Smeg FA55PCIL3, SBS8003P, SS55PTLH3, SS55PTE3, FA55XBIL3 User Manual

...

Introduction

Table of contents

Entry ________________________________________________________ 3

Important safety instructions ______________________________________ 3

Identication of parts ____________________________________________ 5

Installation

Operation

Where to install ________________________________________________ 6

Door removal __________________________________________________

Door replacement ______________________________________________ 8

Feed water pipe installation (Dispenser model only) ____________________ 8

Door height adjustment __________________________________________ 9

Starting ______________________________________________________ 10

Adjusting the temperature and functions _____________________________ 10

Dispenser use (on some model) ___________________________________ 14

Two stars section (Applicable to some models only) ____________________18

Refreshment centre(Applicable to some models only) __________________18 Shelf (Applicable to some models only) _____________________________19

Wine holder (Applicable to some models only) ________________________19

Egg box (Depends on model) _____________________________________19

Humidity control in the vegetable compartment

Deodorizer (Applicable to some model only)

Fresh 0 Zone (Applicable to some models only) _______________________20

Extra Fresh Temperature Transition Corner (Applicable to some models only)

_______________________________________

Temperature Change at Extra Fresh (Applicable to some models only) Extra Fresh (Applicable to some models only)

________

___

________

21

Suggestion on

food storage

Care and

maintenance

Location of foods _______________________________________________ 22

Storing foods __________________________________________________ 23

Suggestion for energy saving _____________________________________ 23

How to dismantle parts __________________________________________ 24

General information _____________________________________________ 26

Cleaning _____________________________________________________ 26

Troubleshooting ______________________________________________28

Introduction

Don’t use an

extension cord

Accessibility

of Supply Plug

Supply Cord

Replacement

Warning

Entry

The model and serial numbers are found on the inner case on the back

or one side of the refrigerator

compartment of this unit. These numbers are unique to this unit and are not available to others. You should record requested information here and retain this guide as a permanent record of your purchase. Staple your receipt here.

Date of purchase : Dealer purchased from : Dealer address : Dealer phone no. : Model no. : Serial no. :

Important safety instructions

Before it is used, this refrigerator must be properly installed and located in accordance with the installation instructions in this document. This Refrigerator is intended for Domestic indoor use only.

Never unplug your refrigerator by pulling on the power cord. Always grip plug rmly and pull it straight out from the outlet.

When moving your appliance away from the wall, be careful not to roll over the power cord or to damage it in any way.

After your refrigerator is in operation, do not touch the cold surfaces in the freezer compartment, particularly when your hands are damp or wet. Skin could adhere to these extremely cold surfaces.

Unplug the power cord from the power outlet for cleaning or other maintenance. Never touch the appliance with wet hands as you may receive an electric shock or injure yourself.

Never damage, press, severely bend, pull or twist the power cord as damage to the cord may cause re or electric shock. Never touch the cord if you are uncertain if the appliance is correctly earthed.

Never place glass items in the freezer as they may break due to expansion of their contents on freezing.

Never put your hands into the storage bin of the automatic ice maker as you could be injured during its operation.

The appliance is not intended for use by young children or inrm persons without supervision.

Young children should be supervised to ensure that they do not play with the appliance. Never allow anyone to climb, sit, stand or hang on the refreshment centre door. These

actions may damage the refrigerator and even tip it over, causing severe personal injury. It is advised that this appliance should be connected through an independent power

socket to prevent it and other appliances from overloading the circuit and causing a power outage.

The appliance should be positioned so that the supply plug is easily accessible for quick disconnection should an accident occur.

If the supply cord is damaged, it must be replaced by the manufacturer or its service agent or a similarly qualied person in order to avoid a hazard.

Do not modify or extend the Power Cord length.

It may cause electric shock or re.

Introduction

Child entrapment

Warning

Don’t store

Warning

Grounding

(Earthing)

Warning

DANGER: Risk of child entrapment. Before you dispose of your old refrigerator please remove doors but leave the shelves

in place so that children cannot climb inside.

This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.

Children should be supervised to ensure that they do not play with the appliance. Do not store or use gasoline or other ammable vapour and liquids in the vicinity of

this or any other appliance. In the event of an electric short circuit, grounding (earthing) reduces the risk of

electric shock by providing an escape wire for the electric current. In order to prevent possible electric shock this appliance must be earthed. Improper

connection of the earthing plug can cause electric shock. Consult a qualied electrician or service engineer if the earthing instructions are not completely understood, or if you have doubts as to whether the appliance is properly earthed.

Keep ventilation openings in the room where the appliance is installed clear of obstruction.

Do not use mechanical devices or other means to accelerate the defrosting process, other than those recommended by the manufacturer.

Do not damage the refrigerant circuit. Do not use electrical appliances inside the food storage compartments of the

appliance, unless they are of the type recommended by the manufacturer. Disposal procedures. If disposing of this appliance, please consult with a service

agent or a similarly qualied person for more details.

This appliance may contain (Check the rating/comliance label for the refrigerant type and amount. Applicable to some models only) a small amount of isobutane refrigerant (R600a), natural gas with high environmental compatibility, but it is also combustible. When transporting and installing the appliance, care should be taken to ensure that no parts of the refrigerating circuit are damaged. Refrigerant squirting out of the pipes could ignite or cause an eye injury. If a leak is detected, avoid any naked ames or potential sources of ignition and air the room in which the appliance is standing for several minutes.

In order to avoid the creation of a ammable gas air mixture if a leak in the refrigerating circuit occurs, the size of the room in which the appliance may be sited depends on the amount of refrigerant used. The room must be 1m for every 8g of R600a refrigerant inside the appliance. The amount of refrigerant in your particular appliance is shown on the identication plate inside the

appliance. Never start up an appliance showing any signs of damage. If in doubt, consult your dealer.

in size

Introduction

Identication of parts

*Non dispenser model

Door rack

Shelf or drawer

Lamp/LED Lamp (option)

Shelf or drawer

Door rack

Drawer

Door rack

Lower cover

Extra door

rack(option)

Automatic

Icemaker

Lamp/LED Lamp (option)

Shelf

Shelf or Drawer

Door rack

Drawer

Door rack

Lower cover

Freezer Compartment

*Dispenser model

Freezer Compartment

Refrigerator Compartment

Dairy Corner

Lamp /LED Panel (option)

Shelf Wine rack (Plastic or wire) (Optional) Door rack

Shelf Snack drawer (Optional)

Shelf (folding or normal) Refreshment centre (Optional)

Lamp /LED(option)

Guide pitcher (Optional)

Door rack

(Optional)

Egg box Vegetable drawer 1 or 2

Door rack

Humidity Switch Opti Temp Zone (Optional)

Fresh 0 Zone (Optional)

Dairy Corner Lamp /LED Panel (option) Shelf

Wine rack (Plastic or wire) (Optional)

Door rack

Shelf Can Server (Optional) Snack Drawer (Optional) Refreshment Centre (Optional)

Lamp /LED (option)

Guide pitcher (Optional)

Shelf No Plumbing Ice & Water (Optional)

Egg Box

(Optional)

Vegetable drawer 1 or 2

Humidity Switch Opti Temp Zone (Optional) Fresh 0 Zone (Optional)

Door rack

NOTE

• Parts, features, and options vary by model. Your model may not include every option.

* The process of freezing occurs the fastest on the marked shelf.

Select a good

location

Disposal of the

old appliance

Introduction

Where to install

1. Place your appliance where it is easy to use.

2. Avoid placing the unit near heat sources, di-

rect sunlight or moisture. Do not operate the appliance outdoors where it can be exposed directly, or indirectly to sun, wind and rain.

3. To ensure proper air circulation around the

fridge -freezer, please maintain sucient space on both the sides as well as top and maintain at least 2 inches (5 cm) from the rear wall.

4. To avoid vibrations, the appliance must be

levelled.

5. Do not install the appliance in temperatures

of less than 5°C as the performance may be aected.

This appliance contains uid (refrigerant, lubricant) and is made of parts and materials which are reusable and/or recyclable. All the packaging materials should be sent to the collection centre for recycling. For details of your local recycling centre, please contact your local council.

Installation

Remove lower

cover and then

feed water

tube

Remove the

freezer

compartment

door

Door removal

Electric Shock Hazard Disconnect electrical supply to refrigerator before installing. Failure to do so could

result in death or serious injury. If your front door is too narrow to get

the refrigerator into the house, remove the refrigerator doors and pass the appliance through laterally.

Remove the lower cover by loosening all the screws. Then push in the feed water tube while depressing the connector , as shown in the illustration on the right.

NOTE

• If a tube end is deformed or abraded, trim the end with sharp knife until perfectly round.

1) Remove the hinge cover by loosening the screws. Then separate all connection wires except for the earth.

Upper hinge

2) Remove the keeper by rotating it counter clockwise ( ) and then lifting the upper hinge up ( ).

①

②

Applicable to No Plumbing

Ice & Water Model only

Feed water tube

Hinge cover

Keeper

Connection wires

Earth line

Upper hinge

Lower cover

Remove the

refrigerator

compartment

door

NOTE

• When removing the upper hinge, be careful that the door does not fall forwards .

3) Remove the freezer compartment door

by lifting it upward. The door should be lifted high enough for the feed water pipe tube to be completely pulled out.

NOTE

• If you have removed the refrigerator compartment door to pass the appliance through an access door, lay the door down, but be careful not to damage the feed water pipe tube.

1) Loosen the hinge cover screws and

remove the cover. Remove connection wires, if any, except for the earth line.

Connection

wires

Lower cover

Upper hinge

Enough for water feed pipe tube to be completly pulled out

Installation

Remove the

refrigerator

compartment

door

Pass the

refrigerator

2) Remove keeper by rotating it clockwise ( ) and then remove the upper hinge by lifting it up ( ).

3) Remove the refrigerator compartment door by lifting it up.

Pass the refrigerator laterally through

the access door as illustrated to the right.

①

②

Lower hinge

Keeper

Door replacement

Once the fridge is through the access door, remount the fridge doors by following the door removal instructions in reverse.

Before

installation

Warning

Feed water pipe installation (Dispenser model only)

▪Automatic ice maker operation needs water pressure of 147~834kPa

(1.5~8.5kgf/cm2) (The pressure is correct when an instant paper cup (180cc) is filled in 3 sec.).

▪If water pressure does not reach the rating 147kPa(1.5kgf/cm

is necessary to purchase a separate pressure pump for normal automatic icing and cool water feed.

▪Keep the total length of the feed water pipe tube within 8m and be careful that

the tube does not bend. If the tube is 8m or longer it may cause water feed problems owing to the drain water pressure.

▪Install the feed water pipe tube at a place free from heat. ▪Connect to drinking water supply only. ▪Refer to instructions with water lter kit for installation.

) or below, it

1. Use the adjustment tool to rotate the adjustment hinge pin in either

clockwise or counterclockwise direction to level the height of the refrigerator to that of the freezer.



Operation

Starting

When your refrigerator is first installed, allow it to stabilize at normal operating temperatures for 2-3 hours prior to filling it with fresh or frozen foods. If operation is interrupted, wait 5 minutes before restarting.

Adjusting the temperature and functions

*Non dispenser model

Refreshment Centre button (Optional)

Refreshment Centre (Optional)

Function display board

NOTE

• Your model may not include every option.

•The control display is touch operated. Excessive moisture on the display panel may

result in its malfunction. Please keep the display panel dry and clean.

1010

+ 22 hidden pages