Smeg FR165SE User Manual
Frigorifero
Installazione e uso
Refrigerator
Installation and use
Réfrigérateur
Installation et emploi
Kühlschrank
Installation und Gebrauch
Frigorifero 0 stelle 1
I
Istruzioni per l'installazione e l'uso
0 star refrigerator 7
GB
Instructions for installation and use
Réfrigérateur desous à 0 étoiles 13
F
Instructions pour l'installation et l'emploi
0-Sterne-Kühlschrank 19
D
Installation- und Gebrauchshinweise
Safety - a good habit to get into.
A TTENTION
Read your manual carefully since it contains instructions which
will ensure safe installation, use and maintenance of your
appliance.
Your Refrigerator is built to International safety standards
(EN60) ans has been awarded the European approval mark
(IMQ) for compliance with UK electrical safety requirements.
It also meets the EC standards on the prevention and elimination of readio interference (EC directive 87/308 - 02.06.89).
1. This appliance must not be installed outdoors - not even in
an area protected by a roof. It is extremely dangerous to
leave it exposed to rain or storms.
2. It must only be used by adults and exclusively to refrigerate and freeze foodstuffs, following the instructions for use
contained in this manual.
3. Do not ever touch or handle the appliance with bare feet
or with wet hands or feet.
4. It is highly recommended that you do not use extension
cords or multiple socket adapters. If the refrigerator is installed between cabinets, make sure that the cord is not
bent or dangerously pinched or compressed.
5. Never pull on the cord or the refrigerator to remove the
plug from the wall socket - this is very dangerous.
6. Never touch the cooling components within the appliance,
especially with wet hands because this could result in injury .
Never put ice cubes just removed from the freezer into your
mouth because they could stick to your mouth and cause
burns.
7. Never clean the appliance or perform maintenance without
first disconnecting it from the electrical mains. Turning the
thermostat knob to the setting does not suffice to break
all electrical contact with the mains.
8. Before having your old refrigerator picked up for disposal,
remove or make inoperable any locking devices to prevent
children who might play in or around the appliance from
being locked inside.
9. Before calling for service/assistance in the case of malfunction, consult the chapter entitled “Is There a Problem?
to determine whether it is possible to eliminate the problem.
do not try to repair the problem by trying to access the internal
components of the appliance.
10. If damaged, the power supply cord on this appliance
must necessarily be replaced by our service centre because
special tools are required for replacement.
Installation
To ensure that the appliance operates properly and to
reduce energy consumption, it is important that the
appliance is installed correctly.
Ventilation
The compressor and condenser generate heat and, therefore,
need to be ventilated properly. Avoid placing refrigerator in
direct sunlight, or next to an electric stove or similar appliance.
Areas not adequately ventilated are not suitable for this
appliance.
During installation, make sure not to cover or obstruct the
grates that allow for proper ventilation of the appliance.
Away from Heat
Avoid positioning the appliance in a place where it is directly
exposed to sunlight or near an oven, cook top or the like.
Level
The appliance must be level. If the floor is not level, the
adjustable feet located in front can be used to level the appliance.
Electrical Connection and Earthing
Before proceeding with the electrical connection, make sure
that the voltage indicated on the rating plate, located at the
bottom left near the vegetable crisper, corresponds to the
mains voltage in your home and that the socket is fitted with
a standard earthing wire in accordance with safety standards
for 46/90 systems. If the socket is not fitted with an earthing
wire, the manufacturer will not be held liability for any
damages and or injuries arising out of the use of the
appliance. Do not use multiple sockets or adapters.
Insufficient power?
The electrical socket must be able to handle the maximum
power load of the appliance, which is indicated on the rating
plate located at the bottom left next to the vegetable crisper .
Before making the electrical connection ...
After the appliance has been delivered, place it in the ver tical upright position and wait at least 3 hours before inserting the plug into the socket in order to ensure that it
functions properly .
For English Market only
The appliance is fitted with a continental 2-èin plug for
factory testing. Before installation the plug should be cut
off. The appliance is designed to be installed in a switched
spur outlet fused at 13 Ampere. If the installation requires
a 13 Ampere plug type to be fitted it should be conform to
BSI 1363.
7
GB
Loading...