Smeg ALFA31XE User Manual

Contents

1. INSTRUCTIONS FOR SAFE AND PROPER USE_______________ 19

2. INSTALLATION OF THE OVEN_____________________________ 21

3. DESCRIPTION OF CONTROLS ____________________________ 23

4. USE OF THE OVEN______________________________________ 24

5. CLEANING AND MAINTENANCE ___________________________ 29

6. REACTIVE MAINTENANCE________________________________ 31

INSTRUCTIONS FOR THE INSTALLER: these are intended for the qualified technician charged with installing the appliance, commissioning it and making a final test.

INSTRUCTIONS FOR THE USER: these contain advice for the user, description of the commands and the correct procedures for cleaning and maintenance of the appliance.

Introduction

1. INSTRUCTIONS FOR SAFE AND PROPER USE

THIS MANUAL IS AN INTEGRAL PART OF THE APPLIANCE AND THEREFORE MUST BE KEPT IN ITS ENTIRETY AND IN AN ACCESSIBLE PLACE FOR THE WHOLE WORKING LIFE OF THE OVEN. WE ADVISE READING THIS MANUAL AND ALL THE INSTRUCTIONS HEREIN BEFORE USING THE OVEN. INSTALLATION MUST BE CARRIED OUT BY QUALIFIED TECHNICIANS IN ACCORDANCE WITH THE REGULATIONS IN FORCE. THIS OVEN IS INTENDED FOR COMMERCIAL USE AND CONFORMS TO CURRENT CEE REGULATIONS IN FORCE. THE APPLIANCE HAS BEEN BUILT TO IMPLEMENT THE FOLLOWING FUNCTIONS: COOKING AND HEATING-UP OF FOOD. ALL OTHER USES ARE CONSIDERED IMPROPER.

THE MANUFACTURER DECLINES ALL RESPONSIBILITY FOR IMPROPER USE.

DO NOT LEAVE THE PACKING IN THE HOME ENVIRONMENT. SEPARATE THE VARIOUS WASTE MATERIALS AND TAKE THEM TO THE NEAREST AUTHORISED WASTE DISPOSAL CENTRE.

THE ELECTRICAL SYSTEM MUST BE GROUNDED IN ACCORDANCE WITH ESTABLISHED SAFETY REGULATIONS.

WHEN HOOKING UP TO THE MAINS WITH A PLUG AND SOCKET, MAKE SURE THAT BOTH ARE COMPATIBLE AND CONNECT BY MEANS OF A POWER CABLE COMPLYING WITH APPLICABLE REGULATIONS.

NEVER UNPLUG BY PULLING ON THE CABLE.

DO NOT OBSTRUCT VENTILATION OPENINGS AND HEAT DISPERSAL SLITS.

IMMEDIATELY AFTER INSTALLATION CARRY OUT A BRIEF INSPECTION TEST OF THE OVEN, FOLLOWING THE INSTRUCTIONS BELOW. SHOULD THE APPLIANCE NOT FUNCTION, DISCONNECT IT FROM THE POWER SUPPLY AND CONTACT THE NEAREST TECHNICAL ASSISTANCE CENTRE. NEVER ATTEMPT TO REPAIR THE APPLIANCE.

Introduction

ALWAYS CHECK THAT THE CONTROL KNOBS ARE IN THE 0 (OFF) POSITION WHEN YOU FINISH USING THE OVEN.

NEVER PUT FLAMMABLE OBJECTS IN THE OVEN: THEY MAY IGNITE ACCIDENTALLY AND CAUSE FIRES.

THE APPLIANCE BECOMES VERY HOT DURING USE. WEAR HEATPROOF GLOVES AT ALL TIMES.

THE I.D. PLATE WITH TECHNICAL DATA, REGISTRATION NUMBER AND BRAND NAME IS LOCATED IN AN EXPOSED POSITION AT THE REAR OF THE OVEN.

THE PLATE MUST NOT BE REMOVED.

THE APPLIANCE IS INTENDED FOR COMMERCIAL USE BY APPROPRIATELY TRAINED PERSONNEL. CHILDREN SHOULD

ALWAYS BE KEPT AWAY FROM IT AND NEVER BE ALLOWED TO PLAY WITH IT.

BEFORE USE, THE OVEN DISHES MUST BE WASHED WITH A SUITABLE DISHWASHING DETERGENT (DO NOT USE ABRASIVE PRODUCTS).

THE OVEN IS SIZED FOR A MAXIMUM LOAD OF 3.5 KG.

THIS APPLIANCE IS MARKED ACCORDING TO THE EUROPEAN DIRECTIVE 2002/96/EC ON WASTE ELECTRICAL AND ELECTRONIC EQUIPMENT (WEEE). THIS GUIDELINE IS THE FRAME OF A EUROPEAN-WIDE VALIDITY OF RETURN AND RECYCLING ON WASTE ELECTRICAL AND ELECTRONIC EQUIPMENT.

BEFORE THE APPLIANCE IS PUT INTO OPERATION, ALL THE LABELS AND PROTECTIVE FILMS APPLIED INSIDE OR OUTSIDE MUST BE REMOVED.

The manufacturer declines all liability for damage to persons or things caused by non-observance of the above prescriptions or by tampering with any part of the appliance or by the use of non-original spares.

Instructions for the installer

2. INSTALLATION OF THE OVEN

The oven must be set up on a perfectly flat surface and left standing free. Make sure to allow enough room at the back for easy access to the terminal block for connection of the power cable to the mains. Installation must be carried out by a qualified technician in compliance with the applicable CEE regulations in force.

2.1 Electrical connection

Make sure that the power line voltage matches the specifications indicated on the rating plate located to the rear of the oven. This rating plate must never be removed. The oven is fitted with a H07RN-F three-core cable for operation at 230V~ and a power supply plug.

The standard cable is of the three-core 3 x 1.5 mm2 H07RN-F type. If necessary, the power lead must be changed by the manufacturer or by an authorised service centre to prevent any risks.

Make sure that plug and wall socket are of the same type and are in conformity with CEI regulations in force. Also check that the power supply line is provided with an adequate ground plant. Avoid using adapters or shunts.

2.1.1 Safety thermostat

The oven is fitted with a safety device which trips in case of serious malfunction. To reset, contact the nearest service centre.

The manufacturer declines all liability for damage to persons or things caused by non-observance of the above prescriptions or by tampering with any part of the oven.

Instructions for the installer

2.2 Levelling

Adjust the four feet so as to level the oven. To do this, loosen the lock nut and unscrew the foot. The range of adjustment of the screw is 10 mm.

2.3 Steam exhaust pipe

An exhaust pipe is fitted on the back of the oven to allow the discharge of steam during cooking. Make sure that it is not obstructed in any way and take care do not crush it.

+ 10 hidden pages