Simrad IS40, OP10 Quick Reference Manual

Changing the Autopilot mode

IS40 Display & OP10 Autopilot Controller

3 SEC

Boat Type:

• Displacement

• Outboard

• Planing

Boat Type:

• Sail

Mode Symbol Function / Mode

S

A

W

N

ND

NFU

Standby

Auto (Compass)

Wind

Navigation

NoDrift

Non Follow Up (Power steer)

Tack & Gybe in Wind mode

To tack or gybe in Wind mode press both 1º course keys on the OP10 Autopilot controller.

1

1

Quick Reference Guide

IS40 Display Keys

Menu / Enter / Lighting: Used to enter the main menu, select sub menus and
confirm selection. Note: Press and hold the Enter key for 3 seconds takes you directly
to the display setup lighting level screen. If the lighting level is set below 5 it will
automatically increase to 5. Use the up and down keys to set the desired level and
press Enter to confirm.

Page: Scrolls through the eight default display pages and navigates back a step in
menus. Note: the eight default display pages including the autopilot page can be
customized to display the required data.

Directional keys: Scrolls up and down through selected menus / set values.

OP10 Autopilot Controller Keys

Changes the autopilot mode. When in Auto mode, pressing the MODE key:

1) when the boat type is set to Sail: changes to Wind mode.

MODE

1

1

10

10

AUTO

2) when set to any other boat type: enters into NoDrift mode.

3) for all boat types: (long key press) enters into Navigation mode; which will require
confirmation via the display before it is engaged.

STBY (or OFF): Disengages the autopilot. Places the autopilot into Standby mode.

Left 1º: Adjust the set course or wind angle 1 degree / steer to Port in Non Follow Up
(NFU) mode. When pressed in Standby mode this will enter the autopilot into NFU
mode.

Right 1º: Adjust the set course or wind angle 1 degree / steer to Starboard in NFU
mode. When pressed in Standby mode this will enter the autopilot into NFU mode.

Left 10º: Adjust the set course or wind angle 10 degrees / steer to Port in NFU mode.
When pressed in Standby mode this will enter the autopilot into NFU mode.

Right 10º: Adjust the set course or wind angle 10 degree / steer to Starboard in NFU
mode. When pressed in Standby mode this will enter the autopilot into NFU mode.

Engage the autopilot / Acknowledge tack/gybe or navigation course change.

MODE

10 10

AUTO

EN

STBY

11

Part No.988-10364-002 - Section 1 of 5

Page navigation

Replacing a data page

Creating custom pages

Menu navigation

Back lighting

Night mode

Disable / Enable a data page

Start / Stop timer

3 SEC

Reset trip log