Sirius SDD2LEMTC580PSEM10, SDD2LEMTC580WHPSEM10, SDD2LEMTC880WHPSEM10, SDD2LEMTC880PSEM10, SDDH-1.1SEM10 Specifications Sheet
...
SEM10 Motor
Off Board motor designed specifically for downdraft installations.
• Motor: 1020 m3/h extraction rate
SEM 10 ducting can be ducted out either parallel or perpendicular (and at two different angles) to the downdraft unit
by rotating the initial ducting point as per the diagram above left.
For re-circulating SEM10 extraction, charcoal filters must be installed within your Sirius downdraft. These can be
purchased separately. The SEM10 uses specific ducting that can be purchased separately.
Please ensure motor is accessible for servicing purposes.
A
Opening: 230 x 80mm
Length: 100mm
B
Opening: 230 x 80mm
Length: 300mm
Combined Length: 403mm
A
220 x 90mm
C
D
Components supplied with SEM10:
A: Joint 230x80 (x2 pieces)
B: Pipe 230x80 (x1 pieces)
Plus connector pieces shown below.
C: Offset adaptor
D: Used when using included ducting
E: When extending ducting length
D
230 x 80mm
220 x 90mm
E
C
Inlet connector can be switched around so that the outlet
on the motor can point towards the air outlet of your
choosing.
Example installation
Diagram shows downdraft with centre nozzle attachment.
Downdraft can also be fitted with offset nozzle.
Offset nozzle piece (C) can be fitted to the top of the
motor to allow it to be fitted closer to the rear of the
cabinet - offsetting the motor to the downdraft - which can
be used in setup option 1 (see page 4).
Loading...