Silex technology PRICOM R-9100U User Manual

2-1About the PRICOM R-9100U

Users Manual RX

Operating Environment

System requirements for the network connection

-Network cable (Category 5 in 100BASE-TX environment)

-USB Cable

-Ethernet HUB

-Printer

Network Environment

Windows 95/98/Me, Windows NT 4.0, Windows 2000, Windows XP, Windows Server 2003

Operating environment

-Temperature : 10°C to 35°C

-Humidity : 20% to 80% RH (no condensation allowed)

Storage environment

-Temperature : -10°C to 50°C

-Humidity : 20% to 90% RH (no condensation allowed)

EMI

VCCI Class B
FCC Class B
EN55022 Class B
EN55024

The PRICOM R-9100U is a mini print server that supports 10BASE-T/100BASE-TX and has
a USB connection. This server is a USB2.0 Full Speed print server developed exclusively for
Aficio G printers. Using the Aficio G status monitor, you can check the printing job status or
printer status.

II. About the PRICOM R-9100U

2-2About the PRICOM R-9100U

Users Manual RX

Parts on the PRICOM R-9100U

Parts and Function

Top Bottom

Back Right Side

(Top)
You can check the LED on the board.

-10BASE LINK LED(Green)
Lights when a proper 10BASE-T network connection is established.

-100BASE-TX LINK LED(Green)
Lights when a proper 100BASE-TX network connection is established.

-STATUS LED(Orange)
Flashes during data transfer.

10BASE LINK LED
(Green)

100BASE LINK LED
(Green)

STATUS LED (Orange)

Ethernet Address
(The last 6 digits are the product’s serial number)

Network Port
(10BASE-T/100BASE-TX)

USB Port

Power Connector

Push Switch

STATUS LED (Orange)

LINK LED (Green)

2-3About the PRICOM R-9100U

Users Manual RX

(Bottom)

-Ethernet Address
The Ethernet Address of the device. The last 6 digits are the product’s serial number.

- Ethernet Address 00:80:92:18:0E: 1A is noted as 008092180E1A.

- The product’s serial number is 180E1A.

NOTE

TIP

Restore the PRICOM R-9100U to factory defaults

1. Make sure that the AC adapter is not connected to the PRICOM R-9100U.

2. While pushing the push switch, connect the AC adapter to the PRICOM R-9100U. The STATUS LED
will blink once when the connection is made.

3. Continue to push the push switch for five seconds. The STATUS LED will blink again when factory
default is successfully completed. Remove your hand from the push switch.

- Do not turn off the power to the PRICOM R-9100U while it is initializing to factory default.

- When the PRICOM R-9100U is turned on again after factory default is completed, do not push
on the push switch.

(Back)

-Network Port (10BASE-T/100BASE-TX)
Connect to the network cable. In 100BASE-TX environment, use category 5.

-USB Port
Connect to the USB cable.

-Power Connector
Connect to the AC adapter.

-STATUS LED(Orange)
Flashes during data transfer.

- LINK LED(Green)
Lights when a proper network connection is established.

Right Side)

-Push Switch
By pushing this switch, you can initialize the PRICOM R-9100U to factory default.

NOTE

- The STATUS LED/LINK LED indicates the same operation as indicated by the LEDs on the top
of the PRICOM R-9100U.