Skutch Electronics AS-703-M User Manual

Thank you for purchasing the Skutch AS703M Promotion-On-Hold
Module. With this Module, all calls that are placed "ON HOLD" will hear
the Promotion-On-Hold audio. When the call is re-answered, the audio will
automatically disconnect.

• Switch Selection

The first step is to set the SWITCH on the front panel of the AS703M so
that it will work with your model of telephone. We suggest that you use a
ball point pen to change the switch settings.

For: AT&T 944, 955, and 964: IBM/Bell 412, 412CID & 4900

1 2

ON

Lines 1&2

Lines 3&4

Installation Diagram

LINES
3 & 4

IN

Connect to Headpho ne
Jack or 8 ohm output

Audio
Source

Lines 1&2

SWITCH

For AT&T 843,853,854,874,953,& 954

1 2

For Radio Shack #43-461(Model 612) and #43-463 (Model 212).

1 2

ON

ON

RCA Plug

To Skutch Box

1/8" Head Phone Plug

When a line is placed "ON HOLD", the corresponding LED on the
AS703M will light indicating that audio is being coupled to that telephone
line. The unit will play audio to all calls that are placed ON HOLD. Make
sure that you adjust the level of the music to the proper level on the audio
source.

• Troubleshooting Guide

No Audio But The Lights Turn On The AS-703M

! Make sure the Message Source is playing.
! Make sure the Message Source volume is turned up.
! Make sure that the audio cable is connected from the headphone

jack on the Audio Source, to the AUDIO IN jack on the AS-703M.

! Make sure the audio cable has the right plug for the AS-703M

(male RCA type).

! Make sure you are NOT using a "Dubbing" audio cord.
! Try reprogramming the station ID's for each of the phones, start

with 22 and go down from there.

Music does not always shut OFF or turn ON.

! Re-program the STATION ID number in EACH telephone.

• Tech Support - 916-786-6186

If you have any problems getting the unit to work properly feel free to
give us a call. Technical Support is available between the hours of 7:30 AM
and 4:30 PM Pacific Time, Monday through Friday.

• ONE YEAR LIMITED WARRANTY

This SKUTCH PRODUCT is warranted against defects for a period of
one (1) year from the date of the original invoice. Within this period, we will
repair it without charge for parts and labor. To obtain warranty service the
product must be returned, at the customer's expense, to SKUTCH Electronics
along with a copy of the original invoice. After the unit has been repaired,
SKUTCH will ship the PRODUCT back via UPS GROUND service at our
expense. If any other form of return shipment is requested, the customer will
pay for 100% of the shipping cost.

This Warranty does not apply if in the sole opinion of SKUTCH
Electronics, the PRODUCT has been damaged by lightning or any other Acts
of God, or by accident, misuse, neglect, or improper packing, shipping,
modification or servicing by other than an authorized SKUTCH Service
Center.

EXCEPT AS SPECIFICALLY PROVIDED IN THIS AGREEMENT,
THERE ARE NO OTHER WARRANTIES, EXPRESSED OR IMPLIED,
INCLUDING, BUT NOT LIMITED TO, ANY IMPLIED WARRANTIES
OR MERCHANTABILITIES OR FITNESS FOR A PARTICULAR
PURPOSE AND IN NO EVENT SHALL SKUTCH ELECTRONICS BE
LIABLE FOR LOSS OF PROFITS OR BENEFITS, INDIRECT, SPECIAL,
CONSEQUENTIAL OR OTHER SIMILAR DAMAGES ARISING OUT
OF ANY BREACH OF THIS WARRANTY OR OTHERWISE.

"Telecommunication Products to solve Telecommunication Problems"

LINES
3 & 4

IN

1 2

ON

AS-703M

Four Line Promotion-On-Hold Module

V1.00