPLY AND CALL THE NEAREST TECHNICAL ASSISTANCE CENTRE.

NEVER ATTEMPT TO REPAIR THE APPLIANCE.

WHEN NOT IN USE, MAKE SURE THAT THE CONTROL KNOBS ARE IN THE CORRECT (OFF)

POSITION 0 .

NEVER PUT INFLAMMABLE OBJECTS IN THE OVEN: THEY COULD BE ACCIDENTALLY

LIGHTED AND CAUSE FIRES.

THE I.D. PLATE WITH TECHNICAL DATA, SERIAL NUMBER AND BRAND NAME IS POSITIONED

VISIBLY IN THE STORAGE COMPARTMENT.

THE PLATE MUST NOT BE REMOVED.

DO NOT PUT PANS WITHOUT PERFECTLY SMOOTH AND FLAT BOTTOMS ON THE HOB

GRIDS.

DURING USE THE APPLIANCE BECOMES VERY HOT. TAKE CARE NOT TO TOUCH THE HEATING ELEMENTS INSIDE THE OVEN.

THE APPLIANCE IS DESIGNED FOR USE BY ADULTS. CHILDREN AND INFIRM PERSONS SHOULD NOT USE IT WITHOUT SUPERVISION. DO NOT ALLOW CHILDREN TO GO NEAR OR PLAY WITH IT.

IF THE APPLIANCE IS TO BE POSITIONED ON A BASE IT MUST BE INSTALLED IN SUCH A WAY

AS TO PREVENT IT FROM SLIPPING OFF THE BASE.

Introduction

ATTENTION: IF THE SURFACE OF THE CERAMIC COOKTOP IS CRACKED. SWITCH OFF THE

APPLIANCE, IMMEDIATELY DISCONNECT FROM MAINS AND CONTACT THE NEAREST SERVICING CENTRE.

REPLACED APPLIANCES MUST BE TAKEN TO A SPECIAL GARBAGE COLLECTION CENTRE.

The manufacturer declines all responsibility for damage to persons or things caused by non

observance of the above prescriptions or by interference with any part of the appliance or by the us of non-original spares.

2 INSTALLATION OF THE APPLIANCE

It is the law that all appliances are installed by competent persons.

This appliance may be installed next to a wall which is higher than the appliance, with a minimu distance of 50 mm from the side of the appliance, as shown in the diagram showing the correc installation conditions. Any wall cupboards or shelves must be at a distance of at least 750 m abov the work surface.

Instructions for the installer

2.1 Electrical connection

Make sure that the power line voltage matches the specifications indicated on the rating plate located inside the storage compartment.

This rating plate must never be removed.

If the appliance is connected to the supply by means of a fixed connection, install a multipolar cut-out

device on the line, with contact opening distance equal to or greater than 3 mm, located near the appliance and in an easily reachable position.

For operation on 400/415V3N

H05RN-F / H05V2V2-F type five-core cable (5 x 2.5 mm2).

For operation on 400/415V2N

H05RN-F / H05V2V2-F type five-core cable (cavo di 4 x 2. mm2).

For operation on 230/240V

F / H05V2V2-F (cavo di 3 x 4 mm2).

The cable end to be connected to the appliance must b provided with an ground wire (yellow-green) at least 20 m longer.

Complete wiring up to power supply with an appropriately rated five-core plug (see data plate) or, in

case of operation from a 230-240V∼∼∼∼ power supply, with a three-core plug. Make sure that plug and wall socket are of the same type and are in conformity with regulations in force. Make sure that the appliance is properly earthed. Before powering, check that the power line is properly earthed. Avoid using adapters or shunters.

The manufacturer declines all responsibility for damage to persons or things caused b

non-observance of the above prescriptions or by interference with any part of the appliance.

Instructions for the installer

∼∼∼∼

: use an H05RR-F

∼∼∼∼

: use an H05RR-F

∼∼∼∼

: use an H05RR-F / H05RN

+ 11 hidden pages