Smart Technologies 710.0026 User Manual

REFERENCE ONLY

SmarTire LF Initiator Tool

PN: 710.0026

Revision 1.2

Instruction Manual

© Copyright 2006
SmarTire Systems Inc.

Duplication of this document in whole or in part for any purposes other than those for which it was originally
intended, without the written approval of SmarTire Systems Inc. is strictly prohibited.

This manual may be changed by SmarTire Systems Inc. at any time and without notice.

REFERENCE ONLY

TABLE OF CONTENTS

INTRODUCTION ................................................................................................................................3

OVERVIEW.........................................................................................................................................3

LED FUNCTIONS...............................................................................................................................4

GETTING STARTED..........................................................................................................................4

USING THE LF INITIATOR................................................................................................................4

PROGRAMMING SENSOR ID NUMBERS........................................................................................5

VERIFYING CORRECT INSTALLATION..........................................................................................6

SMARTIRE PRODUCT & SERVICE PART WARRANTY:EFFECTIVE NOVEMBER 15, 2005.......7

710.0026 R1.2 SmarTire LF Initiator Operating Instructions

2

REFERENCE ONLY

INTRODUCTION

The SmarTire LF Initiator is a handheld tool designed to provoke data transmissions from SmarTire
High Pressure Sensors. The tool can be used to assist the installer during:

• New Installations – programming sensor ID numbers & vehicle configuration into the
receiver

• Sensor Replacement - programming new sensor ID numbers into the receiver

• Installation Verification (without moving vehicle)

• Transmitter De-Activation (after removal)

NOTE: The SmarTire LF Initiator is compatible with SmarTire’s low and high pressure
commercial sensors ONLY. It is not compatible with the low pressure sensors used in
SmarTire products for passenger vehicles, motorcycles, trailers and tow-behinds.

OVERVIEW

Transmission End

LED Light

Initiate Button
De-Energize Button
Learn Button

On / Off Switch

Battery Cover

Initiate: Press this button to make a sensor transmit its ID number, tire pressure data and tire
temperature data. This function is used when confirming that sensors are installed in the correct
wheel locations on a vehicle after system installation.

De-energize: Press this button to de-activate a sensor. This function should only be used when
sensors are removed from a vehicle.

710.0026 R1.2 SmarTire LF Initiator Operating Instructions

3