• Introduction
The AS-26 was developed to meet the rising need for a Bi-directional
Telephone Line Simulator. The AS-26 will allow either Telecommunication
Device to "RING UP" the other. The AS-26 provides a simulated RING
BACK signal, to the Telecommunication Device that initiates the call, during
each ring to the other Telecommunication Device. The AS-26 has an
adjustable DIAL TONE option, that allows you to select from no dial tone to
a maximum of six seconds of dial tone, before the unit rings up the other
Telecommunication Device. The AS-26 also provides you with a Bidirectional AUDIO jack for recording HIGH QUALITY AUDIO into a
Telecommunication Device, or for recording your voice information to tape.
The AS-26 even provides you with "WINK" disconnect in one direction, to
assure you of fast disconnect.
• Installation
AS-26
Telephone
• Record Audio From Computer
1) Once you are into your Voice Card, plug an audio cable from the Audio
jack of the AS-26 to the MIC jack of your tape recorder.
2) Start the tape recording when you are ready on the Voice Card.
3) When you're finished, just hang up the phone.
• Play Audio To Computer
1) Once you are into your Voice Card, plug an audio cable from the Audio
jack of the AS-26 to the HEADPHONES or MONITOR jack of your
tape player or other audio source.
2) Start the Voice Card recording, then play some of the message from the
tape.
3) Now play back the message from the Voice Card and check it for audio
level and clarity.
4) Make any adjustments necessary, then repeat the prior steps until the
message sounds great.
5) Now record the entire message.HINT: Reduce background noise by
using a phone with a MUTE button.
6) When you're finished, just hang up the phone.
Audio
Voice
Ca r d
Te l ephone L i ne Simulator
Optional
Message Source
Head
Phones
• Operation
1) Take either side "OFF HOOK".
2) If enabled, you will get 2, 4 or 6 seconds of DIAL TONE.
3) The other side will "RING UP" and activate, you can do everything as
you normally would.
4) When you are finished, just hang up the phone.
• Turn On Simulated Dial Tone
The AS-26 is factory set to NOT supply DIAL TONE, so this option
needs to be turned on to use it. Open the AS-26 (remove 4 screws from lid).
1) Find the jumpers labeled J1 and J2.
2) Pull the shorting blocks off of J1 and J2.
3) Put the shorting blocks on J1 and J2 for the desired DIAL TONE setting.
4) Close the AS-26.
5) You're done, everything should work now.
• Tech Support - 916-786-6186
If you have any problems getting the unit to work properly feel free to
give us a call. Technical Support is available between the hours of 7:30 AM
and 4:30 PM Pacific Time, Monday through Friday.
• ONE YEAR LIMITED WARRANTY
This SKUTCH PRODUCT is warranted against defects for a period of
one (1) year from the date of the original invoice. Within this period, we will
repair it without charge for parts and labor. To obtain warranty service the
product must be returned, at the customer's expense, to SKUTCH Electronics
along with a copy of the original invoice. After the unit has been repaired,
SKUTCH will ship the PRODUCT back via UPS GROUND service at our
expense. If any other form of return shipment is requested, the customer will
pay for 100% of the shipping cost.
This Warranty does not apply if in the sole opinion of SKUTCH
Electronics, the PRODUCT has been damaged by lightning or any other Acts
of God, or by accident, misuse, neglect, or improper packing, shipping,
modification or servicing by other than an authorized SKUTCH Service
Center.
EXCEPT AS SPECIFICALLY PROVIDED IN THIS AGREEMENT,
THERE ARE NO OTHER WARRANTIES, EXPRESSED OR IMPLIED,
INCLUDING, BUT NOT LIMITED TO, ANY IMPLIED WARRANTIES
OR MERCHANTABILITIES OR FITNESS FOR A PARTICULAR
PURPOSE AND IN NO EVENT SHALL SKUTCH ELECTRONICS BE
LIABLE FOR LOSS OF PROFITS OR BENEFITS, INDIRECT, SPECIAL,
CONSEQUENTIAL OR OTHER SIMILAR DAMAGES ARISING OUT
OF ANY BREACH OF THIS WARRANTY OR OTHERWISE.
"Telecommunication Products to solve Telecommunication Problems"
AS-26
Telephone Line Simulator
Telephone
Audio
Voice
Ca rd
AS-26
Bi-Directional Telephone Single-
Line Simulator
Version 1.03
Loading...