USER GUIDE
EZ Connect
56K Internal V.92 Data/Fax/Voice PCI Modem
TM
SMC3056IM V5
SMC3056IM V5
56K Analog Modem User Manual
Apr., 2008
Copyright
Information furnished by SMC Networks, Inc. (SMC) is believed to be accurate and reliable.
However, no responsibility is assumed by SMC for its use, nor for any infringements of
patents or other rights of third parties which may result from its use. No license is granted by
implication or otherwise under any patent or patent rights of SMC. SMC reserves the right to
change specifications at any time without notice.
Copyright © 2008 by
SMC Networks, Inc.
20 Mason
Irvine, CA 92618
All rights reserved. Printed in Taiwan
Trademarks:
SMC is a registered trademark; and EZ Connect is a trademark of SMC Networks, Inc. Other
product and company names are trademarks or registered trademarks of their respective
holders.
1
Disclaimer
This company makes no representations or warranties, either expressed or implied, with
respect to the contents hereof and specifically disclaims any warranties, merchantability or
fitness for any particular purpose. Any software described in this manual is sold or licensed
"as is". Should the programs prove defective following their purchase, the buyer (and not
this company, its distributor, or its dealer) assumes the entire cost of all necessary servicing,
repair, and any incidental or consequential damages resulting from any defect in the software.
Further, this company reserves the right to revise this publication and to make changes from
time to time in the contents hereof without obligation to notify any person of such revision or
changes.
Caution
This device complies with part 15 of the FCC rules. Operation is subject to the following two
conditions.
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause
undesired operation.
Per FCC 15.21, you are cautioned that changes or modifications not expressly approved by the
part responsible for compliance could void the user’s authority to operate the equipment.
2
Contents
1.Introduction ………………………………………………………………4
1.1 System Requirements………………….………………………………………............ 4
1.2 Package Contents……………………………………………………………………. 4
1.3 Specifications…………………………………………..……………………………...5
2. Hardware Installation Instructions………………………………………….. 5
2.1 PCI Interfaced Analog Modem Card…………………………………..…………….. 5
3. Software Driver Installation………………………………………………… 6
3
1.Introduction
Fax Modem Installation CD is an All-In-One installation utility for both internal and external
Data, Fax, Voice/Fax and Voice/Fax with Speaker Phone Analog Modems. It automatically
detects and installs recently installed modem hardware under Windows 2000, XP and Vista.
This utility includes Install Driver, Install Software Utilities, User Manual and Readme four
sections. Click Install Driver to start analog modem device driver installation process. Install
Software Utilities includes “FAXTALK Communicator SE” (all modem software driver
installation program) and Adobe Reader. User Manual includes this user’s manual and specs
for all modems this utility supports. Readme includes modem software driver locations and
modem hardware installation instructions.
1.1 System Requirements
Pentium 100 MHz CPU or faster
32 MB system memory or more
10 MB free space on your hard drive
256-color VGA or higher resolution
CD-ROM drive
One available PCI slot for internal modem
Microsoft Windows 2000, XP, or Vista operating system
1.2 Package Contents
One internal/external Analog Modem
One RJ-11 Cable
Fax Modem Installation CD CD-ROM disk
Quick Installation Guide
If any of above items is missing or damaged, please contact your local dealer immediately.
4
1.3 Specifications
Data Transfer Rates Up to 56 Kbps download and 48 Kbps upload
Data Mode
Data Compression ITU-T V.44, V.42 bis/MNP 5
Error Correction ITU-T V.42/MNP 2-4
Fax Transfer Rates Up to 14.4 Kbps send and receive
Fax Mode
Voice Mode Telephone Answering Machine (TAM), DTMF detection & generation
Video Mode H.324, V.80 (Video Conference Protocol)
Media Connector RJ-11 x 2
Interface PCI V2.3
Power Consumption 0.1W
Dimensions (app.) 122mm (length) x 42mm (width) x 15mm (height)
Net Weight (app.) 65g
Operating Temperature 0°C ~ 70°C(ambient)
Humidity 5 % ~ 95 % (non-condensing)
Storage Temperature -20°C ~ 70°C
Supported OS Windows 2000, XP 32/64bits, Vista 32/64bits
Minimum System
Requirements
Regulations FCC part 15, part 68, CE, CTR21
ITU-T V.92, V.90, V.34, V.32 bis, V.32, V.22 bis, V.22, V.23, V.21,
Bell 212A and Bell 103
ITU-T V.17, V.29, V.27 ter, V.21 Ch2, modulation modes
EIA/TIA 578 Class 1 and T.31 Class 1.0 commands
Pentium compatible processor 233 MHz and above
Minimum 8 MB RAM
Minimum 30 MB available hard disk space
CD-ROM drive
One PCI slot
2. Hardware Installation Instructions
2.1 PCI Interfaced Analog Modem Card
1) Open PC case and insert PCI Card into an available PCI slot.
2) Close PC case, and then plug one end of RJ-11 cables into modem’s LINE jack and the
other end into telephone wall jack.
5
3. Software Driver Installation
Insert FAX Modem Installation CD into CD-ROM drive then window below will appear.
Install Driver: Click Install Driver to start analog modem installation process.
Install Software Utilities: Install Software Utilities includes “FAXTALK Communicator SE”
(all modem software driver installation program), and Adobe Reader (Version 6.0 for Windows
2000 and Version 8.0 for Windows XP/Vista).
User Manual: User Manual includes this user’s manual and specs for all modems this utility
supports.
Readme: Readme includes modem software driver locations and modem hardware installation
instructions.
Step 1: When Windows boots up, operation system will detect the LAN card and Found New
Hardware window will appear. Click Cancel.
6
Step 2: Insert Fax Modem installation CD into CD-ROM drive. The installation CD will
auto-run and show the main screen as below.
Step 3: Click Install Driver to start the modem installation, window below will appear.
Step 4: After Fax Modem Installation Utility finishes installing corresponding analog modem
device driver, window below will appear. Click OK to complete the installation
process.
7
Step 5: Click Exit to close FAX Modem Installation Utility.
Step 6: To check if modem is properly installed:
For Windows Vista
Right-Click “My Computer Properties Choose “Device Manager”
8
For Windows XP
Right-Click “My Computer Properties Hardware Choose “Device Manager”
For Windows 2000
Right-Click “My Computer Properties Hardware Choose “Device Manager”
9
TECHNICAL SUPPORT
From U.S.A. and Canada (24 hours a day, 7 days a week)
Phn: (800) SMC-4-YOU / (949) 679-8000
Fa x: ( 94 9) 67 9-1 4 81
English: Technical Support information available at www.smc.com
English(For Asia Pacific): Technical Support information available at
www.smc-asia.com
Deutsch: Technischer Support und weitere Information unter www.smc.com
Español: En www.smc.com Ud. podrá encontrar la información relativa a servicios
de soporte técnico
Français: Informations Support Technique sur www.smc.com
Português: Informações sobre Suporte Técnico em www.smc.com
Italiano: Le informazioni di supporto tecnico sono disponibili su www.smc.com
Svenska: Information om Teknisk Support finns tillgängligt på www.smc.com
Nederlands: Technische ondersteuningsinformatie beschikbaar op www.smc.com
Polski: Informacje o wsparciu technicznym sa dostepne na www.smc.com
Čeština: Technicka podpora je dostupna na www.smc.com
Magyar: Műszaki tamogat informacio elerhető -on www.smc.com
简体中文:技术支持讯息可通过www.smc-prc.com查询
繁體中文:產品技術支援與服務請上 www.smcnetworks.com.tw
ไทย: สามารถหาข้อมูลทางด้านเทคนิคได้ที่ www.smc-asia.com
한국어: 기술지원관련 정보는 www.smc-asia.com을 참고하시기 바랍니다
INTERNET
E-mail address: techsupport@smc.com
Driver updates
http://www.smc.com/index.cfm?action=tech_support_drivers_downloads
World Wide Web
http://www.smc.com/
20 Mason • Irvine, CA 92618 • Phn: (949) 679-8000 • www.smc.com
SMC3056IM V5
Loading...