Smc 7908VOWBRA Configuration Guide

1. To setup VoIP function, you need to collect VoIP configurations from your VoIP Service Provider:

• Phone number

• Gatekeeper IP address

• Password if security feature is required

Note: Optionally there are “Gatekeeper ID” and “H.323 ID” for additional security

2. Go to web interface under “VoIP” submenu “Port Setting”, change the “Extension Number:” to the phone number
collected from your VoIP Provider, then click “OK”

3. In the VoIP Provider Mode page, put the Gatekeeper IP address into “IP Address:”.

4. “Gatekeeper ID:” and “H.323 ID” are optional if they are available from your VoIP Provider

5. Click “OK” to save changes.

Note: If security feature is required by your VoIP Provider, select the “HMAC-SHA1-96 Authentication Only” mode in the
“Security:” drop-down menu. Also put in password into “Password:” field

6. If you encounter problems after entering the requested
parameters, please do the following:

• verify that the router is online, if not please refer to the

troubleshooting section of the QIG

• if the router is online, you should verify the different VoIP

parameters

• then consult the VoIP status page and write down the error

message

• contact VoIP provider to verify that their server is working

and the parameters are correct, then give them the error
message you get

SMC7908VoWBRA

VoIP Configuration Guide for H.323

SMC7908VoWBRASMC7908VoWBRASMC7908VoWBRA