Smartab ST706, ST706-SM, ST706-DG User Manual

ST706 / ST706-DG / ST706-SM

Android system recovery screen

Factory Data Reset

Please note: this will erase all data on the tablet including the password settings, any saved apps, photos, videos and any
other saved information. Once finished, the tablet will be restored to factory default settings including all factory
preinstalled apps. Any apps you have purchased and/or downloaded to the tablet will need to be reinstalled manually
when finished.

IMPORTANT: Make sure you have charged the tablet for at least one hour before performing this reset.

NOTE: Some screenshots below may differ slightly depending on which model tablet you are using. The choice

selection will be the same.

1. Make sure the tablet is powered OFF. You can double check this by quick-pressing the power button to see if the

tablet is still powered on.

2. Press and HOLD the [POWER] and [Vol +] buttons together for five full seconds then release both at the same

time. Wait for the Android system recovery screen to show:

3. Use the [Vol -] button to scroll through the selections. Scroll to option "wipe data/factory reset" then press the

[POWER] button to confirm the selection. Wait for the Confirm wipe screen to show:

Android system recovery utility screen

Confirm wipe screen

4. Use the [Vol -] button to scroll to "Yes ", then press the [POWER] button to confirm the selection. Wait for the

Android system recovery utility screen to show:

5. Use the [Vol -] button to scroll to "Reboot system now”, then press the [POWER] button to confirm the

selection.

6. The tablet will power down then back on and the SmarTab logo will show. The tablet will take a few minutes to

reload the original factory settings. DO NOT press anything on the tablet while this is happening. Wait for the

Welcome screen to show: