SmartRG SR616A User Manual

Quick Start Guide

SR616ac

This Quick Start Guide shows you how to set up and start using your new gateway.

Installation

1. Connect one end of the included phone cable to the DSL port on the gateway and connect the other end to the
wall jack.

2. Connect one end of an Ethernet cable to a LAN port of the gateway and connect the other end to your PC.

3. Plug the power adapter into the wall outlet and connect the other end of it to the Power port of the gateway.

4. Turn on the unit by pressing the On/Off button on the left side of the gateway.

Your gateway is now automatically being set up to connect to the Internet. This process may take a few minutes to com­plete before you can begin using your Internet applications (browser, email, etc.).

Notes:

l If you use 3G WAN service, connect the 3G USB data card to the USB port of the gateway. If you use the Ethernet

uplink, connect to the WAN port with an Ethernet cable.

l You cannot use the xDSL uplink, 3G WAN service, and Ethernet uplink at the same time.

If you are unable to connect to the Internet, confirm that all connections are in place and the gateway is turned on.

3

LED INDICATORS

The LEDs on the front of the SR616ac gateway can help you

understand the current state of your adapter.

Legend:

LED Action Explanation

AllLEDs

those listed below

POWER

WAN

LAN

except

White

White blinking

Feature enabled &/or working corr ectly

Data being transferred

Device in CFE mode

Device powered on and ready for use

WAN connection active

LAN connection active

Data being transferred

Red Green

Green blinking

QUICK GATEWAY CONFIGURATION

Warning: Do not press the Reset button unless you want to clear the current settings. The Reset button is in a small cir-

cular hole on the rear panel. If you want to restore the default settings, insert a thin wire (such as a paper clip) into
the hole, press the Reset button for 1 second, and then release the button. The system reboots and returns to the fact­ory defaults.

Logging in to your gateway

To change the settings on your gateway, you must log in to the gateway's interface. Make sure that you have completed
the steps in "Installation" on page 2 before you begin.

1. Open your internet browser application and type 192.168.1.1 into the address line. The login dialog appears.

2. Enter the factory default credentials shown below and click Log In.

User Name: admin Password: admin

Note: Your service provider may use other settings. Contact your provider for details.

5