SMC Networks SMCSR01Z1 User Manual

I/M SMCSRXX-Z rev. 2.2 6/20/2012

Input Voltage:

110 VAC to 240 VAC 60 Hz

Peak Input Amp:

Max Wattage:

15W

Power Limited Peak Output Voltage:

Power Limited Peak Output Amp:

3A Backup Battery Duration:

>24 hrs

Nominal Battery Voltage Range:

3.4V to 4.1V Maximum Battery Voltage:

4.2V

Operating Temperature:

32F to 104F (0C to 40C)

Storage Temperature:

14F to 140F (-10C to 60C)

Battery Storage Temperature:

-20C to 60C (1 week max)

-20C to 45C (3 week max)

-20C to 20C (1 year max)

Recommended Battery Storage Temperature:

20C +/- 2C Operating Relative Humidity:

10% to 90% noncondensing

Storage Relative Humidity:

5% to 95% noncondensing

Enclosure Dimensions:

3.81"L x 2.16"W x 1.58 H (97 mm x 55 mm x 40.3 mm)

Max Volume:

>85dB per UL measurement

Compatible Control Unit(s):

RB5701-Z XXX

SMC Wireless Siren ZigBee Range Extender Guide

Congratulations on purchasing your SMC ZigBee Siren Repeater

The SMC ZigBee Wireless Siren Repeater is a multipurpose fire and burglar alarm signaling device that performs two main functions in the SMC home-security product lineup. It emits sound at levels greater than 85dB, loud enough to provide an audible alert and scare intruders. It also increases the range of your RB5701-Z Homes Security and Automation Gateway wireless remote controls, motion sensors, and security products by boosting and retransmitting the RF signals it receives from those products.

continued on next page

White LED Strobe Light

Green, Red Amber Status LEDs

1 Models

The SMC Siren Repeater comes in two versions:

 SMCSR01-Z (North American version) 

includes an Electrical Outlet Mounting Tab (see Figure 2 on page 2)

 SMCSR01-Z CA (Canadian version)  no

provisions for securing device to an electrical outlet

2 Parts List

 Battery Cover and Screw  (2) rubber pads  Battery  Tamper Switch

NA version only:

 (3) plastic washers  Electrical outlet screw

3 Package Contents

The package comes with a wall-mounting kit containing 1 SMCSR01-Z and 2 tamper button rubber pads. A lithium polymer rechargeable battery is located inside the battery compartment. The NA version includes 3 plastic washers and a longer electrical outlet screw.

4 Specifications

5 Key Components

Figure 1. Front View

SMC Wireless Siren ZigBee Range Extender Guide

I/M SMCSRXX-Z rev. 2.2 5/20/2012

Electrical Outlet Mounting Tab (NA version only)

AC Receptacle

Tamper Switch

Battery Cover

& Screw

continued on next page

Figure 2. Rear View

6 Precautionary Statements

Battery Precautions

DO NOT dismantle, open, or shred the battery. The battery should be dismantled only by trained personnel.

DO NOT short-circuit the battery. DO NOT store the battery haphazardly in a box or drawer

where they may short-circuit each other or be short-circuited by conductive materials.

DO NOT expose the battery to heat or fire. Avoid storage in direct sunlight

DO NOT subject the battery to mechanical shock.

DO NOT use any other charger other than the one built into the SMCSR01-Z.

DO NOT use any other battery that is not designed for use with this product.

Seek medical attention if a battery has been swallowed.

Wipe the battery clean with a dry cloth if the battery becomes dirty.

Test the Siren Repeater at least once a week:

A. Disconnect the Siren Repeater from the

mains electrical power source, so the Siren Repeater is running in battery mode.

B. After 24 hours in standby mode, perform an

alarm system test. The Siren Repeater should sound for 4 minutes before shutting off. If it does not remain in standby mode for 24 hour or does not sound for the full 4 minutes after 24 hour standby, the battery must be replaced.

Device Precautions

Proper device operation depends on proper installation, usage, and maintenance of the device.

The North American model (SMCSR01-Z) has provisions to secure the Siren Repeater to an electrical outlet using the electrical mounting tab inherent in the design of this model.

Canadian regulations and safety standards forbid the use of such device. The Canadian model (SMCSR01-Z CA) does not have the electrical outlet mounting tab necessary to secure the device to an electrical wall outlet. If you received a device that has an electrical outlet mounting tab and this product is to be used in Canada, please contact the distributor or retail location where this device was purchased and obtain the Canadian model (SMCSR01-Z CA).

The battery is a lithium rechargeable battery. Do not drop, crush, incinerate, or damage in any form.

Note: DO NOT CONNECT TO A RECEPTACLE

CONTROLLED BY A SWITCH.

This system must be tested by a qualified technician at least once every three (3) years.

Install the system in accordance with Chapter 2 of the National Fire Alarm Code, ANSI/NFPA 72, (National Fire Protection Association, Batterymarch Park, Quincy, MA 02269.)

Return the device to an authorized distributor or to SMC Networks Inc., 20 Mason, Irvine, CA 92618 for servicing or repair in case of malfunction.

SMC Wireless Siren ZigBee Range Extender Guide

I/M SMCSRXX-Z rev. 2.2 6/20/2012

continued on next page

7 Selecting a Location

The Siren Repeater lets you extend the range of your home security system to accommodate longer distances and broaden your security coverage. As a result, select a location that has average signal strength and resides between the Touchscreen and the furthest sensor, such as a gameroom or bedroom, to boost the wireless signal strength for sensors located furthest from the Touchscreen.

The number, thickness, and location of walls, ceilings and other objects that the signals must pass through may limit the range of the Range Extender. Typical ranges vary, depending on the types of materials and background radio frequency (RF) noises in your home or business.

To maximize your range:

 Keep the number of walls and ceilings

between the Touchscreen and the Siren Repeater to a minimum.

 Position a direct line between the key pad

and the Range Extender, so the signal will travel straight through a wall or ceiling.

 Consider angles when placing the Range

Extender. For example, a wall that is 1.5 feet thick (.5 meters) at a 45°angle appears to be almost 3 feet (1 meter) thick; however, at a 2°angle, it looks over 42 feet (14 meters) thick.

 Position the Siren Repeater to receive the

wireless signal through drywall or open doorways and not other materials. Building materials such as a solid metal door or metal studs can impede the wireless signal and may have a negative effect on the wireless range. When it is necessary to work with these limitations, more SMC Wireless Siren ZigBee Range Extenders can be used to improve signal strength for the whole premise.

their own radio signals, such as wireless routers and access points.

Other locations where the Siren Repeater can be placed include:

 Centrally located areas  Family rooms  Living rooms  Game rooms  Bedrooms of children that are hard to

wake in the event of fire

8 Preparing the Siren

A. Use a Phillips #1 (PH1) screwdriver to remove

and set aside the screw securing the battery cover. Next remove and set aside the cover. The device battery is inside.

 Keep the Siren Repeater at least 3-to-6 feet

(1-to-2 meters) away from electrical devices or appliances that generate extreme RF noise.

 Keep the Siren Repeater at least 3-to-6 feet

(1-to-2 meters) away from devices that emit

+ 4 hidden pages