SkyLink CG5 User Manual

MultiLink

®

MINI GARAGE DOOR REMOTE
WITH FLASH LIGHT

MODEL : CG5

1. INTRODUCTION

Thank you for your purchase of the MultiLink® garage door remote control,
Model CG5. This remote is designed to work with the Chamberlain
“Security +”, Genie® “Intellicode” and Chamberlain® Billion code. This
remote is also capable to operate the mentioned brands garage door
opener with the newer 315MHz garage door openers or the older one at
390MHz. Please follow the details instructions below in order to setup the
new transmitter to work with your existing opener.

2. SELECT THE FREQUENCY

Check with your garage door opener to determine it is

Brand Frequency
Chamberlain® with learn button color: Purple 315MHz
Chamberlain® with learn button color: Green, White,

Grey, Yellow

Chamberlain® with learn button color: Orange, Red 390MHz

®

Genie

390MHz

Either 315MHz or 390MHz
(check on your garage door
opener)

The default frequency setting is at 390MHz. Follow the procedure
below to change this frequency setting.

1. Open up the case with a coin.

2. Remove the frequency jumper.

3. Secure the frequency jumper to
the 2 connector posts.

4. Table below shows the frequency
setting with different jumper
configurations.

315MHz

390MHz

®

3. SELECT THE BRAND (CONT)

Once you have setup the frequency and brand setting of your remote
control, following the instructions below to learn the remote to your
garage door opener.

4. PROGRAMMING

You should find a “learn” button from your existing garage door opener
(the unit with the motor located on the ceiling of your garage). Press and
hold this “Learn” button for 2 seconds and then release. The LED light
located beside the ‘Learn’ button will go on. Then press the garage door
button on your new transmitter for 1 second and then release to activate
it. The LED light on your existing
garage door opener will flash then
go off. Your remote control is now

Garage Door

Opener (GDO)

programmed to your existing garage
door opener and will operate your
garage door.

‘Learn’ Button

5. TROUBLESHOOTING

If the garage door cannot be activated, check the followings:

- The red light LED should come on when the button is pressed, if not,
check the battery and its polarity, ensure it is inserted properly.

- Repeat programming again to ensure the new transmitter is programmed.

6. OPERATION

Press and hold the plastic case
where it marks “PRESS” to
activate the flash light.

®

Garage Door
Button

Press the garage door opener
button will activate your garage
door.

Jumper (connected at right 2 posts) 315MHz

Jumper (connected at left 2 posts) 390MHz

3. SELECT THE BRAND

Depends on what brand of garage door opener you have, the brand
jumper setting is different. The brand jumper setting is the red jumper
next to the battery.

Brand Brand jumper setting
Chamberlain® with learn button color: Purple, Orange, Red

Chamberlain® with learn button color: Green, White,
Grey, Yellow

®

Genie

1 2 3 4 1 2 3 4 1 2 3 4

Posts 1 & 2 Posts 2 & 3 Posts 3 & 4

Connecting Jumper on
posts 1 & 2

Connecting Jumper
on posts 3 & 4

Connecting Jumper on
posts 2 & 3

7. BATTERY

Positive "+"
Up

One 3 volt Lithium type (CR2032)
battery is included.

Replacing the battery.

1. Open the case with a corn.

2. Slide the old battery away from the battery holder.

3. Slide in the new battery with the positive (+) side facing up.

4. Firmly close the case.

8. WARNING

If this transmitter triggers other garage doors in your neighborhood,
change all your transmitters and receiver to a new code setting.

DO NOT let children use the garage door
transmitter without adult supervision.
Children can injure themselves or others
by the garage door.

9. FCC

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) This device must accept any interference
received, including interference that may cause undesired operation.

WARNING:

Changes or modifications to this unit not expressly approved by the party responsible for compliance could
void the user’s authority to operate the equipment.

NOTE:

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications.

However, there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

- Consult the dealer or an experienced radio/TV technician for help.

10. WARRANTY

If, within one year from date of purchase, this product should become defective
(except battery), due to faulty workmanship or materials, it will be repaired or
replaced, without charge. Proof of purchase and a Return Authorization are required.

1 1. CUSTOMER SERVICE

Skylink will not be held liable or responsible for any misuse or application of this
product other than for its intended use.

If you would like to order Skylink’s products or have difficulty getting them to
work, please :

If you would like to order Skylink’s products or have difficulty getting them to work,
please :

1. visit our FAQ section at www.skylinkhome.com , or

2. email us at [e-mail] , or

3. call our toll free at 1-800-304-1187 from Monday to Friday, 9 am to 5 pm EST.
Fax [phone]

CUSTOMER SERVICE

17 Sheard Avenue, Brampton, Ontario, Canada L6Y 1J3
Email: [e-mail]
http://www.skylinkhome.com
P/N 101A424
© 2006 SKYLINK GROUP
® are registered trademarks of their respective corporations