Skutch Electronics AS-27 User Manual

• Introduction

• Operation

The AS-27 is a High Performance Telecommunications Cycling
Tester/Telephone Single Line Simulator. The main purpose of the AS-27 is
to let you thoroughly test your Telecommunication Devices before you sell
them in order to minimize the chance of your customers finding problems, in
the systems they purchase from you, that could have easily been discovered
and corrected, by you, without causing any hassle for your customers.

The AS-27 connects easily, via modular connectors, to your
Telecommunication Device. Just place the switch on the unit to the CYCLE
position and the unit will "RING UP" your Telecommunication Device, wait
for your system to "HANG UP", and then wait three seconds and repeat the
process. You can also add an audio signal, as part of the test, through the
AUDIO in/out jack on the AS-27. Should you need to perform more
complicated testing, involving the use of touch tones, etc., just place the
switch on the unit to the NORMAL position and connect a telephone to the
TELEPHONE jack on the unit. The AS-27 will start a call sequence (with
optional DIAL TONE before dialing) as soon as you take your telephone
"OFF HOOK"; and it also provides a "WINK" disconnect to your system
when you "HANG UP" your telephone. When the AS-27 starts to "RING
UP" the Telecommunication Device, the unit will provide a simulated RING
BACK signal, to the telephone during each ring phase. The AS-27 provides
you with a Bi-Directional AUDIO jack for recording HIGH QUALITY
AUDIO into a Telecommunication Device.

Single Test Calls

•

1) Place the switch on the AS-27 to NORMAL.

2) Take your telephone "OFF HOOK".

3) If set, you will get 5 seconds of DIAL TONE.

4) The other side will "RING UP" and activate, you can do everything as
you normally would.

5) When you are finished, just hang up the phone.

Cycle Your System

•

1) Place the switch on the AS-27 to CYCLE.

2) The AS-27 will call the system, wait for it to hang up, wait 3 seconds and
then repeat.

Turn On Simulated Dial Tone

•

3) The AS-27 is factory set to NOT supply DIAL TONE, so this option
needs to be turned on to use it. Open the AS-27 (remove 4 screws from
lid).

4) Find the jumper labeled J1.

5) Pull the shorting block off of J1 then put it on the ON position.

6) Close the AS-27.

• Installation

Norm al

Cycle

AS-27

Te lephone Line SimulatorA udio

Head

Phones

Voic e CardTelephone

Optional

Message S ource

• Tech Support - 916-786-6186

If you have any problems getting the unit to work properly feel free to
give us a call. Technical Support is available between the hours of 7:30 AM
and 4:30 PM Pacific Time, Monday through Friday.

• ONE YEAR LIMITED WARRANTY

This SKUTCH PRODUCT is warranted against defects for a period of
one (1) year from the date of the original invoice. Within this period, we will
repair it without charge for parts and labor. To obtain warranty service the
product must be returned, at the customer's expense, to SKUTCH Electronics
along with a copy of the original invoice. After the unit has been repaired,
SKUTCH will ship the PRODUCT back via UPS GROUND service at our
expense. If any other form of return shipment is requested, the customer will
pay for 100% of the shipping cost.

This Warranty does not apply if in the sole opinion of SKUTCH
Electronics, the PRODUCT has been damaged by lightning or any other Acts
of God, or by accident, misuse, neglect, or improper packing, shipping,
modification or servicing by other than an authorized SKUTCH Service
Center.

EXCEPT AS SPECIFICALLY PROVIDED IN THIS AGREEMENT,
THERE ARE NO OTHER WARRANTIES, EXPRESSED OR IMPLIED,
INCLUDING, BUT NOT LIMITED TO, ANY IMPLIED WARRANTIES
OR MERCHANTABILITIES OR FITNESS FOR A PARTICULAR
PURPOSE AND IN NO EVENT SHALL SKUTCH ELECTRONICS BE
LIABLE FOR LOSS OF PROFITS OR BENEFITS, INDIRECT, SPECIAL,
CONSEQUENTIAL OR OTHER SIMILAR DAMAGES ARISING OUT
OF ANY BREACH OF THIS WARRANTY OR OTHERWISE.

"Telecommunication Products to solve Telecommunication Problems"

Voice CardTelephone

Norm al

AS-27

Cycle

Telephone Line Si m ul at orAudio

AS-27

Telephone Single-Line Cycling

Simulator

Version 1.10