Smeg FLTK ASSEMBLY INSTRUCTIONS

Servizio post vendita - After sales service - Kundendienst - Service après vente - Servicio posventa

FLTK FILTER KIT ASSEMBLY INSTRUCTIONS

1- The active carbon filter contains:

-n°1 circular active carbon filter with slot to be

2- Disconnect the hood from the mains and remove the grease filters

applied on left hand side of motor-hood

-n°1 circular active carbon filter without slot to be applied on right hand side of motor-hood

3- Remove the motor suction protection grids by forcibly pulling them out of the recesses

4- After removing the grids, snap-fit the active carbon filter support only on the right hand side of the motor, making sure the arrow on the support faces up.

Page 2 / 3

Servizio post vendita - After sales service - Kundendienst - Service après vente - Servicio posventa

5- Take the right hand side active carbon filter (filter without slot) and draw it close to the motor/filter support assembly

- insert A the carbon filter in the filter support centring prongs

- rotate B the filter as shown in the figure

6- Take the left hand side active carbon filter (filter with slot) and insert the filter support in the filter centring prongs (Fig. A) making sure the arrow on the support faces the slot

- rotate the filter on the filter support as shown in Fig. B

7- Draw the filter/filter support assembly close to the LHS of the motor and apply the filter by exerting pressure and making sure the filter slot coincides with the projection on the motor as shown in the figure.

Page 3 / 3